JP handguard User Manual
Contents
1. f bodily harm is guilty of a misdemeanor punishable by imprisonment in the county jail for a term of not less than 30 days2. t a Wm T 16 inch barrel E CLA 8 5 inch barrel Product Advisory for ALL Airsoft Paintball related products WEAR GOOGLE AT ALL TIMES WARNING Dont change obscure alter remove or obliterate any coloration or markings on this gun The coloration and or marking on this product including the blaze orange barrel tip are designed to comply with applicable state and federal law and regulations WARNING This product may be mistaken for a firearm by law enforcement officers or others Any person who changes alters removes or obliterate any coloration or markings that are required by state or federal law or regulation in any way that makes this product look more like a firearm is guilty of a misdemeanor WARNING The open display brandishing and or exposing of this product in any public place may cause confusion and may be a crime The term public place means any area opened to public including but not limited to streets sidewalks bridges alleys plazas parks driveways front yards parking lots automobiles whether moving or not and buildings opened to the general public including those that serve food or during or provide entertainment and the doorways and entrances to buildings or dwellings WARNING Every person who except in self defense draws or exhibits this product in a threatening manner against another in such a way as to cause a reasonable person apprehension or fear o
3. www MadBullAirsoft com MAD BULL AIRSOFT Y JP Hand Guard Kits for Airsoft User Manual NOTE WEAR GOGGLE AT ALL TIMES Step 01 Dissemble original M4 hand guards outer barrel Delta ring Step 04 Insert JP16 gas tube into the hole on JP05 Gas Block and weld spring and retaining ring Only leave Barrel Nut using spring pin to lock it Then put the whole set on to JP14 rear barrel dissemble Delta ring Barrel Nut Weld Spring Retaining Ring Spring Pin Socket Set Screw Step 02 Install JPO3 hand guard base onto the rifle body Step 05 Assemble JPO06 compensators on to front barrel JP15 and use Remember to line up the gas tube and upper receiver by turning socket set screw to lock it and use O ring on the back end of JP15 as clockwise all the way down to the end and turning counter clockwise washer Then assemble the whole set onto JPO5 Gas Block Line up little bit to line up If you can t put JPO3 onto upper receiver s screws and use socket set screw to lock it you may need to modify it by using one of our product DRM or DRM pro use 7 screws to fix onto JP03 Step 07 Assemble JP13 upper rail on the top of JP12 hand guard by Mid Length 9 8 inch Handquard screws Assemble other rails JPO7 side rail long JPO9 side rail short JP10 bipod base onto your preferred position eS con n ir Pa HE Full Length 12 inch Handguard A D ST LYA ae L
Download Pdf Manuals
Related Search