manual
Contents
1. Lincat User Instructions Opus 700 Gas Fryer OG7106 and OG7107 Please make a note of your product details for future use Date Purchased Model Number Serial Number Dealer OPUS 700 IS361 ECN3592 Please read the following carefully before using this appliance Warnings and Precautions Please ensure that all commissioning checks and initial start up procedures have taken place Please ensure that the installation engineer has instructed the user how to light safely operate and shutdown the appliance and that the user has been made aware of the position and operation of the gas isolating cock for use in the event of an emergency Whilst in operation parts of the appliance become hot Please take care to avoid accidental burns The flue outlet must not be blocked and must be kept clear at all times This manual should be kept in a safe and accessible place for future reference This appliance is designed for professional use and must only be operated by qualified personnel It is mandatory that all appliances are installed commissioned and serviced by a qualified and competent person as defined by the regulations in force in the country of installation Failure to comply will invalidate the warranty Please ensure that the appliance is serviced regularly by a competent and registered catering equipment engineer WARNING Do not overheat the oil Do not move this appli2. RTNUMBER DESCRIPTION BA82 Basket BA83 Halfbasket WI09 Basket support OG7107 WI12 Basket support OG7106 BU77 Burner OG7106 7 JE31 Cross light jet natural OG7106 0 026 JE32 Cross light jet butane propane OG7106 0 016 JE91 Cross light jet natural OG7107 0 65mm JE92 Cross light jet butane propane 0G7107 0 35mm JE97 Burner injector natural OG7106 3 0mm JE98 Burner injector butane propane OG7106 2 0mm JE94 Burner injector natural OG7107 3 15mm JE95 Burner injector butane propane OG7107 2 15mm JE86 Pilot injector natural OG7106 7 0 5 1mm JE87 Pilot injector butane propane OG7106 7 0 35mm VA20 Control valve PI25 Pilot body 0G7106 PI18 Pilot body 0G7107 TC40 Thermocouple OG7107 TC41 Thermopile TH95 Control Thermostat TH97 Safety thermostat TA101 Drain valve LE37 Adjustable leg KN253 Control knob 1G39 Ignition lead IG15 Igniter electrode IG35 Piezo igniter 1G37 Igniter earth lead IS361 ECN3592
3. ance when the tank contains oil Hot oil can cause severe burns Avoid direct physical contact Always drain food before frying Never put water into the oil as this will cause splashing and possible overflow of the tank Never put anything other than food in to the oil Parts of this unit may become hot in normal use therefore suitable precautions must be taken to avoid accidental contact Never leave the unit unsupervised whilst frying If the unit should begin to smoke switch off immediately In the event of a fire occurring water should not be used to extinguish it It is advisable to install a fire extinguisher and have a fire blanket within reach of the fryer Do not over fill the tank with oil Maintain the oil level above the minimum mark Before lighting the appliance please ensure that the tank is filled with oil to the specified capacity as indicated below The flue outlet must not be blocked and must be kept clear at all times Parts that have been protected by the manufacturer or his agent must not be adjusted by the installer or the user Model No Oil Capacity litres OG7106 IS361 ECN3592 2 Filling with oil 1 Remove the dust cover and locate it behind the wire basket support at the rear of the tank 2 Check that the drain valve is closed 3 Fill the tank of the fryer to the higher of the two level marks on the batter plate Always use good quality oil and maintain th
4. e level as above to avoid early deterioration ControlPanel On Off Position lincall J Fig 1 KNOB INDICATORS o we A OFF PILOT MAIN BURNER Fig 2 IS361 ECN3592 OG7106 OG7107 ers ey p Safety Cut out Reset Button Pilot Bumer Control Knob E Lighting the Appliance Please ensure that the gas isolation valve for the appliance is turned to the open position before attempting to light this unit Ensure that the thermostat control knob see fig 1 is in the OFF position Press the pilot knob in and turn anticlockwise to the Pilot position see fig 2 Keeping the pilot control knob depressed press the piezo ignition button see fig 3 Hold the pilot control knob in for 20 seconds to establish the pilot flame If the pilot flame fails to ignite return the pilot control knob to the off position and repeat the process allowing a short period of time for the control to reset When the pilot is lit release the pilot control knob and turn fully anti clockwise to the Main Burner position see fig 2 7 To operate the main burner turn the thermostat control knob see fig 1 to the required temperature setting hae oe ea D Standby Once the pilot is lit the appliance may be left on standby by leaving the pilot control knob in the pilot ign ition position When in this position
