MODULE INSTALLATION GUIDELINES
Contents
1. Sy r RADIOTRONIX A C ife without wires 905 Messenger Lane Moore OK 73160 P 405 794 7730 F 405 794 7477 www radiotronix com MODULE INSTALLATION GUIDELINES Form MIG 001 Revision B General Production Guidelines 1 Radiotronix designs modules that are formed into a hybrid surface mount package which allows both manual and automated placement 2 These modules contain descrete components therefore the assembly procedures utilized by automated or manual techniques are critical for the performance after installation on the end users product 3 Radiotronix reccommends the following procedures be followed by all assembly personnel 4 Proper ESD precautions are required while handling Radiotronix modules Manual Assembly 1 The primary mounting surface for the module is located on the bottom pad surface 2 Castellations have been provided that run perpendicular to the pad surface beneath This design allows for proper heat transfer and solder wicking to the bottom side 3 Itis recommended that the user carefully align and tack one corner of the module then move sequentially around the module 4 The end user layout pads see user s manual for suggested pad layout should extend out slightly from the module to allow a fine tip soldering iron to heat the pad and castellation simultaneously 5 Use a fine point conical tip to heat the modules castellation and board pad simutaneously 6 Apply 020 solder wire to the pad where the2. castellation contacts The solder will wick properly to the underlying surface providing a secure electrical connection Automated Assembly 1 Modules have been designed to be compatable with techniques utilized in an automated process Due to the complexity of the module additional attention is required in comparison to other component types The reflow temperature profile is a critical point for creating a consistant solder connection Any shock that may be applied during the reflow movement process should be avoided If a shock is applied during the liquified state of reflow the components may shift causing malfunction of the module Recommended Soldering Parameters ROHS Compliant Printing Dispensing Reflow Profile Note e Stencil 0 006 inch 6 mil e Ramp 1 0 2 0 C sec to 130 C e Please note that the e Squeegee Metal recommeded Slow ramp from 130 C to 180 C for 90 120 seconds eee ee Ramp 0 5 2 C sec to peak temperature 230 C to and adjustments may 250 C TAL for 40 80 seconds be necessary to Ramp down to R T 1 3 C sec ensure proper wetting of the solder Recommended Soldering Parameters Non ROHS Compliant Printing Dispensing Reflow Profile Note e Stencil 0 006 inch 6 mil e Straight ramp up profile preferred e Please note that the e Squeegee Metal recommeded Ramp up from ambient temp to peak temp of 210 C to reflow profiles listed 225 C 1 C sec are guidelines only ee and adjustment
3. s may TAL Time Above Liquidus 45 to 75 seconds be necessary to Ramp down to R T 1 3 C sec ensure proper wetting of the solder 2 Sah Washibility 1 If modules are assembled with a water soluble process special attention to cleaning will be nessesary All flux residue should be removed to ensure performance as well as reduce the potential of corrosive activity Modules which have been washed must be completely dry before power up or testing Ultrasonic cleaning systems should not be used Proper support during wash is nessesary to eliminate any mechanical stress which could damage components on the module Gi a D The information contained herein is based on data considered accurate and is offered at no charge No warranty is expressed or implied regarding the accuracy of this data Liability is expressly disclaimed for any loss arising from the use of this information
Download Pdf Manuals
Related Search