Soneco MC2 - Soneco Oy
Contents
1. If phone numbers have not been previously saved into the memory the device will automatically switch to the number saving mode To change previously stored numbers press the button once when the flashing yellow indicator light turns green 3 Save phone numbers and press the action key once 4 Wait for the green light to start flashing to indicate the device is in standby mode 5 Send SOS ALARM SMS messages when needed by a single press of the action key 6 Turn off the device by pressing and holding the button until all three indicator lights are illuminated simultaneously Release the action button 7 Remember to charge the battery as needed 6 11 Soneco Oy 1 Charging the battery To charge the battery connect the plug of the charger to the charger connector located on the side of the device The yellow indicator light is illuminated constantly during charging whether or not the device is switched on When the battery is fully charged the yellow indicator light switches off The normal charging time of an uncharged battery is about two hours Charging is possible in all function modes of the device The yellow light is not illuminated when saving numbers and during normal starting of the device You can charge the battery every night if you like because overcharging is prevented NOTE If the battery becomes fully discharged for example after being stored unused for over 3 months it has to be pre charged Pre c2. Only use the Soneco MC2 charger 4300P Using other types of charges will void the approval classification and warranty of the device and may damage the device Soneco MC2 is not water proof Make sure the device stays dry The device should only be opened by an approved maintenance facility 10 11 Soneco Oy Important information A Keep the device switched off in hospitals and near health care equipment such as pacemakers and hearing aids The device may interfere with the operation of such equipment If you have a pacemaker do not carry the device around your neck Keep the device switched off when travelling in an airplane Make sure the device is not switched on accidentally amp L Switch the device off at filling stations fuel or chemical storages and blasting areas The device may interfere with the operation of technical equipment El The device may cause interference near TVs radios and computers 11 11 Soneco Oy Technical specifications Phone network dual band GSM 900 1800 MHz Antenna internal Weight 58 g without the carrying strap Dimensions 64 x 41 x 23 mm Battery Li lon 740 mAh Standby time gt 72 hours fully charged Charging time lt 2 hours to 100 Operating temperature 10 55 C when charging 0 45 C SIM card 3 0 V SAR lt 0 5 W Kg Operating voltage 3 7 V Patented 0523 Declaration of conformity Sonec
3. function key once The device will send the SMS message SOS ALARM to the numbers saved in the memory During sending of a text message the green indicator light will illuminate momentarily after which the device will switch back into function mode If the device gives three sound signals and the red indicator light flashes three times sending one or both of the SMS messages has failed Wait for the device to switch back into function mode and then try sending the SMS again 6 Switching off the device To switch off the device press the function button continuously until all three indicator lights turn on Release the button The device will give a sound signal and the indicator lights will illuminate for approximately 5 seconds as the device switches off Warranty Soneco Oy Ltd is not responsible for faults in the device caused by incorrect or careless use or use that is contrary to this user guide or connection of the device to another device or if the device has been repaired opened or otherwise modified or installed incorrectly Neither is Soneco Oy Ltd responsible for a fault in the device caused by inadequate mobile phone network operation or changes made to the mobile phone network 9 11 Soneco Oy Warranty clause This warranty is valid in Finland and it does not limit the application of currently effective mandatory Finnish legislation such as Consumer Protection Act to the purchase of the device Soneco O
4. second and the green indicator light will flash When numbers are saved the indicator lights will keep flashing the same was they did before receiving the message The phone numbers will be kept in the memory even if the device is turned off You can get to the operation mode by pressing the function key once If the text message that contained the numbers was not written in the correct form the device will give an error message three sound signals and flash the red light three times and switch back to the number saving mode Before starting using the device send a test message to ensure that the device is sending the SOS ALARM message to the correct number 8 11 Soneco Oy 4 Function mode The device will switch into the function mode automatically after starting if numbers have been saved in the memory and also after the function key is pressed when numbers are saved The green indicator light will flash The device is ready for sending the SOS ALARM message If the device loses its connection to the mobile phone network it will give three sound signals in rapid succession and the red indicator light will start flashing When network connection is resumed the device will switch back into the normal operation mode If the device does not reconnect to the network in a few minutes try turning the device off and restarting it 5 Sending an SOS ALARM message You can send an SOS ALARM message by pressing the
5. 1 11 Soneco Oy Soneco MC2 USER S MANUAL 2 11 Soneco Oy Published September 2007 Copyright 2007 Soneco Oy Ltd Soneco Oy Ltd Teknologiantie 14 A FI 90570 Oulu FINLAND Soneco MC2 is a trademark of Soneco Oy This document is intended for the product version Soneco MC2 under pro duction at the moment of writing this document Product support is available directly from the producer by e email lt sup port soneco fi gt or by phone 358 10 7788 300 It is prohibited to use copy modify reproduce or distribute this docu ment any part of it or its accompanying documentation for any purpose in any form by any means electronic photocopy photography recording or other without prior written permission from Soneco Oy Ltd Every possible effort has been made to ensure the validity of this docu ment It represents the current view as of the publishing date on the functions and properties of the products mentioned in the document Soneco Oy Ltd does not give any warranties with respect to the accuracy or completeness of this document or its accompanying documents Neither Soneco Oy Ltd nor the authors who have participated in the mak ing of this document shall be liable for any direct or indirect damages to humans machinery materials products production losses profit losses business interruptions or any other commercial damages that may result from using the products mentioned according to this docume
