User Manual - Heattend Products
Contents
1. b Press and hold down min 5secs the ON OFF PROG button in order to go to the manual Programming mode PRO Pra c Press the ON OFF PROG button d Select the day by using the and buttons and press the ex button to validate e Adjust the time by using the and gt buttons and press the button to validate The validation causes the heater to return to the shutdown position ducasa Temperature Compensation Due to the characteristics of the radiator the control unit has to read the temperature measurement from the lower part of the apparatus but it is automatically adjusted in relation to the comfort temperature setting However it is possible to manually adjust this Thermic Compensation Room temperature recorded by an ambient thermometer minus Comfort setting temperature displayed on the control panel screen compensation value 1 Put the thermostat in the OFF mode by pressing the ON OFF PROG button 2 Press and hold down the button until the 0 0 is displayed on the screen 3 Press the and buttons to enter the adjustment in increments of 0 1 C 4 Press the button to return to the OFF mode 5 Reset the radiator to the mode required Example e A temperature 22 C is measured in a room with a thermometer while the value of the required Comfort temperature on the thermostat 20 C The setting for the compensation is therefore 22 20 2 C In the tem2. anti tamper facility Overheat protection Connectable to a central programming system by pilot wire if required Programmable by infrared control Ducasa Remote optional 1 IMPORTANT INFORMATION See Section Installation Instructions Location of Heater for important notes regarding the siting of the appliance Due to the surfaces of the heater becoming hot it must not be positioned directly against or below infammable surfaces Do not dry clothes or towels on the heater nor leave fabrics magazines spray cans volatile substances or similar objects within 250mm of the heater In case of breakdown or damage turn off the appliance at the main On Off switch and notify the supplier If the electricity cable gets damaged it must only be replaced by a technician appointed by the supplier This will avoid possible risks and ensure that special tools are available if needed This appliance is not intended to be used by persons incl children with limited physical sensory or mental capabilities or who lack experience except for those under supervision or have received instruction in the use of the appliance from a person responsible for their security Children must be supervised in order to ensure that they do not play with the appliance WARNING In order to prevent overheating do not cover this appliance There has to be free movement of air around all surfaces of the appliance This symbol DO NOT COVER is plac
3. ducasa The Vitro Radiant Convector Combination Heater Instructions for Operation and Installation Read these instructions carefully and retain for further reference Models VITRO 750 Black VITRO 1200 Black VITRO 1600 Black VITRO 750 White VITRO 1200 White VITRO 1600 White NOTE A qualified electrician must carry out the electrical installation of this radiator The Electrical installation must comply with current UK regulations Any claim on the warranty could be invalid if these requirements have not been met 4 C24 05 13 GENERAL INFORMATION The Ducasa Vitro glass fronted designer heater provides a combination of radiant and convected heat and will grace any home With touch sensitive adjustment and LCD display the Vitro can be used as a stand alone heater as a part of a zoned pilot wire system optional or programmed via the Ducasa remote controller optional Luxurious design with glass front panel Black or White Double heating circuit aluminium heater for convection heating and heating circuit on glass for radiant heat Designed and fabricated in accordance with EN60335 1 and EN 60335 2 30 NEC Class Il The radiator requires a 230 240V 50Hz power supply and is a double insulated product so does not require an earth cable Wall mounted by quick fixing system On off main switch Electronic digital thermostat with LCD screen Standby Comfort and Anti frost settings 2 Hour Turbo Mode Keypad locking
4. ed on the heater as a reminder to the user ducasa 2 TECHNICAL DATA MODEL 1200 1600 230V 1h IS0R2 670x500x110 840x500x110 1000x500x110 CLASS ERA ESSE AS E 3 INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTION A qualifed electrician must carry out the electrical installation of this radiator The electrical installation must comply with the current UK regulations Any claim on the warranty could be invalid if these requirements have not been met The radiator requires a 230 240V 50Hz power supply and is a double insulated product so does not require an earth cable CONNECTING WIRES L Live Brown N Neutral Blue FP Pilot Wire Black if required for external programmer IF PILOT WIRE IS NOT REQUIRED INSULATE BLACK CABLE TO ENSURE IT DOES NOT COME INTO CONTACT WITH ANY OTHERS WIRES OR TERMINALS The connecting wires must be of the appropriate section in regards to the length of cable type of cable and power rating of the apparatus The apparatus must be connected into a connecting box We recommend that the connecting box is positioned 10cm to the right of the apparatus and at 15cm above the floor According to regulations the apparatus must be connected to the power supply by means of an all pole circuit breaker with a contact gap of at least 3mm or by a thermal magnetic circuit breaker LOCATION The ideal place to site the Ducasa radiator is as close as possible to coolest wall in the room but it is n
5. h an abrasive product or those containing granular substances We recommend regular cleaning with PH neutral products In order to clean the radiator it is recommended that the electric power is switched off GUARANTEE Your appliance is guaranteed for two years from the date of purchase during this period we will repair or exchange at our discretion any faulty or defective parts providing the appliance has been used in accordance with the operating amp installation instructions and has not been misused or mistreated in any way Any unauthorised repair or attempted repair will invalidate the guarantee This guarantee is additional to your statutory rights In the unlikely event of a problem with your appliance please contact your supplier E ducasa UK Distributor of Ducasa Products Heattend Products Ltd Web www heattend co uk Email enquiries heattend co uk
