T-MAX™
Contents
1. Lumen Output 700 Lumens at the maximum brightness setting Batteries e 2 CR123 3 Volt Lithium Batteries ANSI 5018LC IEC CR17345 e Run Time Max 2 hours High 4 hours Medium 16 hours Low 60 hours NOTE High quality rechargeable CR123 batteries may be used to power the T MAX Tactical Light The user should identify the voltage capacity of any rechargeable batteries prior to installing them into the T MAX Tactical Light IMPORTANT Never install any rechargeable CR123 batteries that exceed a combined voltage of 8 volts as this will damage the internal circuitry and void the warranty Environmental Specifications e Normal Operating Temperatures 20 F to 120 F e Waterproof REPLACEMENT PARTS To order replacement parts please call 877 454 4450 or visit www firstlight usa com BATTERY INSTALLATION STEP 1 Remove battery cap Insert two batteries terminals first as shown above STEP 2 Reinstall battery cap Hand tighten until snug STEP 3 Ensure batteries are properly installed by pressing any button on the control panel The red LED lock should illuminate indicating the light is in Lockout Mode If it does not repeat Steps 1 and 2 ensuring both terminals are facing up COMPONENTS CRENULATED BEZEL STEEL BELT CLIP BATTERY HOUSING SLEEVE BATTERY CAP BASIC FUNCTIONS Control Panel Diagram LOCK UNLOCK INDICATOR CYCLE CONTROL CONSTANT ON CONTROL2. 7 FIRST LIGHT is TABLE OF CONTENTS Specifica ONS mene con asias 3 Battery Installation tai idos 4 COMPONEN citant E AENA 5 sis ies 1 01010101010101 6 Lockout Ready 6 Momentary Mode 7 GonstantOn MOde cerner prt er RR E HER a er Ea EX d FT HR Ea 7 10 1 1 00100 8 Ready Strobe 1 sn 8 Low Battery Indication 1 1 1 1 1 1 1 1 1 1 1 1 1 00000 9 151110817 LOO ici E RO 10 0 000000 11 Lifetime Limited Warranty conce a 12 FIRST LIGHT USA LLC 205 S Main Street Seymour IL 61875 Phone 877 454 4450 Fax 877 454 4420 Email info firstlight usa com www firstlight usa com Thank you for purchasing the First Light USA T MAX Tactical Light Please carefully review this manual prior to use IMPORTANT PLEASE READ FIRST The intense white light emitted by the primary white LED may cause temporary blinding regardless of the brightness level used Use caution during operation Do not point light directly into eyes at any distance Not for use by children LITHIUM BATTERY WARNING Lithium batteries can be dangerous if used improperly Never disassemble short circuit recharge or expose to water fire or high temperatures Never use batteries of different ages capacities or brands together Store separately and properly dispose of batteries after use Keep away from children SPECIFICATIONS
3. 877 454 4420 205 S Main Street Seymour IL 61875 Email info firstlight usa com 12 WHEN YOUR LIGHT DEPENDS ON IT www firstlight usa com REV 15 03
4. MOMENTARY CONTROL LOCKOUT READY MODE Lockout Mode prevents accidental illumination OO DICATOR To unlock the light and enter Ready Mode press the Constant On and Cycle Control GOKSTANEON buttons simultaneously and release The green CONTROL unlock indicator will illuminate signaling that visible light modes are active To reenter Lockout Mode at any time during use press and hold the Constant On and Cycle Control buttons simultaneously for 1 second The red lockout indicator will illuminate MOMENTARY CONTROL CONSTANT ON CONTROL NOTE While the primary white LED is activated in Momentary Mode Constant On Mode can be activated by simultaneously pressing the Constai n Control and Momentary Control buttons then releasing both buttons MOMENTARY MODE The Momentary Control button activates the primary white LED at maximum brightness when pressed When released the white LED turns off NOTE To momentarily activate the secondary colored LEDs from the off position press and hold the Cycle Control button When released the secondary LEDs turn off The secondary LEDs will illuminate at the last used Constant On brightness level CONSTANT ON MODE The Constant on Control button activates the primary white LED and secondary color LEDs in Constant On Mode To turn on the primary white LED from the off position press and hold the Constant On Control button until the white LED