6. ey and wait until the green light starts flashing The flashing indicates that the device has signed on to the mobile phone network If phone numbers have not been previously saved into the memory the device will automatically switch to the number saving mode See step 3 7 11 Soneco Oy If you want to change previously saved numbers wait for the green light to illuminate during device boot up and press the function key simultaneously once The device will switch to the number saving mode 3 Saving numbers in the memory The device can be used to send a SOS ALARM SMS message to one or two saved numbers If only one number is saved the SMS message will be sent to that number If two numbers are saved the message will be sent to both numbers When the device is ready for receiving the number saving SMS message the green and yellow indicator lights will flash in turn Phone numbers are saved by sending the device an SMS message containing the number using a mobile telephone Write the number between the symbols lt lt lt and gt gt gt in the following manner lt lt lt 358XXXXXXX 358XXXXXXX gt gt gt NOTE Include all symbols in the message also lt lt lt and gt gt gt For example lt lt lt 358414319220 358414319221 gt gt gt or lt lt lt 358500677555 gt gt gt When the device is receiving and saving an SMS message to memory the yellow indicator light will illuminate for approximately one
7. harging is started automatically when the charger is plugged into the device When the charger is turned on the yellow indicator light will flash slowly Pre charging takes about one hour after which normal charging begins If the normal charging does not begin after about an hour disconnect the charger for a while and reconnect it to the device If normal charging still does not begin after an hour of pre charging contact the place where you bought the device or an authorised service point NOTE We recommend you do not leave the device uncharged for an extended period of time more than 3 months because then the charge may drop too low and the protective mechanisms of the battery may prevent its normal charging Low battery warning If the battery charge drops to 20 of full capacity the yellow indicator will blink five times in succession and the device will give a sound signal This is repeated about once a minute until the device is connected to the charger or the battery becomes fully discharged Approximately half an hour after the battery alarm has started the device will also send a BATTERY 20 SMS message to the first saved number if a charger is not plugged into the device before this 2 Starting up Start the device by pressing and holding the function key The yellow indicator light will illuminate for a moment The yellow indicator light will start flashing and the device gives a sound signal Release the function k
8. nt including but not limited to special incidental consequential or other damages All rights reserved Soneco Oy Ltd 2007 3 11 Soneco Oy ER DES fOr IA ii iii 5 Quick start instructions A dq METE a DO ee CTR A A 4 11 Soneco Oy Intended use Soneco MC2 is a small size device that uses the GSM network With one press of a button the device can be used to send an SMS message SOS ALARM to one or two numbers that have been previously saved to the device s memory Sending an SMS will also work abroad as long as the foreign operator has a roaming agreement with the GSM operator associated with the device Before you begin Make sure the package contains the following e Soneco MC2 device and neck strap e Soneco charger 4300 P e User Guide Preparation for use Before you can begin to use the device you have to install your personal SIM card without a PIN code request in the device and charge the battery Installing the SIM card Press the switch indicated in the picture Place the SIM card into The SIM card holder comes out the holder and push the holder back into the device NOTE Power must be switched off when installing the SIM card 5 11 Soneco Oy Quick start instructions 1 Start the device by pressing and holding the action key You can release the button when the yellow light starts blinking Move directly to step 4 if you re not going to program a number 2
9. o Oy Ltd hereby declares that the product Soneco MC2 is in compliance with the requirements of the European Council directive 1999 5 EC http www soneco fi
10. y Ltd grants the device a twelve 12 month warranty and the devices battery a six 6 month warranty The warranty period begins on the day when the first user gains possession of the device Soneco Oy Ltd or its authorised retailer shall repair or replace a faulty device at their own discretion This warranty does not cover normal wear and tear or the carrying strap supplied with the device Soneco Oy Ltd does not grant a warranty if the device is used contrary to this user guide improperly or carelessly or if the device is connected to another device or if the device has been repaired opened or otherwise modified or installed incorrectly Neither is Soneco Oy Ltd responsible for a fault in the device caused by inadequate mobile phone network operation or changes made to the mobile phone network If the user wishes to invoke the warranty granted by Soneco Oy Ltd the user has to present a legible receipt of purchase to Soneco Oy Ltd or the retailer of the device The user has to invoke the warranty regarding a fault in the device during the warranty period within two months of the date when the user discovered the fault or when it should have been discovered Soneco Oy Ltd is not responsible for any other demands the user may have that are not connected to this warranty unless the mandatory Finnish legislation dictates otherwise The device is only operational in areas with GSM network coverage at times when the network is operational
Download Pdf Manuals
Related Search