Manual
Contents
1. High performance multicopters for rc enthusiasts WALT PALA Y USER MANUAL Due to continuing improvements actual product may differ slightly from the product described herein Thank you for purchasing a mini fairy It is important that you read the entire manual to become familiar with the unit befor you begin to fly Save the receipt warranty and these instructions The Meaning Of Symbols And Signal Words Mishandling Due To Failure To Follow These Instructions WARNING May Result In Severe Injury Or Death Mishandling Due To Failure To Follow These Instructions CAUTION May Result In Serious Harm S FORBIDDEN Do Not Attempt Under Any Circumstances IMPORTANT NOTES This copter is suitable for people of 8 years and older it is not a toy Please read this manual thoroughly before using and make sure to be conscious of your own personal safety and the safety of others and your environment when operation or the use of this copter Manufacturer and seller assume no liability for the operation or the use of this model Intended for use only by adults with experience flying remote control helicopters at a legal flying field After the sale of this product we can not maintain any control over its operation or usage Safety notes Before Flyign Your copter Check for damaged parts and assembly Before using any product any part that appears damaged should be carefully checked to determine that it will operate2. properly and perform its intended function Check for any broken or damaged parts and any other conditions that may affect its operation Replace or repair damaged or worn parts immediately Do not trim the copter s antenna Trimming the antenna will affect radio range It is mandatory to check all control systems and mechanical linkages for proper operation before every flight 1 Consider The Circumstances Of The Surrounding Area Select a flying field where there are not too much debris Do not fly the copter in strong winds rain Do not fly near crowd high voltage cables railways to ensure the safety Flyer Do not let children use the copter without adult supervision Failure to do so could result in personal injury and or property damage Do not let menstruating or pregnant wonen fly this copter Do not fly under tired condiction and improper operation may cause in danger If you are a novice pilot we strongly suggest that you should find an experienced pilot in R C model to assist you Recommend you to practice with computer based flight sim mulator While In Flight Keep Away From The Rotating Blades Do not touch the copter when the propellers were running keep it away from other things to avoid danger and damage When operating do not get too much close to the copter Operate the model within the limits of your ability Operating the modle improperly increase the risk of accidents or injury After
3. stick you can get the to complete radical flip maneuvers in any direction 6 Replacing Damaged Blades Two of the nini fairy rotors turn clockwise in B Counter Clockwise red A Clockwise black flight A and two turn counter clockwise B The spair parts includ 1pair red color rotors and 1 pair black rotors same as black color rotors one of the red color rotor turns clockwise and the other one turns counter clockwise If one of the rotor blades is damaged please replace wiht suitable type rotor color and turning direction A Clockwise red B Counter Clockwise black Warnings The control distance will be reduced if the mini fairy or transmitter is not fully charged If the mini fairy becomes damaged please stop using it immediately Remove all batteries from the transmitter when not using it for more than a few days Do not touch the motor during or after flights as it will become hot Make sure your surrounding area is free of all obstacles before flying Not suitable for under 8 years old Children should be accompanied by adults at all times If replacement blades are to be attached to the mini fairy care must be given to make sure they are put on the correct way round Do not dispose of any part of this product in the normal rubbish bin All parts should be taken to your local recycling centre CAUTION A WARNING pordgese e High speed propellers never touch propell
4. with this product Never leave battery unattended while charging 4 Preparing to fly 1 Put the throttle in the lowest position and turn on the transmitter 2 Connect the li po battery to your mini fairy as image shown the indicator lights on the circult board will flash rapidly this indicate the receiver go into auto detection mode place the copter at a level position 3 Push the throttle to the highest position then put it back to the lowest position a beep will sound from the transmitter and the indicator lights on hte circult board will stop flashing LED ON or flash about once per second LED OFF it means the mini fairy is ready to fly 4 Push the trottle forward slowly the copter will take off 1 Keep small parts out of the reach of children to avoid choking hazard 2 After flight disconnect the li po battery from the copter first then turn off the transmitter 3 Always turn off the power of the transmitter and the copter when not in use Transmitter Fuctions Left Hand Throttle Speed select ONS Throttle Rudder mode1 pe LED on or off Control model Elevator Aileron mode1 Throttle Aileron mode2 Elevator Rudder mode2 Sub Trim D Sub Trim C Sub Trim A Sub Trim B LCD screen Power Switch 1 The transmitter can be used in 2 modes the pre setting is mode 1 Press and hold the Controls Mode switch until beep sounds to toggle between mode1 and mode 2 2 Action sen