5. e unit off and isolate from the gas supply Allow the oil to cool to a maximum of 55C 3 Screw the drainpipe 1 onto the drain valve and place the drain container under the outlet of the pipe making sure that the filter mesh is in place 4 Open the tap and allow the oil to drain into the container taking care not to overfill it vo Fig 4 IS361 ECN3592 Cleaning the fryer tanks 1 Drain as per above instructions 2 Lift the filter mesh from the oil receptacle and remove larger particles before washing 3 Wash the tank and the top surface of the fryer body using a warm detergent solution 4 With the drain tap in the open position using a tube or suitable flue brush clean the drain tube Wash all parts thoroughly Rinse and dry all parts thoroughly 7 To ensure there is no water left in the drain tube flush thoroughly with a small a mount of clean cooking oil 8 Reassemble the unit and refill with oil to the correct level De Depress Align squares press to engage turn to open and close Ze Turn to Open Turn to Open Fig 5 Flue Cleaning Disassembly of the flue for cleaning 1 Unscrew the two locking pins to release the spillage guard 2 Lift the wire basket support from the mounting bosses 3 Reassemble in reverse order IS361 ECN3592 This appliance should be serviced and maintained regularly according to the service instructions Before carrying
6. out any maintenance on this appliance isolate from the gas supply See ServiceInformation below SERVICE INFORMATION Gas catering equipment should be routinely serviced to ensure a long trouble free life It is recommended that this appliance is serviced every 6 months by a competent gas engineer For help regarding the installation maintenance and use of your LINCAT equipment please call LINCAT SERVICE HELP DESK T 01522 875520 AUTHORISED SERVICE AGENTS We recommend that all servicing other than routine cleaning be carried out by our authorised service agents we cannot accept responsibility for work carried out by other persons Please quote both the model and serial numbers from the data plate attached to the unit Give brief details of the service requirement If possible please quote the product code of the part number you require Work carried out under warranty will normally be undertaken only during normal working hours i e Monday to Friday 8 30 a m 5 00 p m CONDITIONS OF GUARANTEE The guarantee does not cover 1 Accidental breakage or damage 2 Operational misuse wear and tear from normal usage incorrect adjustment or neglect 3 Incorrect installation maintenance modification or unauthorised service work IS361 ECN3592 7 SPARE PARTS LIST The following components are listed with the Lincat reference number followed by a brief description PA
7. the appliance cannot be operated from the thermostat control knob To re ignite the main burners follow steps 6 and 7 above Note Should the safety cut out thermostat operate during normal use the unit will shut down To re light the unit allow the oil to cooled to a temperature below 200 C Reset the safety thermostat by depressing the red reset button see fig 3 To reset the unit open the door s the reset button s are located at the base of the left hand frame pillar The button is in the centre of the protruding threaded tube IS361 ECN3592 4 Shutting down the appliance To turn off the appliance completely 1 Turn the thermostat knob fully anticlockwise to the OFF position 2 Press the pilot control knob in and turn to the OFF position Warning The surfaces behind the door s become hot during normal operation Please take care to avoid accidental burns Cleaning Ensure gas supply is isolated before commencing cleaning Note The baskets batterplates filter mesh and drain tube can all be cleaned using a commercial dishwasher To maintain the condition of the oil it is recommended that it be filtered after every service period Oil should be replaced when it becomes dark brown in colour and it should be disposed of according to local authority regulations Warning Always allow oil to cool to a maximum 55 C before draining Always drain the unit before cleaning or servicing Draining the oil Turn th
Download Pdf Manuals
Related Search