User manual - ElektrischeBoiler.EU
Contents
1. RCDs with a rated residual operating current not exceeding 30mA shall be provided protection for all the circuits 13 Keep the Towel Rail clean Do not allow any objects to enter any ventilation or exhaust opening as this may cause electric shock fire or damage to the heater 14 Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided 15 CAUTION Some parts of this product can become very hot and cause burns Particular attention has to be given where children and vulnerable people are present 16 WARNING In order to avoid a hazard for very young children this appliance should be installed so that the lowest heated rail is at least 600 mm above the floor 17 The maximum carrying capacity of towel rack is 5 Kg Selection of use site 1 This wall mounted heater should be installed at a proper position 2 It should not be installed near furniture curtains or other electrical appliances 3 It should not be installed at a corner of wall 4 It should be installed far away from doors and windows 5 It should be installed in such way that people who are having a bath or shower cannot touch the switch or controller Installation instruction for a wall mounted heater The installation of the product must conform to the following requirements THIS FITTING MUST BE INSTALLED IN ACCORDANCE WITH IEE REGULATIONS AND BUILDING2. 1 12 Figure 1 13 Figure 1 14 2 3 Not under the time setting mode short press PROG to start or quit reservation function 3 If there is no any operation in 60s the screen will be automatically locked and gn displayed The key will be automatically locked and unlocked by keeping pressing for 3s Daily maintenance and cleaning Wipe the surface of the housing with soft cloth or special cleaning cloth for glass Before cleaning wait for complete cooling of radiator body Do not use the towel rack before drying and after cleaning Troubleshooting Ensure that power supply is connected Ensure that the product is powered In case that the above mentioned ways fail to solve problems please contact the Techni cal Service Recommendation for environmental protection H Do not dispose of electrical appliances as unsorted municipal waste use separate collection facilities Contact your local government for information regarding the collection systems availa ble If electrical appliances are disposed of in landfills or dumps hazardous substances can leak into the groundwater and get into the food chain damaging your health and we ll being When replacing old appliances with new ones the retailer is legally obligated to take back your old appliance for disposals at least free of charge
3. 00A 693 360MM Hang the host machine of heater over the hook fixed on the wall through hook cover on the back of the heater See Figure 1 2 Then screw down the set screws and fix the product and the hook with the 4 set screws See Figure 1 5 Installation instruction for a wall mounted heater Figure 1 5 Description of control panel LCD Screen Program Set Time Power ON OFF Increase Decrease Heating Mode Towel Drying Description of keys 1 Time Set key Keep pressing PROG 3 second to set local time reserved time and reserved working mode Under the setting mode keep pressing PROG 3 second to quit from setting short press it to switch over among local time reserved time and reserved working mode Not under the setting mode short press it to start or quit reservation function 2 Power key After power source is connected press ly to enter standby mode When the heater is operating press ly to enter standby state If the heater is switched off and then powered on again press ly to recover to the working condition before power failure 3 and a At heating mode press or to regulate the range at 1 5 Press it once to increase or reduce 1 range If without any operation the heater will confirm this range The new range will be saved in the machine 1 Under time setting mode press or to set current time Under reser
4. Black Glass Towel Radiator User manual This picture is for reference only Please carefully read this instruction before using the product MODEL ETGS00A jes IP24 GE CE The appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance This appliance can be used by children aged from 8 years and above and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved Children shall not play with the appliance Cleaning and user maintenance shall not be made by children without supervision Children of less than 3 years should be kept away unless continuously supervised Children aged from 3 years and less than 8 years shall only switch on off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved Children aged from 3 years and less than 8 years shall not plug in regul
