Serene User Manual
Contents
1. No MAN10441 8 Maintenance User Manual SKOPE Contacts SKOPE INDUSTRIES LIMITED NEW ZEALAND CONTACT Head Office PO Box 1091 Christchurch New Zealand Freephone 0800 947 5673 Fax 03 983 3896 E mail enquiry skope co nz Website www skope co nz AUSTRALIAN CONTACT ABN 73 374 418 306 PO Box 7543 Baulkham Hills B C NSW 2153 Australia Freephone 1800 121 535 Fax 1800 121 533 E mail enquiry skope com au Website www skope com au2. cabinet is positioned Ensure the power supply can be easily accessed once the cabinet is positioned so the cabinet can be disconnected from the power supply for cleaning and maintenance When positioning the cabinet adequate clearance must be maintained for ventilation For efficient operation of the cooler it is essential that adequate ventilation be provided around the cabinet The maximum operating temperature is 32 C Climatic Class 4 This chiller should not be recessed or enclosed in a cabinet It is designed for free standing installation only The recommended clearance on both sides and at the back of the cabinet is 50mm When positioning the cabinet n Avoid direct sunlight and warm draughts etc n Allow adeguate space for the door to open fully n Ensure the cabinet is positioned on a level surface so the door shuts and seals correctly and to prevent the condensate tray from overflowing o Ensure the cabinet is positioned near a suitable power supply User Manual SERENE HB50 2 Operation Refrigeration System Lights Loading Cabinet Operation If the chiller has been disconnected from the power supply for any reason allow about 10 minutes before switching it back on This allows the refrigeration system pressure to equalise before the system is restarted Before operating the chiller ensure n The chiller is positioned on a level surface The maximum operating temperature is 32 C There is ad
3. User Manual MAN10440 Rev 1 0 Jan 2012 HBSO SERENE Counter Top Chiller Type HSC050 LED Lighting serene from SKOPE HB50 SERENE Counter Top Chiller Type HSC050 User Manual MAN10440 Rev 1 0 Jan 2012 2012 SKOPE Industries Limited All rights reserved SKOPE Industries Limited reserve the right to alter specifications without notice AE Ol oan AUG iS a registered trademark of SKOPE Industries Limited SKOPE INDUSTRIES LIMITED Head Office PO Box 1091 Christchurch New Zealand Freephone 0800 947 5673 Fax 03 983 3896 E mail enquiry skope co nz Website www skope co nz Trademark Infringement The SERENE trademark on this product is infringed if the owner for the time being does any of the following e Applies the trade mark to the product after their state condition get up or packaging has been altered in any manner e Alters removes including part removal or obliterates including part obliteration the trade mark on the product e Applies any other trade mark to the product e Adds to the product any written material that is likely to damage the reputation of the trade mark Notice of the above contractual obligations passes to e Successors or assignees of the buyer e Future owners of the product SERENE HB50 CONTENTS 1 Installation afety First OR RE RE OE OR OE OE EE Bye te die EE EE EE N EE Ee N he di N OE EE EE N POSINGRING is wird ER eo ERROR EE RR Oe
4. equate ventilation around the refrigeration unit There is a gap of at least 50mm around the cabinet The chiller is allowed to stand for 1 hour before connecting to the power supply While the chiller is operating it is normal to hear gurgling sounds caused by the flow of refrigerant when each cooling cycle ends The evaporator fan located inside the cabinet should operate when the cabinet door is closed and the chiller is plugged in The evaporator fan is activated by a door switch which turns the fan off when the door is opened The fan will continue to operate when the door is closed The sign light and cabinet interior lights will turn on when the cabinet is plugged in and will stay on permanently The chiller should be left running for 30 minutes to allow the cabinet to cool down before loading with product When loading the cabinet shelves with product n Allow air space around all the product for even cooling and efficient operation of the cooler Do not exceed a maximum of 15 kg per shelf Do not allow products to overhang the front or rear of the shelves as this will effect air flow Do not obstruct air flow from the evaporator fan inside the cabinet Do not block the condensation drain hole inside the cabinet Operation User Manual Operation SERENE HB50 Temperature Adjustment The storage temperature of the chiller is regulated by a thermostat located at the rear of the cabinet see below The thermo
