(taipei)iPower Reminder User Manual_Final.ai
Contents
1. compensate for environmental factors Q iPower does not charge the iPhone 4 4S 1 Make sure On Off switch on the iPower is in the On position 2 Double check the battery status on the iPower if the iPower has less than 10 it will stop charging the iPhone 3 Verify that your iPhone 4 4S is properly docked into the 30 pin connector at the bottom of the iPower FAQ continued Q What can cause a false Out of Range alarm 1 Low battery power 2 The human body is also a source of interference when carrying both iPower amp Reminder carry them on the same side of your body 3 Interference block by concrete wall metal objects or high power signals used by 2 4 GHz band devices i e Wi Fi networks or Microwave ovens Q How many charge cycles do you get with the iPower Over 300 cycles Q Will always be able maintain the same capacity for the iPower battery We cannot guarantee that your battery will always maintain the same capacity over time The battery capacity and lifetime depends on a variety of usage factors that are different for every iPhone 4 4S and user Specifications iPhone Support iPhone 4 4S previous generations of iPhone not supported 0 100 feet 0 30m Far 32 9 10m 3m Search FindMe distance Out of Range distances Near 16 9 5m 3m Component Reminder Unit iPower Li Polymer rechargeable battery Battery Type CR2032x1 1a Capacity 1900 mAh Batte Lif2. demonstrating abnormal behavior immediately stop all iPower use and contact the Manufacturer E Never dispose of the iPower in public garbage disposal it is unlawful under state and federal environmental laws and regulations Dispose of your iPower at your local battery recycling center Limited Warranty The product enclosed herein is warranted to be free of operational defects for a period of one year from the date of purchase In the event of a defect in operation during the warranty period we will replace the defective product when the owner returns all product contents The limited warranty will be considered void if the unit is tampered with subject to misuse negligence or accidental damage has been improperly serviced This warranty is limited to replacement only and shall not cover any other damages FCC Certifications Federal Communication Commission Interference Statement This equipment has been tested and improved to comply with the limits of a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This FCC Certifications equipment generates uses and can radiate radio frequency energy if installed and used not in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this eq
3. can search for a misplaced iPower using the Reminder but only if the iPower is within a 100 radius conversely you can also search for your Reminder with the iPower On the Reminder press the FindMe button and release as soon as the LED turns orange if the iPower is within 100 the iPower will begin to beep allowing you to locate it by following the audible Press the FindMe button again on the Reminder to suppress the iPower beep Conversely you can locate the Reminder with the iPower by using the FindMe button on the iPower the only difference is that when you press the button keep it depressed until you hear the Reminder beeping Reminder must be within 100 7 Power Usage and Recharging iPower On Off switch and iPower battery backup for the iPhone The On Off switch on the iPower determines whether the iPhone uses its own battery resource or the iPower battery reserves On instructs the iPhone to use the iPower s battery resource otherwise the iPhone will use its own battery Normally you would leave this switch Off until your iPhone runs low on battery power after which you can switch it to On Whenever the iPhone is using the iPower s battery resource the battery symbol that displays in the iPhone screen will have a charging symbol in it As long as the switch is ON the iPhone will first use power from the iPower battery until it is exhausted then the iPhone will use it s own battery resourc
4. ce is set to 16 Green indicates 32 By default the Reminder is set to 16 To change it to 32 simply depress the Range Setting button i e FindMe button on the Reminder until the LED changes to green indicating that the system is now set to trigger an alert at 32 Note that the actual Out of Range distance may vary 9 because of environmental factors e g walls and partitions Out of Range alarm After an Out of Range alarm is triggered if the Reminder is unable to re establish a link to the iPower within 20 seconds it will suppress the beep alarm and go into sleep mode If your iPhone location is known and is in range you can simply press the Reminder button once to re establish the link Disabling the Out of Range alarm If you temporarily leave the iPhone e g to answer the door and want to disable the Reminder Out of Range alarm for a short while press the Reminder FindMe button until after the LED turns orange and you hear the disable beep De Da Do The Reminder will go into sleep mode for 10 minutes After 10 minutes the Reminder will automatically try to relink with the iPower but only upon detection of motion using internal sensor 3 second intervals if motion is detected and the iPower is within range the link will be re established automatically If motion is detected and the Reminder cannot establish a link it will beep to remind you that the link has yet to be re established O Two way FindMe You
