user`s manual - Standby - Xtreme Power Conversion
Contents
1. on of the UPS F Remove some of the load from the The UPS is overloaded Alarm continuously sounds when output of the UPS the AC input is normal UPS fault Return the unit for service Battenrdetaet Replace the aaah with the same Alarm sounds every 2 seconds type of battery when the AC input is normal Charging circuit is damaged Return the unit for service Remove some of the load from the output of the UPS When power fails backup time is shorter than expected Battery voltage is too low Charge the UPS at least 8 hours Batten defect Replace the battery with the same type of battery Reconnect the input power cord The UPS is overloaded The AC input is normal but the blue LED is flashing properly Power cord is loose i eeee S Xtreme Power Conversion Corporation Rev 8 29 13 Page 7 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS SPECIFICATIONS Soovnae0W 230 VAC 180 270 VAC 50 Hz O D ge D o e lt Voltage Range Frequency Voltage AC mode Voltage bat mode same as input 230 VAC 10 Transfer Time 2 6 ms typical Simulated Sine Wave Up to 38 min Up to 68 min Up to 87 min Charging Time 8 hours to 90 capacity Protection Overcharge discharge short circuit and thermal 82 5 x 228 x 207 mm 3 2 x 8 9 x 8 1 in in vertical stand position 2 2 kg 4 8 Ibs 2 7 kg 5 9 Ibs 3 1 kg 6 8 Ibs Input Cord IEC 1 5m with Schuko Plug o aoc 62060 Attitude 3500 m 11 5002. CT REME Power Conversion UNINTERRUPTIBLE POWER SUPPLY UPS XSTi Standby UPS 400VA 800VA 800VA Models USER amp INSTALLATION MANUAL WWW XpPCC COM 2013 Xtreme Power Conversion Corporation All rights reserved XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS PACKAGE CONTENTS You should be receiving the following items inside the package e UPS Unit e User Manual e Local Monitoring Software CD XSTi 600 800 models e USB cable XSTi 600 800 models PRODUCT INTRODUCTION Thank you for selecting this uninterruptible power supply UPS It provides you with protection for connected equipment Please read this manual before installing the XSTi Series UPS models XSTi 400 XSTi 600 and XSTi 800 as it provides important information that should be followed during installation and maintenance of the UPS and batteries allowing you to correctly set up your system for the maximum safety and performance Included is information on customer support and service if it is required If you experience a problem with the UPS please refer to the Troubleshooting section in this manual to correct the problem If the problem is not corrected please collect information so that the Technical Support personnel can more effectively assist you PRODUCT OVERVIEW The XSTi Series UPS provides comprehensive protection in a small and economical package This UPS is compact offering greater power The XSTi has been designed with a mi
3. NSTRUCTIONS SAVE THESE INSTRUCTIONS CAUTION UPS having Internal Batteries risk of electrical shock Hazardous live parts inside this unit are energized from the battery supply even when the input AC power is disconnected CAUTION No User serviceable Parts Risk of electrical shock do not remove cover No user serviceable parts inside Refer servicing to qualified service personnel CAUTION Non isolated Battery supply risk of electric shock battery circuit is not isolated from AC input hazardous voltage may exist between battery terminals and ground Test before touching WARNING unit intended for installation in a controlled environment CAUTION Do not dispose of batteries in a fire the battery may explode CAUTION Do not open or mutilate the battery released electrolyte is harmful to the skin and eyes CAUTION a battery can present a risk of electric shock and high short circuit current The following precaution should be observed when working on batteries Remove watches rings or other metal objects Use tools with insulated handles To reduce the risk of electric shock disconnect the UPS from the main supply before installing a computer interface signal cable Reconnect the power cord only after signaling interconnections have been made Servicing of batteries should be performed or supervised by personnel with knowledge of batteries and the required precautions Keep unauthorized personnel away from
4. batteries The instructions contained within this safety manual are deemed important and should be closely followed at all times during installation and follow up maintenance of the UPS and batteries E Xtreme Power Conversion Corporation Rev 8 29 13 Page 5 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS d caunon The unit has a dangerous amount of voltage If the UPS indicator is on the unit s outlets may have a dangerous amount of voltage even when not plugged into the wall outlet because the battery may continue to supply power Care should be taken to undertake installation indoors free from electrically conductive particles which are under temperature and humidity control in order to reduce the risk of electric shock It is best to disconnect the device using the power supply cord Ensure that the equipment is placed in a position near the outlet where easily accessible All servicing on this equipment must be carried out by qualified service personnel Before conducting any maintenance repair or shipment first ensure that everything is turned off completely and disconnected eee Xtreme Power Conversion Corporation Rev 8 29 13 Page 6 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS TROUBLESHOOTING Charge the UPS at least 8 hours No LED display on the front UPS Battery fault Replace the battery with the same panel type of battery Press the Power Switch on the front The UPS is not turned
