User Manual
Contents
1. On Off foot pedal B Flexible Current Carrying Hose Powerhead on off switch D Powerhead EJ Power Light Powerhead Height Adjustment Telescopic Tube MD swivel neck MN Side Parking Position Power Cable Storage and Accessory Compartment Bumper Protection Mm Dust Bag Holder inside canister N Filter Holder inside canister ol Combination Floor Brush fey Dusting Upholstery Combo Brush Le Speed Control R Powerhead Foot Pedal sauber POWERPROF SCP 9000 Before YOU Begin Do not operate the vacuum cleaner too close to heaters radiators and other hot surfaces Before inserting the plug into the wall make sure your hand is dry o gt Before turning on the vacuum cleaner remove any large or sharp objects from the floor or cleaning surface in order to prevent damage to the filter 4 When you want to pull the plug from the wall do not unplug by pulling on cord To unplug grasp the plug not the cord 88 5 Ifthe air inlet floor head or telescopic tube are blocked you should switch off the cleaner straight away and remove from mains power First clear the blocked substance before attempting to start the vacuum cleaner again Please do not expose the electrical hose to water or clean it with water Damaged cables should be inspected by an authorized Sauber service representative Do not use the machine if damaged cables are found Important instructions for use of a powerhead Leaving th2. Please refer to your vacuum cleaner manual first and have a look at the Removing Blockages section Check the swivel neck of the powerhead and the orange trap door 11 on the bottom of the powerhead Also check between these two openings in the powerhead POWERPROF SCP 9000 Accessories Dusting upholstery combo brush The small dusting upholstery brush can be used in two ways Use the dusting brush for dusting corners and crevices You can also use this when vacuuming 4 curtains but reduce the vacuum power manually Combination brush The combination brush can be used on hard floors and carpets You can manually set the hard floor function by pushing the slider to the front In the AUTO function the floor tool will automatically adapt to the surface according to the floor type POWERPRUF SCrP S000 Use the upholstery brush to vacuum upholstery and stairs You can manually set the carpet function by pulling the slider to the back Replacement of consumables Dust bag and filters Disconnect the cleaner from the mains power supply Open the cover by releasing the locking system and lifting the cover To change the dust bag cloth or synthetic ye remove the bag holder and put it aside Remove the dust bag and replace with a new y position and pull out one Secure the new 7 the filters Dispose of dust bag with the bag the filters and replace hold
3. height ise is at its lowest setting the brush is worn and needs to be replaced This detail applies only to carpet Green light only 7 Brush is working well We strongly recommend in normal use selecting a brush height that is only one level beneath that at which both the green and red lights are on For maximum cleaning performance the brush height adjustment can be lowered to its lowest setting Red light only 6 The brush is blocked see below Removing Blockages Turn off the machine unplug it and then remove the blockage To clean delicate floor surfaces the powerhead is equipped with an on off switch When this switch is used to turn off the brush roller the indicator lights 6 7 are also turned off Maintenance A Danger and Live Parts Within Always unplug the vacuum from mains power supply before dismantling any part of the machine The vacuum cleaner powerhead contains electrical connections The vacuum cleaner powerhead is not a serviceable part Removing the Brush Roller To remove the brush roller press the button marked PRESS 9 and turn the bearing 8 downward Turn the brush 24 quickly to the right and pull it out We recommend regular removal of threads and hair which have wound around the brush roller Removing Blockages If you can only feel a small amount of suction or the brush is not functioning correctly there might be a blockage
4. Conditions of Warranty Your Sauber Powerprof has a 2 year parts and labour warranty against product defects and failures when the product is used in accordance with the terms and conditions of this warranty statement This warranty commences from the original date of purchase and is not transferable please retain your original proof of purchase for any warranty claims This warranty is valid only in the country where the cleaner is purchased The cleaner must be operated in accordance with these instructions and used to remove DRY dirt and dust from carpets flooring and fabrics This cleaner is not designed for the collection of vitreous building material including particle board construction products and similar products such as wood hbres cement fillers fibre glass etc or excessive or frequent sand The infrequent pick up of these materials in these circumstances may be harmful to your cleaner and may void manufacturer s warranty Accessories and consumables including dust bags and filters unless defective in manufacture are not subject to this warranty In order to prolong the life of accessories and consumables regular care and maintenance is recommended When properly used and cared for your cleaner will render excellent service refer to the instruction manual for further details as misuse or failure to follow the instructions makes this warranty void In the event of service or advice being needed please co