5. e Charging the iPower battery Take the cable supplied in the package and use the smaller Micro USB connector to attach it to the Micro USB Port on the iPower then take the larger standard USB connector on the cable and attach it to a computer USB port or a USB wall plug power adapter made for 4 4S iPhones Recharging takes 2 3 hours and the 4 LEDs on the back of the iPower will blink while recharging Charging statuses represented by the iPower LEDs are as follows 10 20 30 50 60 80 80 90 100 Vwi wi Vw wi NI 17 I IY Tu TiN TIN If you are charging the iPower with the iPhone installed the iPhone will be the first device to become fully charged Note Recharge your iPower battery every 2 months when not in use Checking iPower battery status Press the Battery Status Button i e FindMe once and the iPower will flash 1 to 4 of the LEDs depending on remaining battery power If it flashes all 4 LEDs the iPower battery is mostly charged 80 100 if it flashes only 1 LED it is only 0 20 charged Low battery conditions The Reminder will chirp every 2 minutes indicating low battery conditions If the iPower runs down its battery reserves completely the Reminder will lose the link and issue a beep alarm O FAQ Q Why is the Out of Range detection distance not always consistent Radio signal strength and signal reflection are affected by the environment You can try adjusting the Out of Range distance setting to
6. e 50 days Up to 300 hours Y 8 hours day on standby on standby Alarm beep at 10 cm or 3 9 95 dB 85 dB Weight 0 3 oz 9 59 2 64 oz 759 2 42 x 1 42 x 0 46 4 96 x 2 48 x 0 62 Dimensions L W H 126 5x63 3x16 7 mm 61 5x36x11 6 mm Warnings E Excessive electrical noise in certain environments may affect iPower Reminder functionality E Change batteries if audible alarm becomes weak E Comply with National Int l Flight safety regulations when using device on flight trips E This product s operating temperatures are between 14 F 140 F 10 C 60 C Storage Temperatures should be between 4F 185 F 20 C 85 C E Do not store the iPower where temperatures are excessively high and avoid sunlight E Avoid any trauma or impact to the iPower If there are any dents punctures tears deformities or corrosion no matter the cause discontinue use and contact manufacturer or dispose of it in an appropriate manner at your local battery recycling center E Do not disassemble repair modify or replace the iPower or any of its components E Keep the iPower dry at all times and do not expose the iPower to moisture or liquid E Only use the device s USB connector and instruction herein to recharge the iPower E All batteries are subject to thorough quality assurance inspection If you find that your battery is excessively hot is emitting odor is deformed has abrasions cuts or is experiencing or
7. iPower Reminder User Manual Oo Introduction The iPower Reminder is the most effective loss prevention solution for your iPhone 4 45 It is an electronic leash that notifies you with an audible alarm whenever your iPhone leaves your vicinity Out of Range or whenever you leave your iPhone behind The Reminder also assists you in locating your misplaced iPhone within a 100 radius FindMe function This product comes in two parts the iPower attaches to your iPhone and also serves as a battery backup for your iPhone the Reminder unit is kept with you to remind you to pick up your iPhone or to help you locate a misplaced iPhone 2 Package Components A Reminder Unit B iPower C Micro USB Cable D Key Chain Link E Battery for Reminder F Manual not shown If any components are missing from the package return the product to your dealer immediately Product Description iPower Embedded iPower Battery d iPhone Connector sia s N s On Off Aa Micro USB Witch Status Port LEDs Battery Status Button iPower FindMe Button Reminder Unit oot Battery Cover O Bi Range Setting Button On Off i Key Chain Link Reminder FindMe Button Switch O Quick Setup Guide Step 1 Place iPhone in iPower iPhone Adapter iPower Connector Separate the iPower Head from the Base Then Slide the iPhone bottom first into the iPower Base as shown
8. making sure the connector within the iPower lines up with the adapter on the iPhone Slide the iPower Head onto the top of Guides the iPhone making sure that the side guides on the Head line up with the side tracks on the Base Tracks Step 2 Place battery into the Reminder Unit Open the battery cover by placing your thumb on the cover as shown and pulling it backwards until it clicks open then lift off the cover Insert the battery into the battery compartment with the sign on the battery facing up Then replace the battery cover by sliding it up into compartment opening Step 3 Turn on the Reminder The power switch on the Reminder is located at one end slide it to the left as shown to turn on power When the Reminder and iPower have established a link an LED light will begin to blink on each device Reminder Power Switch Step 4 Test the iPower Reminder system Test your setup by placing the iPhone in a stationary location Then take the Reminder and walk away from the iPhone when you reach 7 20 feet from the iPhone the Reminder will begin to beep If you move back into range the alarm will cease 7 20 Feet Congratulations you just completed the Quick Setup iPower Reminder User Manual O Out of Range additional info Setting the Out of Range distance Out of Range distances can be set to 16 or 32 If the Reminder LED shows RED during normal operations the distan
9. uipment does cause harmful interference to radio or television reception which can be determinedly turning the equipment off and on the user is encouraged to try to correct the interference by one of the following measures 1 Reorient or relocate the receiving antenna 2 Increase the separation between the equipment and receiver 3 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected 4 Consult the dealer or an experienced radio TV technician for help This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept an interference received including interference that may cause undesired operation FCC Caution Any changes or modifications are not expressly approved by the party responsible for compliance which could void the user s authority to operate this equipment EU DECLARATION CONFORMITY This product is carrying the CE Mark in accordance with the related European Directives 91E 02B9 U50G00
Download Pdf Manuals
Related Search