find a store - Edwards & Co
Contents
1. attach the tether strap loop it over the handle Open the end of the tether strap hanging over the handle and insert the opposite end through the opening created Pull until the tether strap is tightened around the handle Place the loop over the desired wrist using the stroller If you need to change the wrist loosen the tether strap and slide to the desired side of the handle USE THIS STRAP TO STOP THE STROLLER ROLLING AWAY WARRANTY AGAINST DEFECTS ALL POCHOLIN BABY PRODUCTS ARE GUARANTEED FOR TWELVE MONTHS FROM THE DATE OF PURCHASE OUR GOODS COME WITH GUARANTEES THAT CANNOT BE EXCLUDED UNDER THE AUSTRALIAN CONSUMER LAW YOU ARE ENTITLED TO A REPLACEMENT OR REFUND FOR A MAJOR FAILURE AND FOR COMPENSATION FOR ANY OTHER REASONABLY FORSEEABLE LOSS OR DAMAGE YOU ARE ALSO ENTITLED TO HAVE THE GOODS REPAIRED OR REPLACED IF THE GOODS FAIL TO BE OF ACCEPTABLE QUALITY AND THE FAILURE DOES NOT AMOUNT TO A MAJOR FAILURE THIS COVERS AGAINST FAULTS WHICH DEVELOP THROUGH FAULTY MATERIALS AND WORKMANSHIP MISUSE ACCIDENTAL DAMAGES NORMAL WEAR AND TEAR OR NEGLECT ARE NOT COVERED IF AFAULT BECOMES APPARENT PLEASE RETURN THE ITEM TO THE STORE OF PURCHASE WITH YOUR RECEIPT YOU MUST INFORM THE STORE WHAT THE DEFECT IS WE WILL THEN ARRANGE FOR ITS REPAIR OR IT WILL BE ASSESSED FOR REPLACEMENT AS EXPEDIENTLY AS POSSIBLE THE BENEFITS OF THIS WARRANTY ARE IN ADDITION TO OTHER RIGHTS AND REMEDIES UNDER THE LAW IN RELATION TO THE GOODS ABD SE2. BUDDY STROLLER Instruction Manual PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE SAFETY GUIDELINES AND INSTRUCTIONS MUST ALWAYS BE FOLLOWED BEFORE MAKING USE OF THIS PRODUCT PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE THIS PRODUCT COMPLIES WITH PRODUCT SAFETY STANDARD AS NZS 2088 2009 A WARNING FOLLOW THE MANUFACTURER S INSTRUCTIONS PUT ON ALL THE BRAKES WHENEVER YOU PARK THE STROLLER ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS STATIONARY DO NOT LEAVE CHILDREN UNATTENDED SECURE THE CHILD IN THE HARNESS AT ALL TIMES DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER DO NOT USE THIS SEAT WITH ANY OTHER MODELS OF STROLLER DO NOT USE THIS BASSINET ONCE THE CHILD CAN SIT UP UNAIDED USE THE SEAT IN THE UPRIGHT ONCE THIS OCCURS ALWAYS LOAD THE HEAVIER CHILD IN THE FRONT SEAT THEN PLACE THE LIGHTER CHILD IN THE REAR SEAT ALWAYS UNLOAD THE REAR CHILD FIRST MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU ADJUST THE STROLLER OTHERWISE THEY MAY BE INJURED USE THE HARNESS AT ALL TIMES WHEN NOT IN USE DISCONNECT SHOULDER STRAPS FROM THE WAIST STRAP AND OR BUCKLE THE HARNESS CAN FORM LOOPS WHICH MAY BE A STRANGULATION HAZARD NEVER LEAVE A HARNESS CONNECTED WHEN NOT FITTED TO A CHILD IN THE STROLLER TO AVOID SERIOUS INJURY ALWAYS USE THE HARNESS PROVIDED TO SECURE THE CHILD ADJUST THE STRAPS TO SUIT THE SIZE OF YOUR CHILDS BODY IT IS UNSAFE TO USE ACCESSORIES OTHER THAN THOSE SUPPLIED BY PO
3. CHOLIN BABY CARE SHOULD BE TAKEN IF THE STROLLER IS TO BE USED ON STAIRS OR ESCALATORS THIS STROLLER SHOULD NOT BE USED NEAR AN OPEN FIRE OR AN EXPOSED FLAME CARE SHOULD BE TAKEN WHILST FOLDING AND UNFOLDING THE STROLLER TO PREVENT FINGERS BEING TRAPPED ENSURE YOUR CHILDS FINGERS HANDS AND ALL OTHER BODY PARTS ARE CLEAR FROM ANY MOVING PARTS WHEN ADJUSTING THE SEAT OR HANDLE ON YOUR STROLLER WHEN USED IN THE UPPER POSITION MAX WEIGHT OF SEAT 15KG MAXIMUM WEIGHT WHEN USED IN BASSINET MODE 9KG SUITABLE FOR NEWBORN WHEN USED IN LOWER POSITION MAX WEIGHT OF THE SECOND SEAT 15KG SUITABLE WHEN CHILD IS ABLE TO SIT UP UNAIDED MAXIMUM WEIGHT FOR BASKET 3KGS MAXIMUM WEIGHT CAPACITY IS 33KG PICTURES USED IN THIS MANUAL ARE FOR ILLUSTRATIVE PURPOSES ONLY THE ACTUAL STROLLER MAY VARY IN DISPLAY CLEANING AND MAINTENANCE ALL POCHOLIN BABY PRODUCTS HAVE ONE YEARWARRANTY FROM THE DATE OF PURCHASE IT IS RECOMMENDED TO REGULARLY INSPECT AND MAINTAIN MOVEMENT OF LOCKING DEVICES AND SECURITY OF ESSENTIAL COMPONENTS REGULARLY CHECK ALL PARTS FOR WEAR AND TEAR LUBRICATE IF TIGHT DO NOT USE SPRAY LUBRICANTS SIMPLY WIPE CLEAN AFTER USE THE SEAT LINER CAN BE CLEANED BY SPONGING WITHWARM SOAPYWATER AND A MILD DETERGENT A MILD DISINFECTANT MAY BE USED IF DESIRED STUBBORN MARKS MAY BE REMOVED WITH A NON ABRASICE CREAM CLEANER NEVER CLEAN WITH ABRASIVE AMMONIA BASED BLEACH BASED OR SPIRIT TYPE CLEANERS IF THE WHEELS BECO
