NADY 351 VR
Contents
1. NADY 351 VR WIREFESSIMICROPHONE Z MADY SYSTEMS INC BPO Sheimauad Streets Emerrailie Ca LEA DS BY THRS2 2 577 Fak 810 852 5075 INSTRUCTIONS SPECIFICATIONS Overall System Performance PREGUENGCY Response se NC M ne 25 20 000 Hz 3 dB Operating Frequency Range Choice of 5 channel between 170 216 MHz D namic RANG E UNE ns 120 dB max SPL to A weighted noise level Harmonie DISIO THON enr RE An as Rata ennemie nn lt 0 3 Frequency SAIS ARS SSSR dr 005 crystal controlled Modula RS CE A A et ns A rs FM 15 KHz Operating Range sesinccics tiuccdvisessannensasuecconehiainnccaassseds Up to 250 feet depending on site conditions 351 VR Receiver Controls ne d aaa Headphone volume controls with unit OFF ON switch Mute adjust Audio output level adjust Audo OUI NN Ea aeS 600 ohm unbalanced Connectors Audio output 3 5 mm mini jack Headset output 3 5 mm mini jack LED Indicators TX on LOW BATT unit ON single flash Low Battery Alert steady ULB LES PR ES Externally adjustable 1 UV preset minimum Unwanted Signal Rejection ss 60 dB image and spurious Power ROQUINOIMGIIS ssh a a ioral ones Single 9V alkaline internal Da RMC BALE MEE AT TI TT ee Softwire detachable WLT Lavalier Bodypack Transmitter Audio Input cece eeeeeeeeeeeeeees 3 5 mm mono locking jack for connecting to omni or unidirectional lavalier mic or unidirection2. Set Up After completing the above steps proceed to instructions for operating the Nady trans mitter included with your system WLT LAVALIER BODYPACK TRANSMITTER OFF STANDBY ON switch allows convenient audio muting with the transmitter ON e Low battery LED indicator flashes once for unit ON lights steady for low battery alert e Locking 3 5mm mini jack provides secure connection for removable microphone or instrument cable e Easily accessible input level adjust control for optimum sound Operating Instructions 1 Snap open the BATTERY COMPARTMENT 10 and insert a fresh 9V BATTERY 11 observing the correct polarity Close the compartment 2 The WLT is provided with a 3 5 mm LOCKING JACK 12 for connecting the microphone Plug in either the LAVALIER LAPEL 13 or the HEADWORN MICROPHONE 14 as supplied To secure the connection turn the metal slip ring on the plug clockwise to thread it on to the jack To unplug reverse the process Slip the transmitter into a pocket or clip on to your clothes To use the lavalier mic attach it at chest level Do not place too close to the mouth a distance of about six inches usually works best To use the headworn mic place it on the head and adjust the mic boom so that the mic is about one inch to the side of the front of the mouth Note The lavalier or headworn mic wire is also the transmit antenna and rolling up or shortening the wire may reduce the effective o
3. al head worn mic with phantom power COMFOIS en RS E enr de OFF STANDBY ON switch input level adjust LED INGIGalOrs LR me nt Unit ON single flash Low Battery Alert steady REF PONSCOUR SSSR ne ae nt 50 mW maximum allowed by FCC Harmonic and Sp rious EMISSIONS ss sanitaire ant gt 40 dB STIENE E R EE on baa ends Sunde le Odea lt et 9V alkaline BANC La Seen eee Aner e eer AAP EER UE URE Cre ce emer TE ea eR RITE ore a eee eee Up to 15 hours WHT Handheld Microphone Transmitter PUGIO MPU accue oo 8 si eeeccvereacdnucuus testa tsateance older E ia Nady DM 10D neodymium dynamic cartridge COMMONS Weert nani ecervens asd dbbansvsl EE EEEE A uen al OFF STANDBY ON switch LED Indicators acerca Sn ne Unit ON single flash Low Battery Alert steady PGs Power OO rect uaesiaecarenctiin same rate 50 mW maximum allowed by FCC Harmonic and Spurious EMISSIONS s nateur wit Medadasesechiuticllies ceccsansaeeresasabass lt 40 dB PLS TAY ass Res cn A ean tata nt dr nt 9V alkaline BATEAU Ra PA AE a ae e a nn Up to 15 hours Service for your Nady Wireless System U S Should your wireless system require service please contact the Nady Service Department via telephone at 510 652 2411 or e mail to service nady com for a Return Authorization R A Number and a service quote if out of warranty Make sure the R A Number is clearly marked on the outside of the package and enclose a cashier s check or money order if not prepaid with a cr
