user manual - Stark Power
Contents
1. StarkPower does not assume responsibility for any loss or damage incurred during shipment or as a result of a force majeure StarkPower is not liable for any incidental or consequential damages arising from the use or misuse of this product 6 All warranty claims are limited to repair or replacement of the defective product and at the sole discretion of StarkPower 7 f StarkPower repairs or replaces the product warranty coverage will begin when the new product is shipped Repair or replacement may involve the use of reconditioned units which are equivalent in function and performance Ce Fe L Eh e Applied Standard GB T 18287 20002. 9 Always use care when using the JumpBox6 The JumpBox 6 is not intended for use by anyone requiring supervision Do not use the JumpBox6 as a toy Do not allow the JumpBox6 to become wet Do not immerse the JumpBox6 in water Do not operate the JumpBox6 in explosive environments where flammable liquids gases or dust may be present Do not modify or disassemble the JumpBox6 Do not expose the JumpBox6 to heat sources Do not store the JumpBox6 in locations where temperatures may exceed 50 C or 122F Charge only at ambient temperatures between 0 C to 50 or 32F to 122F Only use the charger provided with the JumpBox6 When disposing of the JumpBox6 use approved recycling facilities in your area Do not discard in the trash I WARRANTY INFORMATION StarkPower offers a limited warranty for this product against any defects in material and workmanship for a period of 6 months from the date of purchase by the end user consumer The conditions of the warranty are as follows 1 The warranty is only valid upon presentation of the original receipt from dealer retailer by the original purchaser with the product to be repaired or replaced 2 The warranty is void if the serial number date of purchase and label have been removed 3 The warranty does not cover damage or product failure resulting from abnormal wear and tear physical abuse improper installation misuse modification or repairs by unauthorized third parties
3. STARKPOWER Thank you for choosing the JumpBox6 Always follow basic safety precautions when using the Jump Box Read all instructions carefully Please keep this instruction manual for as a reference Model SP 12V6 JEP NOTICE FOR 12VDC SYSTEMS ONLY A Product Layout battery indicator light es ee ee 12V1A Input Port S ON j Switch of battery indicator light eae Battery clamps B Technical Specifications Dimension 180 70 35mm 7 08 2 75 1 38 Weight 6909 1521 Battery capacity 2 1AR S Output O O AN Input S VA O Full charging time approximately 4h Starting current 300A Peak current 600A Operating temperature 20 C to 60 C 4F to 140 F Lifetime gt 500 cycles C Parts list 1 Jump Box 2 100V 240 VAC charger 3 User manual D Indicator Instruction Press the switch and check the battery charge level according to the color of indicator Charge level Low Battery Full E Charging the JumpBox 6 Use the JumpBox6 charger provided with the unit when the indicator is YELLOW or RED 1 Plug the charger into the 115 VAC wall outlet 2 Connect the charger s connector to the input port on JumpBox6 F JumpBox6 vehicle instruction Follow the instructions shown bellow when your vehicle can t start because of a weak battery Press the switch and check the state of charge making sure the light is GREEN or YELLOW Connect the RED clam
4. p to the vehicle s battery positive terminal then connect the BLACK clamp to the vehicle s battery negative terminal Start the vehicle When the vehicle starts immediately disconnect RED and BLACK clamps from the vehicle s battery terminals NOTE In extremely cold temperatures the JumpBox6 may require a couple of attempts to warm up the unit Io SIART G Warnings 1 DO NOT start if the indicator light on the JumpBox6 is RED 2 DO NOT connect the clamps to the wrong terminal Improper connection will damage the JumpBox6 and the vehicle s battery 3 Always check if the jumper clamps are well connected Be aware that dirty or corroded cable terminals in the vehicle may limit or inhibit starting performance If in doubt seek professional technical assistance DO NOT attempt to start your vehicle more that 3 times or the JumBox6 may be damaged Let the unit rest for 5 minutes before attempting to restart your vehicle Always charge the JumpBox6 when the indicator is RED DO NOT connect or touch RED and Black clamps together as this action may cause FIRE DO NOT disassemble the JumpBox6 H TOXIC AND HARMFUL SUBSTANCES Composition and level of toxic and harmful substances in the JumpBox6 Pb Hg Cd Cr Vi PBB O O O O O O O Indicates that all hazardous materials are below the MCV limit specified in the Standard 2002 95 EC RoHs 99 OO DOPO 0
Download Pdf Manuals
Related Search