4. ME DAMAGED OR WORN DISCONTINUE USE AND REPLACE FABRIC CARE HANDWASH ONLY GRO gt lt DO BLEACH DO NOT TUMBLE DRY DO NOTIRON DO NOT WRING DO NOT DRY CLEAN OR click click 13f click 7 13g IN click 24b Shoulder straps 23 Release Button Waist Strap Crotch Strap 24d Instructions In words 1 Parts List A Tango Frame Chassis B 2x Front wheels C 2x Rear wheels D 2x Rear Mud Guards E Main Seat F Main Seat Front Bar G Main Seat Canopy Hood H Toddler Seat Sold Separately 2 Unfold the Frame 2 To unfold the frame press the button located on the side of the frame at point A After pressing the button then raise the handle upwards 2b While the frame is on the foor and the stroller has been unlocked raise the handle upwards It should click once the handle is raised to the top The stroller is now unfolded 3 Attaching and using the Front wheels To attach the front wheels place the item front wheel into the opening sockets located at the front of the Frame A 3b Once the wheels are placed into the sockets they should click into place Pull on the wheel to ensure that it is attached correctly Repeat with the other front wheel 3c To lock the front wheels into the straight position push the latch located on the front of the wheels holder downwards To
5. RVICES TO WHICH THIS WARRANTY RELATES
6. d lock Point 1 pull the folding sliding cover of two sides of the handle tube upward point 2 22 You can leave the toddler seat on the frame when you fold it but it must be reclined over 150 degrees Once the stroller is folded downwards it should click once it is locked into place 23 How to use the Harness 23a For newborns or smaller children you should use the lower height position on the seat units You can change the position of the height of the harness by threading the harness through the seat As the child gets taller you should use the top position 23b The installed 5 point harness should look like this 23c Carefully place your child into the seat and bring the waist straps around the childs waist and over the childs shoulders Place the crotch strap between your childs legs Tighten the harness to be snug around the childs waist and over its shoulders Attach each of the shoulder straps to the waist strap buckle with each end Repeat this for both sides The should click onto each other Once each shoulder strap is attached on the waist buckle insert the waist strap end to the crotch strap buckle Repeat on both sides You can then adjust the straps further if required 23d To release the harness squeeze the centre of the crotch strap buckle to release all straps USE THIS HARNESS AT ALL TIMES WHEN NOT IN USE DISCONNECT SHOULDER STRAPS FROM THE WAIST STRAP AND OR BUCKLE 24 Attaching the tether strap 24 To
7. ine the seat once it is bassinet mode 10e Carrycot changes to seat Push the bottom of the carrycot upward Point 1 then adjust the webbing behind the backrest and adjust the seat cover of backrest to the highest position point 3 11 Do not leave the main seat in the flat position 180 degrees with the footrest in the upright position Adjust the position and the footrest before you place your child in the stroller 12 Adjusting the Handle 12 Press two side buttons of handle bar and adjust the handle bar to the desired height 13 How to Attach the toddler seat 13a To attach the toddler seat H to the frame please remove the main seat to give you more room to attach the toddler seat 13b Place the toddler seat onto the rear part of the main frame Attach the toddler seat to the right side first 13c The toddler seat should then click onto the right side 13d Then you should start on the left hand side and align the catch from the toddler seat onto the bottom frame 13e Push the lever inwards to open the arm of the toddler seat to latch onto the frame The toddler seat should then click onto the sides of the frame 13f Slide the toddler seat towards the rear axel The toddler seat should then click into place The toddler seat should now be attached to the frame 14 You should then re attach the main seat back onto the frame 15 Adjusting the toddler seat backrest 15 To adjust the back rest for the toddler seat p