4. edit card Ship the unit prepaid to Nady Systems Inc Service Department 6701 Shellmound Street Emeryville CA 94608 Include a brief description of the problem you are experiencing The warranty card enclosed with this system contains additional valuable warranty and se rvice information Keep it in a safe place for possible future reference Do not attempt to se rvice this unit yourself as it will void the warranty International For service please contact the Nady distributor in your country through the dealer from whom you purchased this product 10 TABLE OF CONTENTS Using this Manual nn init nadniu 3 30 1 VR R C IM T a Le E 4 WLT Lavalier Bodypack Transmitter 6 WHT Handheld Microphone Transmitter 8 SPSCIICAL ONS ne ns soma ac 10 SEVICE aa ne ra om en nn 10 Thank you for purchasing a Nady 351 VR wireless camcorder microphone system and congratulations on your choice The 351 VR operates on long range interference free VHF high band frequencies It also utilizes a patented companding noise reduction system for excellent dynamic range 120 dB and hiss free performance The 351 VR will make a tremendous difference in your videos adding professional quality audio to every production Using this Manual Please read these instructions completely before operating your unit This booklet gives instructions for the operation of the Nady 351 VR wireless system
5. ent at all times to protect it Connecting Audio Output Plug one end of the audio cable provided into the AUDIO OUTPUT JACK 7 The other end should be plugged into your camcorder Connecting Headphone to Monitor You can monitor the received signal through headphones and you will need to monitor to set the transmitter s level trim properly Any Walkman type headsets with a minijack or minijack adaptor can be used though the signal may be heard in only one ear unless a stereo to mono adapter jack is used Monitoring through Receiver Plug headphones into HEADPHONE JACK 8 on the receiver The ON OFF VOLUME WHEEL 2 controls volume to the headset Set the volume to a comfortable level by rotating the volume wheel You will be able to hear the received signal to the receiver when the system is operational This is the monitoring method necessary when adjusting the WLT 15 transmitters microphone input level per page 6 Monitoring through Camcorder Many camcorders allow the user to monitor by providing a headphone jack If you plug your headphones into the camcorder you may need to make a simple adjustment on the 351 VR receiver If the sound you hear is uncomfortably loud or sounds distorted turn the AUDIO LEVEL CONTROL 9 on the back of the receive counter clockwise until good audio quality is obtained If volume is too low turn the AUDIO LEVEL CONTROL 9 clockwise until you obtain comfortable volume Transmitter
6. in maximum range You may also install Nady s optional rubber duck or flexible rubber duck antenna They all simply screw into the ANTENNA SOCKET 4 on top of the receiver Mute Adjustment In normal operation the MUTE CONTROL 5 on the back of the receiver should be set fully clockwise to the factory preset RF level of 1 uV However in areas of high RF activity the mute may need to be adjusted If with transmitter off the receivers TX LED 6 flickers or stays on the MUTE control should be turned counter clockwise until the TX LED extinguishes When the mute is properly adjusted the TX LED will light only when the svstem transmitter is turned on Note Turning the MUTE control too far counter clockwise will yield a quieter mute function but reduce your operating range 4 21 Battery Indicator LED 20 j OFF STANDBY ON Switch 18 Battery Holder l a 19 7 9V Alkaline Battery h WHT HANDHELD MICROPHONE TRANSMITTER e Features the Nady DM 10D unidirectional neodymium dynamic cartridge for optimum true sound maximum feedback rejection and minimal handling noise e OFF STANDBY ON switch allows convenient audio muting with the transmitter ON e Low battery LED indicator flashes once for unit ON lights steady for low battery alert Operating Instructions 1 Unscwthe BATTERY COMPARTMENT COVER 18 and remove exposing the battery holder Insert a fresh 9V ALKALINE BATTERY 19 obser
