User manual of combination thermostat ECO16
Contents
1. It takes time to notice changes in room tempe rature because the better an insulator the floor material is the more slowly the he at is released into the room Let the changes take affect for several hours before making new adjustments The thermostat is able to inter pret a rapid drop in room temperature as ventilation turning off the heating fun ction for 15 minutes After that the ther mostat will restore the heating function in accordance with the settings The ECO16FR thermostat can be used asa component in the Ens to Smart home control system In this case adjusting screw F under the adjusting wheel is set to the Smart position Tem perature adjustments and control can then be performed using the Ensto Smart sys tem USER MANUAL COMBINATION THERMOSTAT ECO16FR o O DW gt The heating is turned on using the current switch A Signal light B on the thermostat will show either a green or red light and signal light D a blue one e The green light signal light B switches on when the thermostat is on and the room tem perature equals the thermostat setting Adjusting screw E on the right is used for selec ting the thermostat s operating method In the Floor position the thermostat controls heating based on the floor sensor temperature The required temperature level is set using the scale on the adjusting wheel C The numerical values on the scale do not equal t2. he temperature of the room or floor sensor but indicates the temperature level In the Room position the thermostat controls heating based on the room temperature The required temperature level is set using the scale on the adjusting wheel C In the Intermediate position the thermostat controls heating based on both room tempera ture and floor temperature For the combination function adjusting screw E is used for set ting the maximum floor temperature and the ENSTO BUILDING TECHNOLOGY PL 110 06101 PORVOO TEL 358 204 76 21 ELECTRIC GENSTO COM WWW ENSTO COM CURRENT SWITCH SIGNAL LIGHT ADJUSTING WHEEL FOR HEATING SIGNAL LIGHT Ensto s ECO16FR thermostat is a so called combination thermostat It controls heating based on the room temperature or floor sensor tempe rature or both e The red light signal light B switches on when the room Is being heated e The blue light signal light D switches on when the temperature drops and the tempe rature raising function Is active E ADJUSTING SCREW F ADJUSTING SCREW Removing the adjusting wheel C reveals two adjusting screws used for selecting the heating control method required room temperature Is set using the scale on the adjusting wheel C Most parquet manu facturers recommend a maximum temperature of ca 27 C for the floor surface to prevent the floor heating from drying out the wood parquet The temperature of the floor surface is normally
3. several degrees lower than that of the sensor installed in the floor If the floor temperature ex ceeds the setting the blue signal light will flash four times a minute as a warning and the floor heating will be turned off until the floor tempe rature has decreased to the set level Adjusting screw F is used to set the temporary temperature drop and raising function which are operated by a separate home away switch usu ally located near the entrance door This switch controls all the floor thermostats connected to it At a maximum the temperature can be tempora rily dropped by 15 C and raised by 5 C based on the setting on the adjusting wheel C
Download Pdf Manuals
Related Search