SM 8000 USER MANUAL SpaceMaster Series
Contents
1. SM 8000 USER MANUAL SpaceMaster Series Photoelectric retro reflective sensors Product Data Electrical Data DC AC Supply Voltage 10 30 V de 20 250 V ac Voltage ripple 15 Reverse polarity protected Yes Short circuit protected Yes Current consumption 14 mA 2 mA Max output load 120 mA 200 mA Environmental Data Temperature operation 20 to 60 C Sealing class IP 67 IP 60 ac CE Alu Approvals dc CE Available Models Supply Output Sensing Model Voltage Cueut Mode Range SMRR 8400 NPN Light dark 10 30 V dc Retro 0 3 m Reflective SMRR 8500 PNP Light dark adjustable SMRR 8800 20 250 V ac SCR Light dark Note Measured against 85 mm retro reflector Illustration 4 YS OF 9t A Output indicator V 24 Light dark switch Power on indicator Sensitivity adjustment DC Models AVE G Eee Light dark switch a M18 x 1 Ora Connection Output indicator Sensitivity adjustment 1 2 AC Models Wiring Diagrams Ay i MLL SMRR 8400 Transistor NPN SMRR 8500 Transistor PNP Brown R V ac supply SN Blue Load WARNING ON AC MODELS SMRR 8800 DO NOT CONNECT THE SENSOR WITHOUT A SERIAL LOAD SCR Website www telcosensors com E Mail info telcosensors com Made in Denmark Warning This product is not a safety system and must not be used as such It is not designed for personnel safety applications and must not be used as a stand alone personnel safety s2. s advised for applications with contaminated environments Increase the sensitivity to maximum by turning the potentiometer to full clockwise position Sensitivity adjustment may be required in applications where objects to be detected are small or translucent Proceed with the following steps Start with the sensitivity at maximum by turning the potentiometer to full clockwise position 2 Select target object with smallest dimensions and most translucent surface Place target object between the sensor and retro reflector If the output status 3 changes adjustment is not required If the output has not changed proceed to step 4 Decrease the sensitivity by turning the potentiometer counter clockwise until the output changes If the output has not changed attempt to move the sensor and a retro reflector further apart or angle the sensor retro reflector Then repeat procedure from step 1 5 Remove target object Check the output status has changed V 1 11 Part Number 0666220643 January 2011 edition Telco A S reserves the right to make changes without prior notice
3. ystem eo o o o Telco fonsors Connection Wires Pins Cable 3 pin M8 plug 4 pin M12 plug AC supply Blue amp Brown Supply Brown Pin 1 Pin 1 Supply Blue Pin 3 Pin 3 Output Black Pin 4 Pin 4 Sensor plug Sensor plug Mounting amp Alignment Mounting amp Alignment 1 Position the sensor pointing at a retro reflector Align by moving sensor horizontally and vertically until the output is deactivated when aiming at retro reflector and when no object is present refer to Output Logic table 3 Fasten the sensor securely using the enclosed locking nuts and or a mounting bracket Avoid acute angles on cable close to sensor Adjustments Output Mode Selection The output mode can be selected via an integral light dark switch Refer to Output Logic table for output mode reference Enables the output to be inactive Turn switch to full clockwise Heni Operes NC when there is an object present position Turn switch to full counter clockwise position Enables the output to be active Dens Operetes NO when there is an object present Output Logic Output Yellow LED Detection Output mode Bi DC AC models models 1 2 Object present Dark operated EE Ga oi Oi B N O _ Light operated N C Open Off On Off biccuabeent AEE oe Close On Off On N C lt __ D lt ie Numa Open Off On Off Sensitivity Adjustment Maximum sensitivity can be used for most applications and i
Download Pdf Manuals
Related Search