7. perating range Extend the wire fully during use and keep it as straight as possible 3 Turn on the WLT by sliding the OFF STANDBY ON SWITCH 15 to the STANDBY position transmitter on audio muted or the ON position transmitter and audio both on The BATTERY INDICATOR LED 16 will give a single quick flash indicating usable battery strength In the case of a dead or low battery the LED either will not go on at all or will stay on continuously indicating that the battery should be replaced with a fresh one 4 The microphone is now ready to use The TX LED INDICATOR 6 on the 351 VR receiver should now be lit indicating a received signal from the transmitter When ready to speak slide the transmitter switch to the ON position and adjust the volume of the receiver as per instructions on page 5 Re position the microphone farther from the source or adjust the AUDIO INPUT LEVEL CONTROL 17 if the monitored volume is to loud or distorted afer adjusting the receiver as per instructions on page 5 6 Note Microphone elements can easily be destroyed by the buildup of salts and minerals from perspiration and saliva It is good practice to put a windscreen on the mic element at all times to protect it 17 Audio Input Level Control 12 3 5 mm Locking Jack 16 P Battery Indicator LED 14 Headworn Microphone 15 OFF STANDBY ON Switch a ee Lavalier Lapel 10 SAT Bat
8. tery 7 CEG Compartment 2 va a F gt 5 11 9V Alkaline Battery Opening Battery Compartment
9. ving the correct polarity as marked and screw the cover back on to the microphone Make sure the cover is screwed on completely A fresh alkaline battery can last up to 15 hours in use but in order to ensure optimum performance it is recommended that you replace the battery after every 10 hours of use 2 Turn on the WHT by sliding the OFF STANDBY ON SWITCH 20 to the STANDBY position transmitter on audio muted or the ON position transmitter and audio both on The BATTERY INDICATOR LED 21 will g ie a single quick flash indicating usable battery strength In the case of a dead or low battery the LED will either not go on at all or will stay on continuously indicating that the battery should be replaced with a fresh one To preserve battery life turn the transmitter off when not in use 3 The microphone is now ready to use The TX LED 6 on the 351 VR receiver should now be lit indicating a received signal from the transmitter When ready to speak slide the transmitter switch to the ON position Receiver Volume Control Adjust Turn volume control on the 351 VR receiver clockwise to near full gain Wearing a monitor headset plugged into the receiver s headset jack speak into the lavalier microphone Adjust the receiver s volume to a comfortable listening level Note Microphone elements can easily be destroyed by the buildup of salts and minerals from perspiration and saliva It is good practice to put a windscreen on the mic elem
10. which consists of a wireless receiver an audio cord to connect the receiver to your camcorder and a wireless microphone transmitter either the WLT lavalier or Nady WHT handheld NADY 351 VR RECEIVER e Ultra compact receiver can be camera mounted or worn on the body with attached clip e Easy hookup to camcorder with supplied connecting cable e Powered by a 9V Alkaline battery in a convenient slide open battery compartment e LED lights indicate low battery and receiver signal e Detachable softwire antenna extends from the top of the receiver e Convenient operation with Output Level and Mute Adjusts separate 3 5mm Audio Output and Monitor Headphone mini jacks and Headphone Volume thumbwheel control with integrated unit OFF ON switch Operating Instructions Powering the Receiver Slide the receiver s battery cover open and place a fresh 9V battery in the BATTERY COMPARTMENT 1 observing the correct polarity Although a fresh alkaline battery can last up to 8 10 hours in use in the receiver in order to ensure optimum performance it is recommended that the receiver battery be replaced after 5 hours use Turn the receiver on by rotating the ON OFF VOLUME WHEEL 2 clockwise The LOW BATT LED 3 will flash briefly indicating adequate battery strength If the LOW BATT LED lights during use replace battery Antenna When the system is in use the 351 VR receiver s standard wire Antenna should be fully extended to obta
Download Pdf Manuals
Related Search