satety warning summary packing list main connection
Contents
1. required angle and direction for a returning direction journey the unit for angle is degree When angle is less than 5 degree it would consider as accurate so direction would not be displayed Horizontal distance The horizontal distance corresponding to the point of 0 99 9km corresponding to the departure the unit would be adjusted automatically point of departure Signal indication of When the device is under interference and out of control remote control range it would flash Flying time The flying time is accumulated from the first take off When there are 4 or more GPS satellites and the speed exceeds 5m s the first time it starts counting2. safety please check the wires again after connection then connect to the power 2 After connecting to power if GPS is NOT Detected is displayed and flashes it means there is no GPS module or it is not well connected Re connect the GPS and connect to the power again Note if there is flashing massage check the corresponding port is well connected and battery voltage is normal Then connect to the power again INDICATIONS OF THE LED LIGHT E RED Power Indicates power supply please check if the system is correctly connected when the light is off DISPLAY EXPLANATION As shown in the following diagram The rectangle in the center is the display range of the plane icon As a warning many of the displayed information would flash When the GPS signal is not strong enough latitude longitude numbers of GPS satellites speed altitude the plane icon returning angle amp direction horizontal distance corresponding to the point of departure would be flashing When the signal becomes fine flashing would stop automatically When user enters this mode the first time after charging if positioning of the GPS has not yet been completed latitude and longitude would not be shown The display area would appear the flashing words of GPS Searching Data which means the GPS is still searching for the satellites To guarantee the navigation information is accurate please wait until the latitude and longitude data are di
3. SKYLARK Tiny OSD QUICK USER MANUAL SATETY WARNING www sSkylarkFPV com SKYLARK OSD is for entertainment purpose only users should bear all the risks involved when using this electronics device SUMMARY 1 Simple to use equip with video input output and power supply voltage only 2 The functionalities provided including graphical altitudinal speed return arrow prompts radar and low voltage alert PACKING LIST 1 Tiny OSD board 1 pe 2 100A Current sensor 1 pe 3 4 Hz GPS board 1 pe 4 GPS cable 1 pe 5 Current sensor cable 1 pe 6 User manual 1 pe 7 Reserve wire MAIN CONNECTION several pcs 1 Please follow the guide and install the system step by step otherwise it may cause non recoverable problems 2 Main connection the interfaces on PCB are labeled with corresponding port numbers Front side GPS port connect with GPS Steering gear port connect with steering gear and supply the power to OSD main board VO the video transmitter signal connects with the camera VI connect with the camera signal Rear side connect with current sensor signal GPS E Front side voltage GND connect to steering gear Note current sensor is Video transmitter connected to the port that is on GPS rear side Camera GND SKYLARK Tiny OSD QUICK USER MANUAL OPERATION PROCEDURES www sSkylarkFPV com 1 Follow the descriptions on the interface connect all the wires To ensure users
4. splayed before takeoff If the device is under interference signal indication of remote control would flash for certain seconds so as to warn the user that it is out of the control range 22 541216N 113 932262E 9 km h 0 34A 12 6Uii 179 40 2nfh 3993m SKYLARK Tiny OSD QUICK USER MANUAL www skylarkFPV com DISPLAYED INFORMATION DESCRIPTION Longitude E is East Longitude W is West Longitude Unit is Degree 180 0E 0 180 0W Numbers of GPS Numbers of GPS satellite that can be received signal O 9 9 would be satellites currently displayed even more than 9 Speed Total speed unit is Km hour 0 999km h Current Operation current unit is A 0 0 99 9A Voltage System voltage unit is V it would flash when under voltage 0 0 99 9V Electricity The electricity consumed from system start up till now unit 0 0 9999mAH consumption is mAH Remaining electricity The battery symbol indicates the remaining electricity level It takes a 2200mAH when it is nearly used up the symbol would flash battery as indication standard Location amp direction The plane icon indicates the existing location amp direction corresponding to the point of departure Up North Down South Left West Right East The flying direction is shown by the plane icon Altitude Altitude that corresponding to the point of departure The 9999 9999m corresponding tothe figure can be negative unit is meter point of departure Returning angle amp Indicate the
Download Pdf Manuals
Related Search