User manual
Contents
1. User manual Before using the product Please read this manual carefully and keep it properly for future reference when necessary 9 User manual Preface Thank you for purchasing the Bullet Camera 720P HD Digital waterproof video camera This product is quite small and delicate with wonderful waterproof humanity design With a multipurpose damp it can help you achieve omni directional video monitoring under all kinds of outdoor conditions This manual contains important safety and operating information Please read all the information carefully before you use the device to avoid accidents and keep it for future reference Product Features gt Waterproof up to 30M portable used gt 1 2 5 5 0Mega pixel CMOS Lens gt HD 720P 1280 720 30fps HD resolution for video AVI format gt HD resolution for photo 4032 3024 JPEG format gt 137 wide angle HD Camera Lens low illumination gt Easy operation with vibration effect gt Built in high capacity Li battery for 3 5h continual video recording gt Support Micro SD card up to 32GB gt 720P memory consumption 4GB micro SD Card lasting video recording for 35 45min gt Photograph memory consumption 4GB micro SD Card lasting picture taking about 2200pcs gt USB2 0 High Speed device gt USB charging 1 Product Structure With picture 1 Power button execute button 2 Mode Switch 3 DV indicator light Red Blue Purple 4 Charge indicator light Y2. ded periods the battery may completely drain When this happens the system time will be restored back to the factory defaults 12 Reset the system If camera can t work well because of any reason such as ESD etc please use a pin to press the reset hole This will shut the camera down so that a fresh start can be made 13 Product protection Specification Please dry the water and place in the shade after using change the waterproof ring if it is aging Image Sensor 5Mega CMOS SENSOR Photo format JPG 12M _4032 3024 Notes Video format AVI HD 1280 720 1 Please well tighten the back cover after charging or connect Frame rate to PC for avoiding leakage water i os F 1 8 f 3 2mm 2 Please do not turn on the camera if it falls into water open Lens Specification 137 wide angle the back cover and dry it with the hair dryer If it doesn t White balance Auto work you call the related agent for after sale service 3 Don t use the camera underwater over 30M Sensitivity Auto 1SO100 400 Subject distance 50cm above Operating hints Vibrate Battery capacity 3 7V 1150MA Power consumption lt 1W battery continue working time About 3 5 hours Charging specification DC5V_500mA Charging period About 3 5 hours USB port USB2 0 High Speed Type of memory card Micro SD card T FLASH Capacity of memory card 1GB 32GB Waterproof Grade IPX8 underwater30M lasting 3h P Windows2000 XP VISTA WIN Operating sy
3. ellow 5 Reset hole 6 MicroSD Card slot 7 USB interface 8 Lens 9 Base 10 Back cover 1 Power button execute button 4 Charge indicator 3 DV indicator light light Yellow Red Blue Purple 8 Lens i 2 Mode Switch 7 USB interface 5 Reset hole 10 Back cover 6 MicroSD Card slot 9 Base Installation With picture This product could be hand held usage directly or you could install in the back clip or bracket as below pictures show 1 Remove the back cover 2 Install the bracket Install the bracket Remove the back cover E S Standard Accessories User Manual USB Cable Mounting bracket Adaptor Bag en Adaptor Eurc US UK AUST Standared Charger User Manual a USB Cable Bag Mounting bracket Option Accessories In view of differernt usage purpose such as motorbike airplanes golf carts vehicle bicycles and many others round and square rail applications we also offer the optional accessories to user to meet their different demand gt 01 Mount bracket gt 02 Suction cup mount gt 03 Base bracket gt 04 Adhesive base with 1pc 3M sticker gt 05 Upright bracket gt 06 90 bracket gt 07 Hexagonal plastic nut gt 08 Anise plastic nut gt 09 Silicon strap 15cm gt 10 Silicon strap 35cm gt 11 Silicon strap 70cm Option 1 r E Q Multi functional sport bracket Option 2 p 8 Sucker MicroSD Card aiik Function Specification 1 Starting up 1 First
4. fully 3 Video Recording In the video recording mode shortly press the execute button the unit will vibrate once the blue indicator flashes slowly and then the unit begins to record video Shortly press the button again the camera will vibrate once and blue indicator will be constantly on unit stops recording Notes 1 The unit would automatically save a file each 20 minutes recording and then go for the next video recording 2 Please open the waterproof back cover of the unit for better sound effect when not use it underwater 3 When the MicroSD card is full battery used up or no operation for 3 minutes the unit will shut down automatically 4 Photo taking In the photo taking standby mode short press the execute button then please keep the camera still until it vibrates a photo has been taken after vibration stop Notes 1 The red indicator will go out when it is taking photo please keep it still for better picture quality 6 2 When the MicroSD card is full battery used up or standby mode for 3 minutes it will shut down automatically 5 Turn off amp automatic turn off gt Inthe standby mode long press execute button the blue indicator light flashes 3 times and goes out The camera vibrates twice and then the camera turns off gt When the MicroSD card is full battery used up or standby mode for 3 minutes it will shut down automatically 6 MicroSD card memory warning amp shut down automat