5. a Flight Conduct a thorough inspection Wipe away any dirt or water Remove batteries if the copter is not used for a long period of time Maintain products with care Keep the copter in a dry location Do not expose it to prolonged moisture Generally R C models are mainly made up of PVC or polythene please put it away from the heat source to avoid distortion and melting caused by high emperature Batteries Use only batteries of the type recommended and do not mix old and new batteries Do not incinerate batteries Batteries may burst causing personal injury and or property damage Do not recharge non rechargeable batteries Don t strike or throw the battery against any hard surface Don t immerse the battery in water and keep the battery in a cool dry place Don t over charge the battery Don t transport or store the battery together with metal object Never charge the battery for more than one hour Note ss Never leave charging battery unattended Always dispose of old batteries responsibly The warnings cautions and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur It must be understood by the operator that common sense and caution are factors which cannot be built into this product but must be supplied by the operator Packing lis Li Po battery USB cable red propellers black propellers 1 pair cw and ccw 1pair cw and ccw Specificatio
6. er CHOKING HAZARD Small parts EC C X E leua Not for children under 3 years MADE IN CHINA e Adult supervision is highly recommended e Do not fly in strong wind e Do not fly near crowd high voltage cables or trees
7. ns Span 149mm Height 31mm Propeller 55 5mm Motor 7 20mm coreless motor Battery 3 7V 250mAH Li Po for mini fairy 4 1 5V AA battry for transmitter not included RC system 2 4GHz 4CH radio control system Flying Weight Approx 35g Recharging time Approx 30 minutes with fully discharged Flying time Approx 8 minutes with fully charged Radio control range over 200 meters user manual transmitter 2 Battery Installation amp Charging Batteries installation Battery cover 4 X 1 5V AA batteries 1 Remove the battery cover on the back of the transmitter insert 4 pieces of 1 5V AA battery not included according to indicated polarity as shown image A 2 After turning on the transmitter power install the li po battery to the fuselage and connect the battery to the copter Charging with computer 1 Connect the Li Po battery to the USB Cable then connect the USB cable to an computer USB port to charge the battery If the indecator light on the USB cable stop flashing it means the battery is being charged and if the indecator light on the USB cable flash rapidly it means the battery is fully charged Charging with wall adaptor Optional 1 Also you can charge the Li Po battery with an optional wall adaptor as shown image Battery charging should be done under adult supervision only Use only the included USB cable and wall charger optional
8. sitivity selectable Speed selectable There are three different programmed speeds can be selected Toggle though these three speed settings using the Speed Selector button Press to hear one beep for low speed two beeps for mid speed three beeps for high speed 5 3 Auto Trim fuction Turn on the trasmitter while pushing the Auto Trim button all the Sub trim will come to the center position Right Hand Throttle Speed select Auto Trim Elevator Rudder mode N LED on or off Control model Throttle Aileron mode 1 Elevator Aileron mode2 Throttle Rudder mode2 Sub Trim A Sub Trim D Sub Trim B Sub Trim C LCD screen Power Switch Rudder control stick o p I I 77 N I 1 I 1 1 I k Turn left Turn right Push the rudder control Push the rudder control Push the aileron control Push the aileron control stick to right stick to left stick to left stick to right Push the throttle stick forward Push the throttle stick downward t Forward Backward Push the Elevator stick forward Push the Elevator stick downward T 7 Radical Flips amp Rolls VA oe Once you ve mastered the basic control over theflying f A you can progress and start to do incredible flips amp rolls ee Using Speed Select set to high speed signaled by 3 beeps Fly themini fairy at about3 meters 9 feet and X hover steadily then with a quick push on the side flight N direction
Download Pdf Manuals
Related Search