5. amaged it must be replaced by a Sauber qualified service person in order to avoid any hazard e Use the vacuum cleaner only for dry substances Never use the vacuum cleaner in damp or wet environment e Never vacuum people or animals e Never vacuum sharp edged objects e Do not allow this cleaner to be used as a toy Use of this product by children should always be supervised by an adult e Be careful that hair fingers clothing never come in contact with the head while the vacuum cleaner is connected to the mains power e Never vacuum close to smoke sparks or fire Such as cigarettes matches hot ashes flammable liquids and gasses or explosive materials e Aerosols may not be sprayed in or on the vacuum cleaner as it could explode e Do not use the vacuum cleaner if it is damaged and if it breaks down Check the electrical components regularly for defects If you have damaged connection cables hoses electrical contacts and electric tubes please contact Sauber Customer Care 1800 728 237 PA wenrror SCP 9000 e Do not pick up liquid dry use only e Never clean the vacuum cleaner and all its electrical parts especially the electrical connections with water or liquid cleaners e Maintenance and repairs may only be undertaken by authorized Sauber customer service personnel Use only ORIGINAL Sauber spare parts and accessories e Never attempt to make any modifications electrically to the vacuum cleaner e This applian
6. ce is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Always switch the cleaner off and remove the plug from the mains power supply before cleaning your appliance when not in use or attempting any maintenance task The cleaner must only be connected to an AC supply at the voltage shown on the rating plate This cleaner should only be used for its intended purpose as described in these instructions Never operate the vacuum cleaner without filters SAFETY PRECAUTIONS 1 Keep hair hands and feet away from rotating brush while the powerhead is running 2 Never leave vacuum cleaner unattended when it is plugged in Unplug from outlet when not in use 3 Do not attempt to service or unclog the powerhead while the unit is running 4 The vacuum cleaner powerhead contains electrical connections the vacuum cleaner powerhead is not a serviceable part 5 The vacuum cleaner hose contains electrical connections the vacuum cleaner hose is not a serviceable part 6 The vacuum cleaner rod contains electrical connections the vacuum cleaner rod is not a serviceable part sauber POWERPROF SCP 9000 3 G RTA owerenor SCP 9000 Overview
7. e machine in a stationary position for an extended period of time while the brush roller is spinning may cause damage to your floor or carpet Be sure not to allow carpet edges or fringe into the brush As with any vacuum with a rotating brush this machine could cause damage to loosely woven carpets or rugs wool loop carpets long piled carpets or very soft sensitive floor coverings Please use the Combination floor brush for the above mentioned floorings We do not recommend the use of the powerhead for cleaning old and especially valuable hand crafted carpets If you have uneven flooring the metal part underneath the machine may come in contact with the floor causing scratches Please carry the machine across high thresholds 9 PY owerenor SCP 9000 Assembly The cleaner should be switched off and disconnected from the mains supply before you start to assemble Push the hose into the hose inlet on the canister Connect the telescopic tube to the combination floor tool or the powerhead Take the cable from the storage compartment and connect to the mains power supply Connect the handle on the hose to the telescopic tube To extend the length of the telescopic tube slide the lock down and pull the tube down To reduce the extension slide the lock up Start the cleaner by pressing the On Off foot pedal switch sauber POWERPROF SCP 9000 i Operation From the electronic contro