5. ically When MicroSD card was full during video recording or photo taking system will sound a warning The purple LED indicator flashes quickly with continuous fast rhythm vibration and unit will shut down automatically after a few seconds 7 Low power warning amp automatic shut down During the system starting if the battery is used up system will sound a warning The blue and red LED indicator will flash slowly alternate with continuous slow rhythm vibration and the unit would shut down automatically after a few seconds 8 Downloading files amp removable disk function Connect the camera with PC USB interface via the USB cable gt Press power button to turn on the unit and a removable disk will appear in my computer you can view the pictures or videos audio record files in the removable disk DCIM 100DSCIM and you can also copy these files to your computer v Te gt When connected to computer with USB1 1 port please copy the videos to your computer desktop and then replay it to avoid ragged playback inthis mode yellow indicator would be on it means the camera is charging and yellow indicator would go out after battery is fully charged 9 Charging amp indicating gt Plug the AC adaptor into socket and then connect with the camera for battery charging The yellow indicator will be constantly on during charging Indicator goes out after the battery is fully charged The charging time is about 3 hou
6. ly please insert Micro SD card before use the unit and then press power button for 2 seconds purple LED will be on the system would enter into initialization After the initialization finishes the product vibrates once system will enter into corresponding mode according to the location of the mode switch Blue indicator is for video recording standby mode and red indicator for photo taking standby mode 2 Due to the difference capacity and data storage of the Micro SD card unit initialization will take a few seconds please wait for vibration before operating functions 3 For the product video resolution is HD 720P it would be better to use the Class 6 MicroSD card to get a better video quality Notes If the MicroSD card is not inserted the blue indicator would flash quickly when turns on the unit You should turn off the unit and insert the MicroSD card 2 Mode transfer 1 When it turns on press the mode switch to transfer to different mode status 2 When the switch button in the position of the video mode blue indicator lights on and enters into video mode When the switch button in the position of photo taking mode red indicator lights on and enters into photo taking mode 3 When the unit is in the video or photo taking mode switch to different mode the system would automatically save the files for the current progress and then go to the next mode Notes The camera will vibrate once after switch the mode success
7. rs gt Connect the camera to PC with the USB cable the yellow LED indicator will constantly on during charging and it would go out after the battery full charged Notes Shut down the camera when charging for energy saving 10 Shooting when charging You can press power button to turn on unit during charging and also can operate its functions at the mean time 11 System time setting If the time stamp is wrong please setting as below 1 Connect with computer by USB cable 2 Open removable disk 3 Create a new time txt file 8 4 Open time txt file and input relevant words of time amp date setting up as following 260160 68 68 Please set time and date as per the following format Video with time watermark 2010 08 08 20 00 00 Y Video without time watermark 2010 08 08 20 00 00 N Keep a space between date and time and another space between time and water mark switch The time character strings in the above mentioned format is the time value you want to set up and pay attention to type a spacebar between date and time another spacebar between time and watermark switch Y and N at the end serve as the control character on the video file for adding the time amp date watermark Y indicates Yes Add watermark and N indicates No Hide watermark 5 Save time txt file and safely exit the removable disk 6 Then turns on the power the system time will be updated Notes If the camera is left unused for exten
8. stem 7 mac10 4 or above Weight 132g EDEA 10 At
Download Pdf Manuals
Related Search