5. REGULATIONS Inside bath or shower Within 2 25m above bath or shower basin 2 Within 0 6m horizontal from outer edge of the Not sunabie bath or shower Greater than 0 6m horizontal from outer edge l 3 of the bath or shower basin or greater than 2 25m Suitable above Zone 2 s floor Installation instruction for a wall mounted heater THIS FITTING SHOULD BE INSTALLED AT LEAST 0 6M away from A BATHROOM SINK TAP E E AP SE a BPP a BP EE OE a RP I RE BP ER AE AP RE AP E ZONE 2 ZONE 3 J EXTERIOR ZONES see aon Se ap ae A we eowewaee q ZONE 1 b pg lt r 0 60 m 2 40 m HO WEVER IF YOU WISH TO FIT THIS PRODUCT IN A BATHROOM IT IS SUITABLE FOR USING IN ZONE 3 AND OUT SIDE ZONE A S PER THE DIA GRAM ZONE 2 2 25 m ZONE 3 ZONES 1 If to install the product on the wall please keep the distance from the wall surface as shown in the following Figure 1 1 200 mm i Figure 1 1 Figure 1 2 Installation instruction for a wall mounted heater 2 Fix the 2 hooks onto the wall with expansion screws provided in the accessory bag of the product Distance is shown in Figure 1 3 When the installation position is determined make a mark first Drill 4 holes on the wall as shown in Figure 1 4 10 mm p s rr rT 7 rererere oror Figure 1 4 Figure 1 3 Distance marked above corresponds to that of each product as shown in the table ETG5
6. ate and clean the appliance or perform user maintenance Product in the carton Once open the carton pls check everything is complete in the package they are as follows a B 4 F en NAME Book pes psc ips Product specication and model Output DuS tproof and ModeL Po Wer Frequency Rated V oLtaGe Waterproof W Grade Safety and cautions 1 The quality guarantee service excludes damages caused by failure to abide by this instruction 2 The product must be connected to a power supply that conforms to the rated voltage marked on the label of the electrical apparatus 3 The product should not be used near coal gas explosive or flammable and combustible materials 4 W arning In order to avoid overheating do not cover the heater 5 The surface temperature will become higher in operation 6 Warning The heater must not be used if the glass panels are damaged 7 Do not install the heater right below a socket 8 The product should not be connected to power source before maintenance or cleaning is finished 9 The product is only applicable for indoor use 10 If the supply cord is damaged it must be replaced by the manufacturer its service agent or a similarly qualified person in order to avoid a hazard 11 The appliance shall be installed so that switches and other controls cannot be touched by a person in the bath Safety and cautions 12 Residual current protective devices
7. start machine then press 4 to enter towel drying mode The towel rails will heat separately 5 will be displayed and the heater will start operation as shown in Figure 1 7 Or under 4 the heating mode press to enter towel drying mode will be displayed and the heater will start opera tion as shown in Figure 1 8 Figure 1 7 Figure 1 8 2 Timer switch setting 21 Keep pressing PROG for 3s to set the local time The hour digits flicker Press or to regulate the hour Refer to Figure 1 9 Then short press PROG to set the minute digits They flicker Press or to regulate the minute Refer to Figure 1 10 Figure 1 9 Figure 1 10 Operation instruction 2 2 Then short press PROG to set timer Start Press or to increase or de crease the time on the basis of 0 5 h Refer to Figure 1 11 Short press PROG to set working mode press or 3 to set heating mode default full power or towel drying mode which can work separately refer to Figure 1 11 or Figure 1 12 or together refer to Figure 1 13 Then short press PROG to set timer End Press or to increase or decrease the time on the basis of 0 5h Refer to Figure 1 14 The available setting range from 00 00 to 24 00 Keep pressing PROG 3 seconds to quit from the setting mode and work as the setting mode Figure 1 11 Figure
8. vation mode press or to regulate the start time and end time for operation 3 Key locking unlocking If without any operation in 60s the screen will be auto matically locked and guy displayed The key will be automatically locked and will be unlocked by keeping pressing key for 3s Ms 4 Short press 3 to enter heating mode Under heating mode 4g press this key to quit from this mode 5 Short press to enter towel drying mode Under towel drying mode press the key to quit from the mode or is invalid under towel drying mode u u TE NOTE In Reservation Mode the product works to the scheduled function if you need to change the function you must first exit the Reservation Mode LCD DISPLAY Key Locking Heating Mode Power Range Towel Drying Mode Time Reservation Mode Reserved Time End Reserved Time Start Operation instruction 1 Power Press power key Then the power indicator will be illuminated and the heater will enter the standby state Ms 1 1 1 Press dy to start machine press to enter heating mode Then and amm will be displayed _ gg gf default is range 5 as shown in Figure 1 6 Press or to regulate the range Press or to increase or decrease for 1 range Range 1 is the lowest Figure 1 6 Operation instruction 1 2 Press to
Download Pdf Manuals
Related Search