5. es damaged it must be replaced by an authorised service agent or similarly qualified person in order to avoid a hazard This appliance is not designed to be stable in motion Use extreme caution when moving or transporting it Ensure all necessary safety precautions are observed during installation or removal of the appliance Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance WARNING Always disconnect the chiller from the mains power supply before cleaning or maintenance CAUTION Never overload the power supply which could damage the chiller and product See the rating label inside the cabinet for the safe power supply and current draw Installation User Manual Shelves Power Supply Ventilation Location Installation SERENE HB50 Unpacking Remove all packing material from the inside and outside of the cabinet including all adhesive tape holding the cabinet accessories Remove the packing material from all three shelves Position the shelf clips at the desired heights 4 per shelf and then fit the shelves into the cabinet see below Shelf Clip Shelf Positioning This chiller is rated 220 240 V a c and will draw a maximum of 1 2 Amps Do not overload the power supply The chiller is supplied with a power cord fitted with a 3 pin plug which exits behind the refrigeration unit The power cord should be retrieved before the
6. stat temperature setting is preset at the factory and should not require adjustment The thermostat knob is graduated from 0 through to 5 with 1 being the warmest and 5 being the coldest The normal temperature controller setting is between 2 and 3 If further adjustment is required o To make colder turn the thermostat knob clockwise o To make warmer turn the thermostat knob anti clockwise Thermostat Knob Cabinet Back User Manual SERENE HB50 3 Maintenance Cleaning Many commercially available cleaning products contain solvents that may attack the plastic components of this product and cause them to crack It is important to use only warm water and a small amount of detergent when cleaning this cooler Do not use abrasive or corrosive cleaners or boiling water n Disconnect the cabinet from the power supply before cleaning o When necessary wipe both the interior and exterior of the cabinet with a damp cloth Do NOT flush the cabinet with water o Clean the door gasket once every three months o The condenser coil and fan located on top of the cabinet should both be brushed regularly to remove any dust build up n Periodically check the condensation drain hole inside the cabinet to ensure proper drainage of any condensation Advanced Servicing Advanced servicing should be carried out by an authorised service agent Detailed service and spares information is available in the HB50 Service Manual Part
7. te eae ee Power SUPPLY ia Nek Se RE RR hd BERE RR ge ke BAR PRE BOE Ee yd Ventilation ER add OE EE OE EE teed Location sasaa ie EE EO OE 2 Operation Cabinet Operation EE EE EE EE EE EE EE ee ee ee ee Refrigeration System 0 0 SE EG Ee ee HONS 203 N wan eeawd ede Cea bh Gare eee ENE Wette EE OE IE EO EE RR EE ns Temperature AdjustmeNE EE EE EE eee 3 Maintenance ele AE TE SE N OR OE EO EO OT a Advanced Servicing ie EE ee de tees User Manual SERENE HB50 1 Installation Safety First Always observe safety precautions when using any electrical appliance Read these instructions carefully and retain them for future reference When the appliance is used by or near young children or infirm persons close supervision is necessary especially to ensure children do not play with it Do not use this appliance for other than its intended use Do not cover the grilles or block the entry or exhaust of airflow by placing objects up against the refrigeration system Do not probe any opening o Only use this appliance with the voltage specified on the cabinet rating label affixed to the appliance Ensure the appliance has adequate ventilation as this is essential to economical high performance Be careful not to touch moving parts and hot surfaces For your own safety and that of others ensure that all electrical work is done by authorised personnel If the power supply flexible cord becom
Download Pdf Manuals
Related Search