5. illuminates then release To turn on the secondary color LEDs from the off position press and release the Constant On Control button To turn the light off press and release the Constant On Control button CYCLE CONTROL CYCLE CONTROL MOMENTARY CONTROL NOTE Upon exiting Ready Strobe Mode the light will default to the last used function CYCLE CONTROL The Cycle Control button is used to adjust the brightness level of the primary white LED while in Constant On Mode Press and release the Cycle Control button when the primary LED is illuminated to select one of three brightness levels The light will default to the last used Constant On brightness setting READY STROBE MODE With light in Ready Mode but not on activate strobe by pressing the Cycle Control button The strobe will activate as long as the Cycle Control button is pressed With the light in Constant On Mode activate the strobe by pressing and holding the Momentary Control iJ button with the base of the thumb Then press the Cycle Control button with the front portion of the same thumb The Ready Strobe function can be activated ONLY as a momentary function and cannot be locked on LOW BATTERY When the battery nears the end of its useful life INDICATOR the red Lock Unlock indicator will begin to flash Once the useful life of the batteries has been reached the T MAX will begin to limit its out
6. is specially designed to attaching securely to MOLLE PALS webbing See Figure A to view suggested mounting option FIRST LIGHT USA LLC LIFETIME LIMITED WARRANTY The PERIOD OF WARRANTY shall be for the lifetime of the lighting device from date of purchase First Light USA will repair or replace free of charge at First Light USA s option any part due to defects in materials or workmanship Certain countries and jurisdictions restrict limited lifetime warranties If you reside in one of these countries or jurisdictions First Light USA extends to you a 10 year limited warranty which maintains the following terms and conditions First Light USA at First Light USA s option may refund the purchase price to the original owner if unable to make the product perform the work for which it was designed by repair or replacement of a product of at least equal value The limited warranty contained herein is the purchaser s exclusive remedy THIS WARRANTY EXCLUDES damage or defects caused by neglect abuse misuse alteration disassembly improper maintenance or accidents Batteries or damaged caused by defective or neglected batteries are excluded from this warranty Accessory items are also excluded from this warranty Electronics other than light emitting diodes LEDs are limited to a 3 year warranty with proof of purchase To obtain warranty service call 877 454 4450 or send e mail to info firstlight usa com First Light USA will then issue a Ret
7. put in order to extend run time FINGER LOOP FINGER LOOP Your T MAX comes equipped with a Finger Loop installed in a neutral straight forward position In order to enhance the ergonomic control of the T MAX it is recommended that the Finger Loop be slightly offset to better align the thumb with the control panel The Finger Loop can be moved by pushing it to the desired position LOOSEN HERE INSTALLING FINGER LOOP A smaller Finger Loop is also provided In order to install the smaller Finger Loop loosen the threaded connection between the lamp housing and battery housing until the large Finger Loop is loosened to a point at which it can be removed Insert the collar of the smaller Finger Loop so that itis seated within the machined groove located at the top of the battery housing IMPORTANT Ensure that the Finger Loop remains securely seated during use Hand tighten the connection between the battery housing and lamp housing as firmly as possible 10 LOOSEN HERE Figure A MOLLE Steel Clip attached to MOLLE PALS webbing 11 T MAX STEEL CLIP The T MAX Steel Clip can be adjusted to any desired position by loosening the connection between the battery housing and the lamp housing to the point where the Steel Clip can be moved Move the Steel Clip to the desired position and re tighten the connection MOLLE PALS Webbing Attachment The T MAX MOLLE Steel Clip
8. urn Merchandise Authorization RMA and instructions on warranty return The original owner must include the RMA upon returning the product in order to obtain warranty service from First Light USA We will pay to ship the repaired or replaced product to the original owner s address if located within United States If the original owner s address is located outside of the United States we will ship the product freight collect If we determine the remedy is not covered under this warranty we will notify you and inform you of service options available on a fee basis FIRST LIGHT USA LLC MAKES NO OTHER WARRANTY OF ANY KIND EXPRESSED OR IMPLIED ALL IMPLIED WARRANTIES TO INCLUDE BUT NOT LIMITED TO WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE WHICH EXCEED THE OBLIGATIONS AND TIME LIMITS STATED IN THIS WARRANTY ARE HEREBY DISCLAIMED BY FIRST LIGHT USA LLC AND EXCLUDED FROM THIS LIMITED WARRANTY SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU ALSO EXCLUDED FROM THIS WARRANTY ARE ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES INCLUDING LOSS OF USE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES EXCLUSIONS MAY NOT APPLY TO YOU THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE FIRST LIGHT USA LLC Phone 877 454 4450 WARRANTY AND SERVICE DEPARTMENT Fax
Download Pdf Manuals
Related Search