User`s Manual of Power Amplifier
Contents
1. User s Manual of Power Amplifier System Configuration External Antenna External cable Lightning Protection KIT External cable Power Amplifier A f External cable 2 4 GHz product DC Injector NOTE For outdoor installation you may need plastic tubes Insert the N Type cable into the plastic tube then assemble with the N Type connector Move the plastic tubes to the junction of the connector and the cable and then heat it up to contract the plastic tubes Power Amplifier Mounting Flanges Antenna Connection i il a4 Power Transmit LED Radio Connection This port connects to the antenna This port connects to the DC Power Injector Mounting holes are provided for either mast mounting using the included U bolts or bolted directly to a bracket or other structure This LED glows GREEN in receiving mode when power is applied to the amplifier and flash RED when transmitting DC Injector Power LED Buzzer Connection to RF and DC Power to Amplifier Transmission LED It rings when the cable mismatching or voltage operates abnormal In these situation the Power LED will glows RED This LED glows GREEN when power is applied to DC Injector and flashes RED when the cable mismatching or voltage operates abnormal This LED glows GREEN in transmission mode when the power is sent to the power amplifier This port connects to the Radio device ex Wire2. ector that attached with this unit Connect one end of the grounding cable to the Ground terminal and the other end to a good ground connection Mounting Instruction This power amplifier can be mast mounted using the stainless steel U bolts as shown in Figure 5 and Figure 6 Refer to the sketch for proper positioning Carefully tighten the bolts using the included nuts Take care not to over tighten the bolts or cause damage to the RF connectors on the amplifier Because the amplifier is a sealed unit these connectors can not easily be repaired This unit can also be mounted to a flat surface using any of the mounting holes on the unit s mounting flanges
3. less PC Card This port connects to the Power Amplifier to Amplifier NOTE Connection to Radio port MUST connect to the radio device ex Wireless PC Card and RF and DC Power to Amplifier port MUST connects to the Power Amplifier If connecting in OPPOSITE way all of the devices will be DAMAGED Lightning Protector PR Ground Cable N Type F N Type F Radio transmitters receivers and RF cables require protection when attracted by lightning strike The surge protectors contain fast response gas filled arrestors to provide low let through voltage for fast rise time transients The device is configured to minimize circuit capacitance and the performance can be assured up to 2GHz Standard models provide protection for receivers and transmitters up to a 1K W power level Installing this device in outdoor may be subject to lightning strikes To properly protect your equipment you should install the lightning arrestor to prevent an electrical surge from traveling through the antenna cable and into the building Lightning protection for a building is more forgiving than protection of electrical devices A building can withstand up to 100 000 volts but electrical equipment may be damaged by just a few volts Direct earth grounding of the antenna and the Lightning Protector is necessary to protect the installation from lightning and the build up of static electricity The ground terminal is located on the lightning prot
Download Pdf Manuals
Related Search