5. croprocessor to guarantee high reliability and provides stable power to connected equipment enabling shutdown of your PC or other equipment safely during a power failure It s a perfect solution for any home or small office environment Power switch UPS status indicator Fault Battery status indicator check the Indicator amp Alarm Table for details FRONT VIEW Xtreme Power Conversion Corporation Rev 8 29 13 Page 2 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS INPUT IEC PLUG WITH FUSE USB COMMUNICATIONS li E 6 MODEL XSTi 600 800 BATTERY PROTECTED IEC OUTPUT RECEPTACLES REAR VIEW INSTALLATION amp INITIAL STARTUP Note Before installation inspect the unit and packaging to make sure that nothing inside has been damaged Placement amp Storage Install the UPS in a protected area that is free of excessive dust and has adequate air flow Place the UPS away from other units at least 7 8 in 20 cm to avoid interference DO NOT operate the UPS where the temperature and humidity is outside the specified limits See Specifications for details Connect UPS to Utility and Charging Before the initial use of the UPS plug the UPS input cord into a wall outlet and turn the UPS on by depressing the Power switch on the front of the UPS For best results the batteries in the UPS should be charged for at least 8 hours before use The UPS charges its battery while it is conne
6. cted to AC utility power and powered on Xtreme Power Conversion Corporation Rev 8 29 13 Page 3 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS Connecting the Loads Plug the loads to be supported by the UPS into the output receptacles on the rear of the UPS Simply turn the power switch on the UPS on and the devices connected to the UPS will be protected by the UPS unit CAUTION NEVER connect a laser printer or scanner to the UPS This may cause damage to the unit Turn UPS ON OFF To turn the UPS unit on press the Power switch on the front of the UPS To turn the UPS unit off press the Power switch on the front of the unit again Connecting Local Monitoring Software optional If it is desired to use the Local Monitoring Software and if your UPS is equipped with USB communications connect a USB cable from your computer to the UPS and install the software from the CD INDICATORS amp ALARM CONDITIONS conton Vevar wm Audible Alarm sounds every 10 Battery mode Blue LED flashes every 10 seconds seconds Blue LED flashes every 1 second Audible Alarm sounds every 1 and Red LED is illuminated second Red LED is illuminated Audible Alarm is continuous Alarm for over temperature protection Low battery mode Red LED flashes every 0 5 seconds No Audible Alarm Xtreme Power Conversion Corporation Rev 8 29 13 Page 4 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS IMPORTANT SAFETY I
7. echnician about obtaining a replacement set of packaging material It is important to pack the UPS properly in order to avoid damage in transit Never use Styrofoam beads for a packing material 2 Include a letter with your name address daytime phone number RMA number a copy of your original sales receipt and a brief description of the problem 3 Mark the RMA number on the outside of all packages Xtreme Power cannot accept any package without the RMA number marked on the outside of the boxes 4 Return the UPS by insured prepaid carrier to the address provided by the Technician 5 Refer to the Warranty statements in this manual for additional details on what is covered Xtreme Power Conversion Corporation Rev 8 29 13 Page 9
8. ft above sea level oO i faa e o s lt Xtreme Power Conversion Corporation Rev 8 29 13 Page 8 XSTi USER S MANUAL UNINTERRUPTIBLE POWER SUPPLY UPS OBTAINING SERVICE If the UPS requires Service 1 Use the TROUBLESHOOTING section in this manual to eliminate obvious causes 2 Verify there are no circuit breakers tripped 3 Call your dealer for assistance If you cannot reach your dealer or if they cannot resolve the problem call Xtreme Power Conversion Corp Technical Support at 1 720 292 1217 Technical support inquires can also be made at support xpcc com Please have the following information available BEFORE calling the Technical Support Department a Your name and address b The serial number of the unit c Where and when the unit was purchased d All of the model information about your UPS e Any information on the failure including LED s that may or may not be illuminated f A description of the protected equipment including model numbers if possible A technician will ask you for the above information and if possible help solve your problem over the phone In the event that the unit requires factory service the technician will issue you a Return Material Authorization number RMA If you are returning the UPS to Xtreme Power for service please follow these procedures 1 Pack the UPS in its original packaging If the original packaging is no longer available as the Technical Support T
Download Pdf Manuals
Related Search