T116 User Manual
Contents
1. and conditions for a period of 90 days from the date of original purchase Should this product fail to function in a satisfactory manner it is best to first return it to the store where it was originally purchased Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period SDI Technologies will repair or at its discretion replace this product without charge except for a 3 00 charge for handling packing return UPS postage and insurance This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below The product must include proof of purchase including date of purchase The fee for service after the warranty period or without proof of purchase is 6 00 Before returning this product for service please first replace the batteries if applicable with fresh ones as exhausted or defective batteries are the most common cause of problems encountered If service is still required 1 Remove batteries if applicable and pack the unit in a well padded heavy corrugated box 2 Enclose a photocopy of your sales receipt credit card statement or other proof of the date of purchase 3 Enclose a check or money order payable to the order of Soundesign for the sum of 3 00 or 6 00 if after the warranty period or without proof of purchase 4 Send the unit prepaid to the Factory Service Cent2. hold the buttons to advance reverse rapidly A PM Indicator will appear to the left of the current time there is no AM indicator Press the Time Set Button when the correct time is displayed 2 beeps will confirm the clock setting is completed Setting Calendar Once the time is set in clock setting mode the year will flash on the display If needed press the Button and Button to adjust the year Press the Time Set Button when the correct year is showing Two beeps will confirm the year is set The date will flash on the display If needed press the Button and Button to adjust the date Press the Time Set Button when the correct date is showing Two beeps will confirm the date is set Note This unit comes with a Daylight Saving Time DST Switch located on the bottom of the unit to make adjusting for Daylight Saving Time simple Just move the DST Switch to 1 to add an hour or to 1 to subtract an hour from current time Setting Alarm Time Press and hold the Alarm 1 or Alarm 2 Button until the alarm time display located at the lower right part of display flashes If no buttons are pressed within approx ten seconds the display will stop flashing and return to normal mode Press the Button and Button to adjust the alarm time Press and hold the buttons to advance reverse rapidly A PM and AM Indicator appears to the left of the alarm time display When the desired alarm time is set press the 7 5 2 Button to select
3. Maintenance section of this manual for cleaning instructions 9 Periods of Nonuse If the unit is to be left unused for an extensive period of time such as longer than a month the power cord should be unplugged from the outlet 10 Object and Liquid Entry Care should be taken so that objects do not fall and or iquids do not spill into any openings or vents located on the product 11 Damage Requiring Service The appliance should be serviced by qualified service personnel when A the power supply cord or plug has been damaged B objects have fallen and or liquid has been spilled into openings or vents C the unit has been exposed to rain D the unit has been dropped or the enclosure damaged E the unit exhibits a marked change in performance or does not operate normally 12 Servicing The user should not attempt to service the unit beyond those methods described in the operating instructions Any servicing not covered in the instructions should be left to qualified service personnel Please also see the Warranty Information or more information on product servicing For questions or comments regarding this or other products please call our toll free number 1 800 888 4491 Limited 90 Day Warranty Information Timex Audio Products a division of SDI Technologies Inc hereafter referred to as SDI Technologies warrants this product to be free from defects in workmanship and materials under normal use
4. TIMEX Model T116 Jelly Clock For additional information online registration and exclusive special offers visit our website www timexaudio com For questions or comments regarding this or other products please call our toll free number 1 800 888 4491 Para instruccionese en Espanol llame al 1 800 888 4491 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE The lightning flash with arrowhead in an equilateral triangle is intended to alert the user of the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock maintenance servicing instructions in the literature accompanying the appliance The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and The symbols above are located at the bottom of the cabinet CAUTION To prevent electric shock do not use this polarized plug with an extension cord receptacle or other outlets unless the blades can be fully inserted to prevent blade exposure ATTENTION Pour pr venir les chocs lectriques ne pas utiliser cette fiche polar
5. er Button again Two beeps will confirm the snooze time is set Press the Snooze Dimmer Button when the alarm sounds to shut off the alarm for the programmed amount of snooze time before sounding again You may repeat this several times during the one hour alarm cycle Battery Low indicator The Battery Low Indicator is located on the lower left corner of the display and will flash if backup batteries are low and need to be replaced with fresh batteries A Consumer Guide to Product Safety IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner this unit has been designed and manufactured to ensure your personal safety However improper use can result in potential electrical shock or fire hazards Please read all safety and operating instructions carefully before installation and use and keep these instructions handy for future reference Take special note of all warnings listed in these instructions and printed on the product 1 Water and Moisture The unit should be kept dry and away from water or other liquids If liquid is spilled on the unit or if the unit should fall or be accidentally placed in or on a wet or damp area immediately unplug the unit 2 Ventilation The unit should be set up in an area and position that does not interfere with its proper ventilation Check to see where the ventilation opening is on the product Do not set up the unit on a bed sofa rug or similar surface that may block the o
