Untitled - Farnell
Contents
1. In addition to the wireless microphone a cable connected microphone may be used Connect the microphone to the jack MIC IN 7 2 Audio units with a line output e g CD player cassette recorder MP3 player or laptop can be connected to the jack AUX IN 8 A cable connected microphone and an audio unit should only be connected at the same time if the output level can be adjusted on the audio unit otherwise the volume ratio between the microphone and the audio unit cannot be altered 3 For sound recordings connect a recorder to the jack MIX OUT 9 The output level is independent of the position of the control MAIN VOL 11 4 For PA applications of larger zones connect an additional PULSE PA 40 to the jack MIX OUT 9 More units can then be daisy chained from the mix out of the second unit etc 5 Operation 1 Switch on the unit with the on off switch and volume control MAIN VOL 11 During operation the red LED LO BAT 12 will light up If it the light flashes recharge the battery as per chapter 4 1 2 If a microphone is connected to the jack MIC IN 7 or a unit to the jack AUX IN 8 adjust the desired volume with the control MAIN VOL 3 If a wireless microphone or a beltpack transmitter is used switch on the receiver with the on off switch and volume control VOL 3 The red LED PW 5 will light up 4 Leave the wireless microphone or the pocket transmitter switched off for the time being and use the rotary switch 4 to2. part is switched on 6 Green reception LED RF will light up when a suitable transmitter is switched on and set to the radio frequency of the receiver 7 Microphone input MIC IN 6 35 mm jack unbalanced 8 Input AUX IN 3 5 mm jack unbalanced to connect a unit with line output e g CD player cassette recorder MP3 Player or laptop 9 Output MIX OUT 3 5 mm jack unbalanced to connect another active speaker system or an audio recorder The output level is independent of the control MAIN VOL 11 10 TONE control 11 On off switch for the unit and control for the total volume 12 Red LED LO BAT will light continuously when the unit is switched on and the battery is still sufficiently charged will flash when the battery must be recharged Applications and Accessories The PULSE PA 40 combines a speaker system an amplifier and UHF wireless receiver for a wireless microphone or a pocket transmitter handheld UHF microphone supplied An additional microphone pack containing UHF beltpack headset microphone and lavalier tie clip microphone is also available please order PA 40 BP LAV from your local PULSE dealer Power is supplied from a mains socket via the power supply unit provided or via the integrated rechargeable battery which allows mains independent operation the system has an internal charging circuit for recharging the battery To cover larger areas amp crowds several PULSE PA 40 systems can be set up to recei
3. 7 863 800 MHz 15 864 800 MHz Dimensions 160 x 210 x 290mm 8 863 925 MHz 16 864 925 MHz Weight 4 2kg Service All PULSE products are thoroughly examined and tested before leaving the factory and if used correctly will give many years of excellent service However if a problem arises proceed as follows A Contact the retailer from whom the unit was purchased and describe the symptoms of the fault B If the retailer cannot help return the equipment to the national distributor for your country Use the original packaging to protect the product from damage Include a note with the equipment stating your name and address details of the problem date code and date and place of purchase The unit does not contain any user serviceable parts For details of spares accessories and other products contact you local retailer In the event of any difficulty contact PULSE directly via www pulse audio co uk
4. PULSE PA 40 Portable PA System User Instructions Ea m F E ceossio Ra TTE ROHS SAVE THESE INSTRUCTIONS Unpacking and Inspection Carefully unpack the unit If it appears damaged in any way return it to the retailer it was purchased from in its original packaging PULSE cannot accept any responsibility for damage arising from the use of non approved packaging INTRODUCTION The PULSE PA 40 is a fully featured portable PA system designed to provide high quality audio reproduction reliable performance and many years of service MAIN FEATURES Ultra compact and very powerful this little PA System from PULSE will grab the attention of any crowd and ensure your message can be heard Ideal for all uses from bingo to education conference to outdoor events Supplied complete with a handheld wireless microphone internal sealed lead acid battery shoulder carry strap and carry case e 40Wrms power output e Compact amp powerful e UHF wireless receiver built in with 16 selectable frequencies for clear interference free wireless reception e Up to 8 hours operation from a 4 5 hour charge e AUX input for line level sources e g Laptop or MP3 e MIX output allows secondary units to be linked e Master tone control e Independent microphone and master volumes e Mesh front panel on carry case allows operation of the unit from within carry case e Supplied complete with a handheld
