Lumina 500 - NiteRider
Contents
1. _ headlamp back and forth Once the handlebar mount is securely mounted slide the headlamp into place Helmet Mount 1 Unclamp the straps on each side of the helmet mount and pull them free 2 Position the plastic mounting plate as close to the centerline of the helmet as possible orienting the parallel grooves on the slider clip to the rear 3 Feed each strap into and out of two helmet vents circling each strap back to the upper edge of the corresponding clamp 4 Fasten the straps by inserting them into the clamps and snapping them shut OPERATION 1 The Lumina headlamp is shipped in lock mode In order to use the headlamp it must be unlocked To unlock the headlamp press and hold the power button for several seconds until the power button turns or flashes blue Release the power button 2 The light has 5 modes low medium and high beam daylight flash mode and walk mode Press and release the headlamp power button to turn the light on Cycle through the three brightness levels by pressing and releasing the power button 3 To access the daylight visible flash mode and press and hold the power button for greater than 3 seconds or until the headlamp begins to flash 4 With the headlamp in flash mode press and release the power button to access walk mode From walk mode you can return to normal mode by pressing and releasing the power button 5 To turn the light off from either normal flas2. 150 22844 RevA NiteRider Technical Lighting Systems Inc 8295 Aero Place Suite 200 San Diego CA 92123 www niterider com RIDING AT NIGHT While a Lumina lighting system will improve your view control and enjoyment of night riding please remember that cycling at night is an inherently dangerous activity In addition to using your lighting system properly and riding with extreme caution NiteRider urges you to e Never ride alone e Always let someone know where you are going e Wear a helmet and reflective clothing e Carry an auxiliary light and emergency supplies e Make sure the headlamp amp mounting bracket is securely fastened IMPORTANT INFORMATION LOCKING THE HEADLAMP FOR TRANSIT It is important to lock the headlamp and protect the switch from being pressed while it is in transit The headlamp can be easily turned on if placed in something like a backpack duffel bag or suitcase The headlamp gets hot while in operation To prevent potential damage from high heat or even fire it is very important to put the headlamp in lock mode and protect the switch from being pressed NiteRider will not be held responsible for damages to person or property resulting from a failure to follow the lock mode instructions PROTECTING YOUR INVESTMENT Properly charge your battery to maximize its lifespan See the Battery Charging and Care section for detailed information The Lumina will perform in wet weathe
3. eriod of time charge the battery every 3 months to maximize battery life
4. h or walk mode press and hold the power button until the light turns off 6 Always put the light into lock mode during transport of the headlamp in order to prevent accidentally turning on the headlamp To put the headlamp in lock mode press and hold the power button for several seconds until the headlamp turns off and continue holding the power button down through flash mode until the power button turns or flashes red Then let go of the Power button and test to make sure the light is in Lock Mode by tapping the power button the light will not turn on if the lock mode is engaged To Unlock the lock mode See step 1 of OPERATION LOW BATTERY INDICATOR With approximately 15 20 battery capacity remaining the indicator LED on the headlamp will turn from blue to red RESERVE MODE Reserve Mode will automatically shift your light to low beam when the battery is very low and about to cut off Once reserve mode starts you will only be able to use Low Beam Flash Mode and Walking Mode High Beam and Medium Beam will be disabled BATTERY CHARGING AND CARE 1 Plug one micro USB side of the USB charging cable into the Lumina charging port and the other into your computer 2 The LED charging indicator on the Lumina will remain red until the battery is fully charged once charged it will then switch to blue 3 Leaving the headlamp and USB charging cable connected indefinitely will not harm the battery 4 When storing for an extended p
5. hoosing the Lumina from NiteRider the innovator in technical lighting systems The Lumina combines a self contained high powered white LED headlamp with a rechargeable replaceable Lithium lon battery To get the most from your NiteRider light we urge you to familiarize yourself with the following safety and operating instructions PARTS LIST AND IDENTIFICATION Please verify the contents of your Lumina system Lumina 350 500 650 Lumina Handlebar Mount Lumina Handlebar Mount Shim Lumina Helmet Mount included with 650 USB Charging Cable moOW gt NOTE The Lumina headlamp is shipped in lock mode The headlamp will not operate until it is unlocked See the Operation section on how to unlock the headlamp MOUNTING The Lumina can be mounted to the handlebar or a helmet Lumina Handlebar Mount The Lumina Handlebar Mount is designed to fit on virtually any handlebar Remove the headlamp from the mount by pressing down on the release lever and sliding the headlamp off of the mount towards the release lever Release Lever Turn the Knob counter clockwise allowing the hinge to swing open Place the mount on the handlebar Knob on the either side of the stem Swing the hinge down to make contact with the handlebar Swing the hex bolt up seating the knob into its recess Turn the knob clockwise to tighten and secure the mount to the handlebar Aim the headlamp by swiveling the
6. r conditions but submerging it in water will damage the system SUPPORT If you experience difficulties during product installation or operation NiteRider provides free telephone support on weekdays from 8 00 AM to 4 30 PM Pacific Time at 800 466 8366 ext 4 You may also e mail us at Support niterider com WARRANTY NiteRider stands behind its products with the followin warranties eLifetime warranty on all mechanical components e2 years on electrical components e180 days on rechargeable batteries To obtain warranty service it is preferable to have your original sales receipt Contact the NiteRider customer service department at 800 466 8366 ext 4 to obtain a Return Merchandise Authorization RMA number The RMA number must be prominently displayed on the outside of your package The product must be properly packaged to prevent damage in transit For complete warranty information please visit our website at www niterider com RUN TIMES The Lumina 650 will run up to Light Level Time Lumens High 1 30 650 Med 3 00 400 Low 5 30 200 Walk 18 00 40 The Lumina 500 will run up to Light Level Time Lumens High 1 30 500 Med 3 00 250 Low 5 30 150 Walk 18 00 40 The Lumina 350 will run up to Light Level Time Lumens High 2 00 350 Med 4 00 200 Walk 21 00 30 Run times are approximations and will vary NiteRider Technical Lighting Systems Lumina 350 500 650 DISCOVER THE NIGHT Thank you for c
Download Pdf Manuals
Related Search