Model 1030 Standalone Enclosure User Manual
Contents
1. Web Site www canoga com Email fiber canoga com Copyright 2003 2005 Canoga Perkins Corporation All Rights Reserved EdgeAccess Universal Chassis System Model 1040 User Manual Model Number 1040 UM Product Number 6913100 Rev C 09 2005 MM 2 EdgeAccess Model 1040 Model 1040 Standalone Enclosure User Manual The Model 1040 standalone enclosure shown in Figure 1 supports one 5U sized managed module L Figure 1 Model 1040 Standalone Enclosure The front provides two switches five LEDs one connector and a slot for a module The back includes an AC power cord socket and the ALM IN and ALM OUT connectors Switch Setting Selects F1 NRM F2 for the module Fl Function 1 such as Local loopback NRM Normal operation set this for most applications F2 Function 2 such as Remote loopback HDX FDX for 1OBASE T port HDX Half duplex FDX Full duplex Note If the link partner is set to auto negotiation the link uses 10M and follows the HDX FDX switch setting for this port otherwise set this switch to match the other switch on the link LED State Definition PWR Off No power Green Power is on ALARM MAJ and MIN Off Normal MIN Amber Minor alarm MAJ Red Major alarm Tx for 10BASE T port Off No transmission Green blinking Transmission activity LNK Rx for 10BASE T port Off No link Green Link is established at full duplex Amber Link is established at half duplex Blinking Data is received Note To clear a latched Minor or Ma2. 0 enclosure connect all cables and access the module see the User Manual for the module Specifications Dimensions 11 70 L x 12 0 W x 1 718 H 297 mm x 305 mm x 44 mm Weight 5 6 lbs 2 5 kg Power 115 to 230 VAC 50 to 60 Hz autoranging 14 W maximum Operating Environment 0 to 50 C Up to 90 humidity Non condensing Regulatory Compliance ETL cETL UL 60950 CAN CSA C22 2 No 60950 EN IEC 60950 EN 60825 1 2 FCC Part 15B 1C 003 VCCI Class A C Tick AS NZS 3548 EN 55022 Class A EN 61000 3 2 EN 61000 3 3 EN 55024 CE Mark EdgeAccess Model 1040 Limited Lifetime Warranty Effective July 1 2005 and After Canoga Perkins warrants that at the time of sale and for its lifetime with certain exceptions noted below every Canoga Perkins labeled product purchased will be free from defects in material and workmanship for its lifetime if properly installed and used in conformity to Canoga Perkins published specifications This warranty covers the original user only and is not transferable For the purposes of this Warranty lifetime is defined as the serviceable life of the product a minimum of 5 years or any longer period during which replacement spare parts are available Subject to the conditions and limitations set forth below Canoga Perkins will at its option either repair or replace any part of its product s that prove defective by reason of improper workmanship or materials The warranty period for power supp
3. CANOGA PERKINS Model 1040 Standalone Enclosure User Manual NOTICE This device contains static sensitive components It should be handled only with proper Electrostatic Discharge ESD grounding procedures NOTE Cet quipement contient des composants sensibles aux d charges lectro statiques Il doit absolument tre manipul en respectant les r gles de mise la terre afin de pr venir de telles d charges NOTICE Canoga Perkins has prepared this users manual for use by customers and Canoga Perkins personnel as a guide for the proper installation operation and or maintenance of Canoga Perkins equipment The drawings specifications and information contained in this document are the property of Canoga Perkins and any unauthorized use or disclosure of such drawings specifications and information is prohibited Canoga Perkins reserves the right to change or update the contents of this manual and to change the specifications of its products at any time without prior notification Every effort has been made to keep the information in this document current and accurate as of the date of publication or revision However no guarantee is given or implied that the document is error free or that is accurate with regard to any specification Canoga Perkins Corporation 20600 Prairie Street Chatsworth California 91311 6008 Business Phone 818 718 6300 Monday Friday 7 a m 5 p m Pacific Time FAX 818 718 6312 24 hrs
4. SACTIONS OF THIS AGREEMENT MAY BE BROUGHT BY CUSTOMER MORE THAN ONE YEAR AFTER THE CAUSE OF THE ACTION HAS ACCRUED CANOGA PERKINS MAXIMUM LIABILITY SHALL NOT EXCEED AND CUSTOMER S REMEDY IS LIMITED TO EITHER i REPAIR OR REPLACEMENT OF THE DEFECTIVE PART OF PRODUCT OR AT CANOGA PERKINS OPTION 11 RETURN OF THE PRODUCT AND REFUND OF THE PURCHASE PRICE AND SUCH REMEDY SHALL BE CUSTOMER S ENTIRE AND EXCLUSIVE REMEDY AUTHORIZED RESELLERS ARE NOT AUTHORIZED TO EXTEND ANY DIFFERENT WARRANTY ON CANOGA PERKINS BEHALF Return Policy Customer must obtain an RMA Return Material Authorization number from the Canoga Perkins Customer Service Department before returning a product for service or repair Canoga Perkins technical support department can be reached through any of the following means Telephone 818 718 6300 Fax 818 718 6312 E Mail fiber canoga com If the warranty for a power supply fan optics consumable or software has expired customer must provide the Canoga Perkins Customer Service Representative with a Purchase Order to authorize the repair Send the defective product postage and insurance prepaid to the address provided to you by Canoga Perkins technical support representative Failure to properly protect the product during shipping may void this warranty The return authorization number must be written on the outside of the carton to ensure its acceptance The customer must pay for the non compliant product s return tran