5. on the operating instructions or as marked on the product Always ensure that a good quality mains lead is used applicable for your country The following wiring convention is used in all product mains leads and must be strictly observed Green amp Yellow Earth Brown Live Blue Neutral IMPORTANT THIS UNIT MUST BE EARTHED 8 If the mains fuse need replacing DISCONNECT THE PRODUCT FROM THE MAINS SUPPLY The fuse is located in the 13A plug of the mains cord and must be replaced with a fuse of the type and rating stated on the rear panel If a replacement fuse fails immediately contact your local service agent DO NOT replace with a higher value 9 The power supply cord of the product should be unplugged from the outlet when left unused for a long period of time When unplugging the power supply cord DO NOT pull on the cord but grasp it by the plug 10 Ensure the mains isolation switch is readily accessible when the product is in use 11 Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings 12 The product should be serviced by qualified service personnel when A The power supply cord or the plug has been damaged or B Object have fallen or liquid has been spilled into the product or C The product has been exposed to rain or D The product does not appear to operate normally or exhibits a marked change in performance or E The product has been dropped or the enclos
6. select a channel which is free and interference free If the green LED RF 6 lights up after the channel has been selected and with the microphone or transmitter still switched off interference or signals of other transmitters are received on this channel In this case set the receiver to a different channel 5 Switch on the wireless microphone or the pocket transmitter and set it to the same channel as the receiver The green LED RF 6 will light up to indicate reception of a radio signal 6 If a microphone is connected to the jack MIC IN 7 or a unit to the jack AUX IN 8 use the control VOL 3 to add the microphone signal received If the wireless microphone or the pocket transmitter is used on its own advance the control VOL 3 to approx 2 3 and adjust the volume with the control MAIN VOL 11 7 Adjust the sound with the TONE control 10 Specifications Received frequencies Output Power 50W Max 40Wrms Channel Frequency Channel Frequency RF Frequency 863 865MHz 16 Channels RF Range approx 30m 1 863 050 MHz 9 864 050 MHz 2 863175MHz 10 864 175 mre Microphone MIGUN my 3 863 300 MHz 11 864 300 MHz Line input AUX IN _ 100mV Output MIX OUT 560mV 4 863 425 MHz 12 864 425 MHz Audio Frequency 60Hz 15kHz 3 dB 5 863 550 MHz 13 864 550 MHz Ue ee ee 6 863 675 MHz 14 864 675 MHz Power supply 12 V 2 9 Ah or power supply unit supplied Input voltage 100 240 V 50 60Hz 180 VA
7. tched on 5 After operating or after recharging the battery disconnect the power supply unit from the mains socket to prevent unnecessary power consumption Notes 1 If the active speaker system is not used for a longer period the battery should be fully recharged every 2 3 weeks to ensure a long battery life 2 As the rechargeable battery is subject to normal aging the battery is classed as a consumable item and covered by a 90 day warranty from point of sale 3 The charging circuit is matched to the type of integrated rechargeable battery Replace a defective battery by one of the same type only see specifications Failure to do so will result in damage to the unit and the battery 4 2 Positioning amp Transporting For optimum setup the system is best mounted on a stand at a height of 1 1 5 m above the ground An optional stand PA 40 STAND can be purchased from your local PULSE dealer For mobile use e g guided tours or outdoor events the shoulder strap or the shoulder bag supplied can be used Fasten the strap to the eyes 1 For operation inside the shoulder bag put the active speaker system into the bag in such a way that the sound from the speaker will be radiated through the mesh side To access the operating elements and connections open the lateral flap of the bag Velcro fastener 4 3 Connections for Microphones amp Audio Sources Always switch off the active speaker system before connecting 1
