250s Quick Setup
Contents
1. Orion 250s Quick Start Guide Follow the steps below to begin welding right away Welder Setup for additional info see page 8 of the user manual 1 Place the welder in a desired workspace 2 Attach the power cable to the back of the welder then into the wall 3 Plug the foot pedalinto any of the three Foot Pedal Microscope ports on the welder Use of foot pedalis optional 4 Choose your preferred hand piece attachments and plug them into the front of the welder Microscope Setup for additional info see page 9 of the user manual 1 Place the microscope next to the welder 2 Plug microscope cable into either of the 3 Foot Pedal Microscope ports on the welder then into the port on the microscope light ring i 5 Attach the power cable into the back of the microscope then into the wall Now turn on the microscope and adjust the brightness with the dial on the side 4 Adjust the microscope head and stylus holder up and down by loosening their respective knobs Once they are ina desired position tighten their knobs for additional info see page 14 of the user manual 1 With the slit on the 2 Now push in the end Stylus plug facing up of the plug and screw lightly push the plug the connector 3 or 4 into the port and screw turns again Repeat this the connector on the process until the plug is me plug clockwise 3 or 4 securely fastened E turns 4 P2. eld plate Maintain contact amp keep hands steady by resting them on the table 3 Use the provided 4 Plug the stylus to select the tack Alligator clips into tab then choose 60ws the Tack ports energy max time on the then line up the weld time bar trigger work pieces and with Foot Pedal then step on the foot hit play pedal n For immediate access to videos tutorials and other Orion related material LUY welders Scan this QR code with any smart phone or go to www OrionWelders com OrionWelders com
3. lace the stylus in the stylus holder then adjust the microscope head up or down with the adjustment knob until the stylus is in focus 3 a Pull to remove the stylus hull then unscrew the collet to insert the electrode b The electrode should stick out between 0 6 and 0 7 in c Tighten the collet and slide the stylus hull back on OrionWelders com 2 Attach the thicker end of tubing to the regulator then the thinner end to the back of the welder 1 Screw the regulator onto the Argon Gas tank Ensure the connection is tight and there are no leaks 3 First unscrew the regulator knob then i turn the gas tank on make sure there is gas 4 Slowly turn the regulator knob gt Clockwise until the pressure to welder tank pressure k a Q is at 10 cuft hr do AS aa E PA not exceed 10 psi psi Pressure to W Touch Screen for additional info see page 15 of the user manual Load Save Arc Tab Tack Tab Settings Tab Unsaved Generic 2 34mm Energy Bar Trigger Option Agitation Option Weld Time Bar Gas Indicator First Welds for additional info see www OrionWelders com for instructional videos Sornonzos 1 Use the provided stylus to select 25ws energy max time on the weld time bar no agitation trigger on touch then hit play 2 Lightly touch the electrode in the 25ws box on the provided w
Download Pdf Manuals
Related Search