6. oles for the top fixing screws See Figure 3b Drill and plug for these screws In this manner the Vitro heater will be mounted on the wall with 205mm between the floor and the bottom of the appliance 3 When the support frame is fixed to the wall mount the heater by first attaching the lower bracket and then the top ensuring the clip clicks into the heater See Fig 2 figure 3a 4 OPERATING INSTRUCTIONS Switching on Once the appliance has been mounted on the wall and correctly connected to the electrical supply network switch on the heater by pressing the ON OFF button situated at the rear of the appliance ducasa UPPER CONTROL Programme time m oo TEE Days of the week an C Dm Heating indicator Operating mode increase decrease Mode OK ON OFF PROG ducasa SWITCHING ON Once the radiator has been mounted on the wall and connected to the main electricity power supply press the main On Off switch Now press the ON OFF PROG switch on the control panel When you switch on the radiator the microprocessor reads the memory in the control unit in order to load the last selected mode When switched on for the first time the memory is empty and the display will flash constantly until you set the Comfort temperature During use the control panel will display the temperature and the current operating mode set by the user The symbol M will indicate that the heating element is in ope
7. ot recommended to site the radiator on un insulated exterior walls in this case the part of the wall behind the radiator should be insulated In bathrooms the radiators must not be sited inside the protected area The control unit switches must not be reachable directly or indirectly by a person in the bath or shower The radiator under no circumstances should be installed below an electric power point Choose the location of the radiator in respect of the minimum distances that are indicated below figure 2 150 Z yu ducasa Mounting the Heater In order to mount the appliance on a wall it is necessary to first secure the support frame supplied with the appliance to the wall Remove the support frame attached to the rear part of the appliance To do this first press the two upper clips of the support frame in order to release the frame from the upper rear part ofthe appliance and then withdraw the lower part of the support frame See Figure 2 Place the support frame in a horizontal position against the wall and mark the location of the screw holes as detailed below and shown in the Figures 3a and 3b below 1 Stand the support frame on the floor lean it against the wall and mark through the top holes as shown in Figure 3a Remove the support frame and drill and plug the wall for the fixing screws 2 Attach the support frame to the wall by means of screws in the lower slotted holes and mark through the upper slotted h
8. perature compensation mode the user should put in 2 C Keypad Locking Anti Tamper The keypad can be locked to prevent any unauthorised person children people in public places nurseries offices hotels etc altering the settings and programming in the control unit To lock the keypad depress and hold the and buttons at the same time The screen will flash now validate by pressing ducasa Waste Electrical amp Electronic Equipment Applicable in the European Union and other European countries with separate collection systems This marking shown on the product or its literature indicates that it should not be disposed of with other household wastes at the end of its working life To prevent possible harm to the environment or human health from uncontrolled waste disposal please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources Household users should contact either the retailer where they purchased this product or their local government office for details of where and how they can take this item for environmentally safe recycling Business users should contact their supplier and check the terms and conditions of the purchase contract This product should not be mixed with other commercial wastes for disposal MAINTENANCE AND CARE Ducasa radiators require very little maintenance The surfaces of the radiator must not be cleaned wit
9. ration Setting The Comfort and Economy Temperature To set the comfort or economy temperatures the heater must be in the relevant mode i e select economy mode to set economy temperature and comfort mode for comfort temperature When the mode is selected pressing the and buttons will increase decrease the comfort temperature in increments of 1 C Pressing and holding down either button will rapidly change the setting in increments of 1 C release the button when the desired temperature is reached Once the required temperature has been entered and there is no further use of the and buttons the control unit will automatically memorise the selected temperature Selection Of Mode Press the Mode OK button to select the operating mode By each press of the button the thermostat moves from one mode to another mode Comfort Economy and Programming Pro In order to access the frost protection mode press and hold down the button Mode OK until the corresponding icon is displayed on the screen MODE DESCRIPTION Select comfort temperature with the button COMFORT Radiator will heat room to required comfort temperature until manually switched off Select economy temperature with the button ECONOMY Radiator will heat room to required economy temperature until manually switched off Heater will operate at the times and modes set in the programme PROGRAMME see Programming instructions or use optional D
10. ucasa handheld controller i e comfort economy or frost protection FROST o PROTECTION Radiator operates when temperature is less than 7 C OFF Radiator switched off ducasa a Start with the screen displaying the symbol or clock hour minutes OFF mode b Press and hold down min 5secs the ON OFF PROG button in order to go to the manual Programming mode Pro c Select the operating mode hour by hour by pressing the button and then the Mode OK button to validate COMFORT ECONOMY lt PROGRAMMATION YE Cc Pro Als a HI Top segments Comfort A Bottom segments Economy 14 gt No segements Frost protection ok De I O 54 Days of the week 74 d Repeat the operation for each hour of each day ofthe week At the end of programming day 7 the parameters are automatically saved and the display changes to the hour adjustment mode to make sure that the time is valid Adjust the time if necessary or validate to return to the OFF mode e To move the programming timetables use the decrease button This enables you to move the time usage without changing the programming Pressing and holding down this button accelerates the process f To return to the Comfort or Economy modes press the Mode OK button Setting The Time a Make sure that the thermostat is in the shutdown position or press ON OFF PROG in order to go to the shutdown position
Download Pdf Manuals
Related Search