8. er once again with new ones To change the HEPA H13 filter and carbon filter unlock the HEPA H13 filter handle in the upright Take the new carbon filter and click into the HEPA H13 filter frame Ensure that the filters are correctly ii in place Lock the HEPA H13 filter handle in position Hook the top lid of the canister first in the front of the vacuum cleaner Secure the lid with the lid lock Cloth Dust Bag re useable e To empty the cloth bag remove the bag slide e Empty all dirt dust in the bag e Replace the bag slide and the bag is now ready to be used again e The cloth bag can be washed in warm water Ensure the bag Is dry before re using POWERPROF SCP 9000 Technical Data Double insulation D CE conforms to the EU directive for CE certification Safety approved according to AS NZS60335 1 and AS NZS60335 2 2 Product code 11300100 Supply voltage 220 240V 50Hz Nominal power 1100W Maximum power 1200W Powerhead 150W Powerhead speed 2700rpm Weight 6 2kg Operating radius 18m Parts and Accessories Product Name Product Code HEPA H13 Filter amp Carbon Filter 32200719 Dust Bags 2pk 32440295 Cloth Bag 1pk 32440296 Customer Service For customer service or product enquiries please visit our website or contact us at 1800 SAUBER 1800 728 237 www sauber com au www sauber co nz POWEAPAUF SCrP 2000 2 Year Warranty Sauber Commercial Powerprot
9. l handle To operate the powerhead press the brush button on the electronic control handle to turn On Off POWERPROP SCP 9000 EI2 1 Powerheao Carpets only keep their appearance when brushed thoroughly during vacuuming Powerhead El Brush height adjustment Swivel neck 4 Connection plug 5 Release button EJ Brush indicator light Power light EX Brush roller cover E Brush roller release button Foot Pedal Access door DANGER and Live Parts Within Operating Instructions The use of a powerhead is recommended for the optimal cleaning of carpets The rotating design of the swivel neck 3 allows the powerhead to move in any direction making it easy to manoeuvre around obstacles The powerhead also has an adjustable brush height and to the edge brush action for effective all round cleaning By pushing the foot pedal 10 and lowering the handle you activate the powerhead and the brush begins spinning Failure to use the foot pedal 10 will cause lasting damage to the machine POWERPR0OP S56P 3000 selecting the correct brush height Start at setting 4 on the height adjuster 2 and adjust according to the indicator light 6 7 The electronic brush control constantly monitors the status of the brush communicating the status through the lights on top Green 7 and red 6 The brush is not fully engaged in the carpet The height adjustment should be lowered If the
10. ntact Sauber Customer Care PO Box 5445 Brandon Park VIC 3150 or on 1800 728 237 Monday Friday 9am 5pm EST The decision to repair or replace the cleaner is at the sole discretion of Sauber If Sauber decide to repair or replace the cleaner it will do so at its own cost Sauber is unable to accept responsibility under this warranty for any repair work not carried out by an authorised Sauber Service Agent or from the use of non genuine parts If any part is no longer available or manufactured Sauber will replace it with a genuine functional replacement part This warranty does not apply to the cost of replacing any parts of the product due to normal wear and tear alterations improper installation physical abuse misuse or accidental damage Any transportation costs involved in the repair of defective parts shall be borne by the claimant If proof of purchase cannot be provided at the time of a warranty claim or service any work carried out on the cleaner is chargeable The repair or replacement of the cleaner under this warranty does not extend the original period of warranty The benefits conferred by this warranty are in addition to all other rights and remedies in respect of the product as outlined under the Competition and Consumer Act and other State and Territory laws Our goods come with guarantees that cannot be excluded in the Australian Consumer Law You are entitled to a replacement or refund for a majo
11. r failure and for compensation for any other reasonably foreseeable loss or damage You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure V2 11 12
12. sauber COMMERCIAL POWERPROF User Manual SGP 9000 2 MS o werrRor SCP 9000 We congratulate you for choosing Sauber Commercial Powerprof the first class commercial cleaning system Before operating the Sauber Powerprof please read this instruction manual carefully and keep it for future reference sauhut Es German Tor clean sauber POWERPROF SCP 9000 gt Safety Instructions Please read all the instructions attentively before using this vacuum Your new Sauber Powerprof is a high quality reliable innovative product that has been designed in Switzerland and made in Europe with the most modern technology The Sauber Powerprof comes with a powerhead that enables you to clean deep down dirt and dust from carpets Please read through the important safety instructions carefully before you use the vacuum cleaner e The manufacturer is not liable for any damage caused by improper use e Never leave small children unattended near the vacuum cleaner e Before cleaning the unit or changing the filters always switch off the vacuum cleaner and pull the plug out of the power socket Never pull the plug out by the power cable e Never leave the vacuum cleaner connected to the mains power when not in use e The electric hose contains electrical connections Do not use to vacuum water Do not immerse it in water for cleaning e Check hose regularly Do not use if the hose is damaged e f the power cable is d
Download Pdf Manuals
Related Search