5. jor alarm push the ACK button Connector Provides ALM IN and ALM OUT MIN and MAJ Alarm status from another device IN and to another device OUT 10BASE T Half or full duplex Ethernet EdgeAccess Model 1040 Installing and Using the 1040 Enclosure To use the 1040 enclosure see Figure 1 and follow these steps 1 Place it on a secure surface with room for air flow and within 7 ft 2 134 m of the AC power source Insert a module in the guide rails and press it firmly into the backplane then secure the thumbscrews finger tight At ALM OUT on the rear panel connect devices to receive alarm information see Figure 2 e NO The contacts are open for normal operation and closed in a fault condition e COM The electrical common e NC The contacts are closed for normal operation and open in a fault condition At ALM IN on the rear panel connect devices to supply alarm information see Figure 2 Connect cabling from the output on the device to IN on the 1040 and from the output to IN on the 1040 the internal alarm sense circuit is optically protected Connect an optional Frame or Chassis Ground to FGND 372377 385385 o o Zak MIN MA J d ALM IN ALM OUT Figure 2 Model 1040 Alarm Connectors S Plug the power cord into the rear of the 1040 enclosure then plug it into the AC power source this turns on the power To turn off the power unplug the power cord To set any switches on the module install the module in the 104
6. lies fans and optics is five 5 years Consumables such as filters are covered for one year Software is warranted for 90 days Hardened Media Converter HS products are covered for three 3 years This warranty does not cover any damage to products that have been subjected to lightning or other Acts of Nature misuse neglect accident damage improper installation or maintenance including over voltage failures caused by use outside of the product s specified rating normal wear and tear of mechanical components or alteration or repair by anyone other than Canoga Perkins or its authorized representative Ifthe user is unsure about the proper means of installing or using the equipment contact Canoga Perkins free technical support services Customer must notify Canoga Perkins promptly in writing of any claim based on warranty Canoga Perkins is not liable for and does not cover under warranty any costs associated with servicing and or the installation of its products or for any inspection packing or labor costs in connection with return of goods In the event Canoga Perkins breaches its obligation of warranty customer s sole and exclusive remedy is limited to replacement repair or credit of the purchase price at Canoga Perkins option Under no circumstance will Canoga Perkins be liable for consequential or incidental damages or loss of profits Warranty Registration To establish original ownership and to record purchase date please comple
7. sportation costs to Canoga Perkins for evaluation of said product s for repair or replacement Canoga Perkins will pay for the shipping of the repaired or replaced in warranty product s back to the customer any and all customs charges tariffs or and taxes are the customer s responsibility Canoga Perkins reserves the right to charge for all testing and shipping incurred if after testing a return is classified as No Problem Found CANOGA PERKINS 6 EdgeAccess Model 1040
8. te the warranty on line form on our product registration page URL www canoga com warranty Optional Service Programs Canoga Perkins offers several optional Service Programs Please call Canoga Perkins Sales Department 818 718 6300 or see our web site www canoga com for details CUSTOMER SERVICE DEPARTMENT REPAIR WARRANTY Repairs performed by the Canoga Perkins Customer Service Department will be free from defects in material and workmanship for a period of ninety 90 DAYS from the date the repaired product is shipped or until the expiration of the original factory warranty whichever is longer EdgeAccess Model 1040 5 Limitations Canoga Perkins may at its sole discretion modify its Limited Warranty at any time and from time to time Other than those expressly stated herein THERE ARE NO OTHER WARRANTIES OF ANY KIND EXPRESSED OR IMPLIED AND SPECIFICALLY EXCLUDED BUT NOT BY WAY OF LIMITATION ARE THE IMPLIED WARRANTIES FOR FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY IT IS UNDERSTOOD AND AGREED CANOGA PERKINS LIABILITY WHETHER IN CONTRACT IN TORT UNDER ANY WARRANTY IN NEGLIGENCE OR OTHERWISE SHALL NOT EXCEED THE AMOUNT OF THE PURCHASE PRICE PAID BY THE CUSTOMER AND UNDER NO CIRCUMSTANCES SHALL CANOGA PERKINS BE LIABLE FOR SPECIAL INDIRECT INCIDENTAL OR CONSEQUENTIAL DAMAGES THE PRICE STATED FOR THE EQUIPMENT IS A CONSIDERATION IN LIMITING CANOGA PERKINS LIABILITY NO ACTION REGARDLESS OF FORM ARISING OUT OF THE TRAN
Download Pdf Manuals
Related Search