8. ont bar from the main seat press the button located at point 1 on both sides of the seat unit then lift the bar upwards point 2 8 How to attach and use the Canopy Hood 8a To attach the canopy G slot the ends of the canopy into the slots located at the top of the main seat The front of the canopy should open forwards The canopy should click into position 8b To use the canopy pull the front of it forwards to extend it outwards or push it to close the canopy 9 Using the Foot rest 9 use the foot rest up and down press the release button located on each side of the main seat They should click into place once the right position is chosen 10 How to use the main seat Unit 10a To recline the main seat push the lever located at the top point 1 then upwards or downwards depending on the desired position 10b Seat changes to carrycot Pull the adjust buckle of the bottom of footrest upward Point 1 press the seat to the bottom at the same time point 2 Adjust the webbing behind the backrest and adjust the seat cover of backrest to horizontal position point 3 10c Attention When use as carrycot you must place the carrycot in level otherwise baby will be probably in danger of droping When use as carrycot only baby less than 6 months is permitted using the carrycot Do not recline the seat once you are in bassinet mode 10d You can place the bassinet in the forward or rear facing position Do not recl
9. release it to swivel mode push the latch upwards To remove the front wheel push the release button located at point 1 and the remove the wheel at point 2 4 Attaching and using the Rear wheels 4a Place the rear wheels c into the sockets located at the rear of the frame Ab Push the wheels inwards until you hear them click 4 To remove the rear wheels pull the lever located at point 1 on the rear wheel axel and then pull the rear wheel from the sockets on the frame 5 Attaching the Mud Guards 5a To attach the mudguards D onto the frame place them on the top of the rear wheels the slot them into the allocated positions of the rear wheel axel 5b Push the mud guards downwards until you hear them click into position Repeat on both sides 6 Attaching and removing the Main seat to the frame 6a To attach the main seat E onto the frame place the seat into the desired position front or rear facing into the slots located on each side of the frame Push the seat downwards until you hear it click Pull slightly on the seat to ensure it is attached correctly 6b To remove the main seat from the frame press the buttons located on the side of the seat point 1 and then lift the seat up out of the slots point 2 7 How to attach and remove the front bar 7 To attach the front bar F to the main seat place the bar into the slots located on the main seat Push it downwards until it clicks into place 7b To remove the fr
10. ush the lever located at the back top of the seat point 1 upwards then move the seat into the desired position 16 Using the toddler seat canopy hood 16 To use the canopy for the toddler seat just push it forwards or backwards depending on the position desired 17 How to use the brakes 17 To unlock the brakes for the stroller kick the red brakes on the back of the stroller upwards To Apply the brakes push the red lever downwards You will not be able to move the stroller 18 Adjusting the Main seat 18 To adjust the position of the seat use the lever located at the top of the main seat point 1 push the lever upwards and then move the seat upwards or downwards as required point 2 19 Adjusting the toddler seat 19 To adjust the position of the toddler seat use the lever located at the top back of the toddler seat point 1 Push the lever then move the seat up or down Warning The toddler seat can not be adjusted to be over 150 degrees The toddler seat should only be adjusted over 150 degrees when folding 20 Removing the toddler seat 20 Recline the toddler seat as far back as possible then press the toddler seat release button located at point 1 and then push the seat backwards then lift the seat from the holders Make sure there isnt any toddlers in the seat when the seat is being removed 21 How to Fold the stroller 21 Press the red second lock button on the right handle tube Release the secon
Download Pdf Manuals
Related Search