6. er listed below Consumer Repair Department SDI Technologies Inc Timex Audio Products Division 1401 Pullman Drive Suite A El Paso TX 79936 7726 NOTE This warranty is valid only if the product is used for the purpose for which it was designed It does not cover i products which have been damaged by negligence misuse or accident or which have been modified or repaired by unauthorized persons ii cracked or broken cabinets or units damaged by excessive heat iii damage to CD s or tape cassettes if applicable iv the cost of shipping this product to the Factory Service Center and its return to the owner This warranty is valid only in the United States of America and does not extend to owners of the product subsequent to the original purchaser Any applicable implied warranties are also limited to 90 days and SDI Technologies will not be liable for consequential damages Some states do not allow limitations on implied warranties or exclusion of consequential damages so these restrictions may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state For questions or comments regarding this or other products please call our toll free number 1 800 888 4491 TIMEX is a registered trademark of Timex Corporation in the United States and other countries T116 102207 0 Printed in China
7. is e avec un prolongateur Une prise de courant ou une autre sortie de courant sauf si les lames peuvent tre ins r es a fond sans en laisser aucune partie a decouvert Getting Started Installing Backup Batteries Note After installing the backup batteries and reading the Maintenance section plug the AC line cord correctly into a wall outlet Battery Backup If the backup batteries have been installed and a power failure occurs or the AC cord is accidentally disconnected the current time and alarm time settings will be temporarily maintained If the backup batteries have not been installed or are dead when the AC power resumes the display will show 12 00 and you must reset the time and alarm settings 1 Open the battery compartment cover Battery Backup Y located on the bottom of the unit 2 Install 2 AAA size batteries into the compartment making sure that the and polarities match the diagram next to the compartment 3 Close the battery cover For the Best Possible Performance We recommend the use of alkaline batteries for longer life e Different types of batteries or new and used batteries are not to be mixed e Only batteries of the same or equivalent type as recommended are to be used Batteries are to be inserted with correct polarity Remove exhausted batteries from the unit Do not attempt to recharge non rechargeable batteries Remove rechargeable batterie
8. pening Do not keep the unit in a tight fitting installation such as a bookcase or cabinet which impedes the flow of air through the ventilation openings 3 Heat The unit should be situated away from heat sources such as radiators space heaters stoves or other appliances including amplifiers that produce or emit heat 4 Power Sources The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance 5 Grounding or Polarization This unit is equipped with a two pronged polarized alternating current line plug a plug having one blade wider than the other This plug only fits into your power outlet in one direction This is a safety feature If you are having difficulty inserting the plug fully into your outlet try reversing the plug blades do not force the plug into the outlet If you are still having difficulty contact your electrician to replace your obsolete outlet 6 Power Supply Cord Protection Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them paying particular attention to areas at the outlet and where they exit from the unit 7 Overloading Do not overload wall outlets extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock 8 Cleaning The unit should be cleaned only as recommended by the manufacturer See the
9. s from the unit before charging The supply terminals are not to be short circuited Batteries should be removed if the item is not going to be needed for an extended period of time approximately 30 days or more to prevent leakage or damage to the unit Maintenance e Protect your furniture when placing the clock on natural wood or a lacquered wood finish A cloth or other protective material should be placed between the unit and the furniture e Clean the casing with a soft cloth moistened only with mild soap and water Stronger cleaning agents may damage the surface of the case e lf the clock is not to be used for a prolonged period remove the batteries to prevent possible corrosion Should the battery compartment become corroded or dirty clean it thoroughly and replace the batteries Controls and Indicators Advance Button Alarm 1 Button Reverse Button Snooze Dimmer Button Alarm Reset Button Time Set Button 7 5 2 Button DST Switch gt LCD Display PM Indicator Alarm 1 Alarm 2 AGO eae poset bu Alarm Clock display Battery Indicator Time display Setting Clock Time and Calendar Setting Clock Time Press and hold the Time Set Button until the display flashes If no buttons are pressed within approx ten seconds the display will stop flashing and return to normal mode When display is flashing press the Button and Button to adjust to the correct time Press and
10. the desired alarm frequency 7 to wake you everyday 5 to wake you on weekdays or 2 to wake you only on the weekend Using the dual alarms you can easily set the alarm clock to wake you at different times during the week and on the weekend When the alarm time has been set press the alarm button again to return to normal mode 2 beeps tone will indicate Alarm Setting is complete Wake to Alarm After setting the alarm time s you can press the Alarm 1 or Alarm 2 button to arm or disarm the associated alarm The Alarm Indicator Icon s will appear on the display showing that the alarm is armed and will sound at the displayed time After the alarm sounds press the Alarm Reset Button to tur it off and automatically reset it for the same time the following day To turn off the alarm without setting it for the following day just press the armed alarm button again The Alarm Indicator Icon will disappear NOTE The alarm will sound for approximately 1 hour and then turn off automatically This cycle will repeat every 24 hours unless the controls are changed Snooze Operation During normal operation press the Snooze button once to adjust the LCD backlight brightness to Hi Med Lo or Off To program the snooze time just press and hold the Snooze Dimmer Button until the display shows the current snooze time default is 9 minutes Press the Button and Button to adjust snooze time from 1 to 30 minutes Press the Snooze Dimm
Download Pdf Manuals
Related Search