8. ure damaged 13 DO NOT attempt to service the product beyond that described in the user maintenance instructions All other servicing should be referred to qualified service personnel 14 WARNING DO NOT place objects on the product s power cord or place it in a position where anyone could trip over walk on or roll anything over it DO NOT allow the product to rest on or to be installed over power cords of any type Improper installations of this type create the possibility of fire hazard and or personal injury IF YOUR PRODUCT STOPS WORKING READ THE MANUAL III Turn volume to zero and re adjust each control in Check all connections input and output at both ends of cable Check status lights battery charge and power connections Disconnect from mains before changing fuse Replace fuse only with same type and rating If problems persist contact a qualified service agent OPERATION amp CONNECTIONS VOL 31 1 O El MAX OF a 4 CH 9 1 7 5 3 VVIRELESS 5 _ i PVVO MIC 6 RFO TONE MAIN VOL AUX MIX IN OUT fone Ee PS eee LO CG DCIN BAT NS E Ee m 7 8 10 11 12 13 14 1 Eyes for fastening the shoulder strap 2 Cover of the battery compartment 3 On off switch for the corresponding receiving part and volume control for the microphone signal 4 Channel selector switch 5 Red power LED PW will light up when the receiving
9. ve and reproduce the signal of one single wireless microphone To do this set all units to the same UHF frequency and adjust volume controls accordingly It is also possible to connect the PA 40 to external powered speaker systems via the audio output MIX OUT The system is supplied with a practical shoulder bag and a shoulder strap 4 Operating the System 4 1 Power supply recharging the battery 1 For operating the active speaker system via a mains socket and or for recharging the internal battery connect the power supply unit supplied to the jack DC IN 14 and connect it via the mains cable supplied to a mains socket 100 240 V 50 60H2 If the power supply unit is connected to the mains socket the green power LED will light up on the power supply unit 2 As soon as the power supply unit supplies power to the active speaker system the battery will be recharged The green charging LED CG 13 will flash For charging it is not necessary to switch on the unit with the switch and volume control MAIN VOL 11 however the unit can be used as usual during the charging process 3 When the battery has been fully charged the charging LED CG will light continuously In this case a mains independent operating time of approx 3 hours at maximum volume will be possible if used at lower volumes run times of up to 8 hours can be achieved 4 The battery should be recharged when the red LED LO BAT 12 starts flashing while the unit is swi
10. wireless microphone internal sealed lead acid battery switch mode charger amp mains cord shoulder carry strap and carry case e Optional tripod stand PA 40 STAND raises the unit off the floor allowing the sound to travel further e Optional Microphone Kit PA 40 BP LAV available as a separate item contains a UHF beltpack headset and lavalier microphones to provide a flexible system for most uses e Weight 3 1kg IMPORTANT SAFETY INSTRUCTIONS WARNING When using electrical products basic precautions should always be followed including the following 1 Read all the SAFETY INSTRUCTIONS before using the product 2 To reduce the risk of injury close supervision is necessary when the product is used near children 3 Do not use this product near water for example near a bathtub vvashbovvi in a wet environment or near a swimming pool 4 This product is capable of producing sound levels that could cause permanent hearing loss DO NOT operate for a long period of time at high volume or at a level that is uncomfortable If you experience any hearing loss or ringing in the ears you should consult an audiologist 5 This product should be located so that its location or position does not interfere with its proper ventilation 6 This product should be located away from heat sources such as radiators heat registers or other products that produce heat 7 The product should be connected to a power supply only of the type described
Download Pdf Manuals
Related Search