User manual
Contents
1. La lake Xe DELE The bicycle is designed for normal use on level and solid ground The usual bicycle caution should always be taken into consideration At the same time all safety instructions as described in this manual should be complied with explicitly Also the local traffic rules should always be complied with All other use including damage or physical injuries due to this are not the manufacturer s responsibility User manual Balance 06 13 Safety measures Ensure the bicycle is in good condition each time before using it Check before each ride that the brakes are in order Check the lights and reflectors Regularly check whether all screw joints are tight Regularly check whether the wheels the handlebars and the saddle are secure Make sure there is sufficient air in the tyres Only use the bicycle on a solid and level surface Make sure that wide trousers or lose hanging clothing don t get caught in the chain spokes or pedals Do not use a pressure washer or a steam cleaner for the cleaning of the bicycle User manual Balance 06 13 4 Load The maximum load should not be exceeded See information in the index of technical details By permitted load we mean the total load including the load on the luggage rack Make sure that the permitted load on the luggage rack is not exceeded Damaged or worn out parts The replacement and repair of parts frame forks illumination brakes drive mechanism and2. at home at room temperature To charge the battery 1 Open the little lock by turning the key a quarter to the right 2 Pull the handle forward 3 Take the battery pack into the house Plug the charger into the plug contact of the battery 4 Connect the charger plug into the socket The red light on the charger will light up User manual Balance 06 13 5 Depending on the battery level the charging time is about 3 hours If the green light is on the battery is charged 6 Once the battery is charged pull the plug from the socket first 7 Then pull the connector from the battery 8 Put the battery back in the holder behind A on B 9 Pull the handle backwards and push the battery on the top to the connector as shown in the drawing and close the lock 10 Push the handle forward and 11 close the lock A It is also possible to charge the battery while it is still in the holder User manual Balance 06 13 When charging the battery first connect the charging point and then insert the plug into the socket After being charged first disconnect the socket and only then remove the charger from the tricycle AN After charging always remove the charger cable from the battery A Ensure that the battery is always is pushed straight into the holder Backup battery optional The bike can be supplied with a second battery To activate the second battery when the first ba
3. in general expires if the instructions stated in this manual are not followed This is also the case if unauthorized maintenance is carried out or if technical changes or additions are made without permission of Van Raam User manual Balance 06 13 18 Frame number The frame number is printed on the sticker This sticker is located on the frame see the image below Example sticker ll U R info vanraam nl XX XX XXXXXXXX wnan Www vanraam nl Frame number Position of sticker on backside of the saddle tube User manual Balance 06 13
4. your order you can use the accessories as described below Crank shortener The crank shortener is fitted to the crank as illustrated The pedal can then be fitted into the crank shortener A at two positions With the socketed screw A the crank 3 shortener should be aligned with the NAG iN crank OND lg 2 assembly points pedal Eccentric crank The bicycle can be fitted with an eccentric crank on the left and or right side User manual Balance 06 13 8 Foot support The foot support is fitted to the pedal with a z balance block iki Flashing light system kg gt To use the flashing lights press the switch to left or right If you want to switch off the flashing light system put the switch in the middle position The lights work on a battery ia B P To replace the batteries turn the screw on the cap and take the orange cap B away Then sm EN remove the PCB C from the holder You can i A now replace the battery D dad This is a 3 volt lithium battery CR123A User manual Balance 06 13 9 Walking stick holder You can take 2 sticks with you in the stick holder Place the stick in the holder at the bottom side A and then secure the stick in the fastening device B at the top side Always fasten the stick s with velcro A Silent Electric motor The Electric motor has the following Functions Pedal assistance while cycling Stand 1 2 or 3 Lau
5. 3 16 The correct tension of the chain The chain should not be too tight It should hang loose Without effort you should be able to move the chain up and down half a centimetre approximately To keep the tension of the chain correct a special tensioning wheel is fitted by the pedal axis If you have an electric motor this tension wheel is behind the battery and you have to remove the battery first The right lubricant The chain should be cleaned and maintained at regular intervals every 3 months approximately Only use special chain grease or Tevlon spray This is the only way to make sure that the chain will run smoothly will stay water resistant and will not rust Wipe the chain with a cloth treat it with grease or spray and remove any excess lubricant with a rag Other parts should not be treated with a lubricant Checking the rim Due to the combined action of the brake and the rims not only the brake lining but also the condition of the rim is important For this reason the rim should be checked at regular intervals for example when you inflate the tyres The presence of fine cracks in the spoke punches or deformation of the rim when there is higher air pressure indicate more serious wear and tear In that case the rim should be replaced because it can lead to loss of brake function or even a crack in the rim which can lead to all kinds of dangerous consequences Repairs and maintenance to be done by dealer It is
6. User manual P S vanraam Balance CE Van Raam BV Aaltenseweg 56 7051 CM Varsseveld Netherlands 06 13 Contents annae EG N Contact details manufacturer Conformity vats Talttere ld edel AA tenen i E a ans ee ae N DEVET ARE EE EE NE AN RE ED EE Intended usage Safety measures Delivery inspection Adjustment of the bicycle Accessories nn Before the first use Technical details ESE SEED SE OE EER EN EE See ce SE eN Maintenance and adjustments to be done by owner ee Repairs and maintenance to be done by dealer ese Re Re Re ee Bee EER RE RR EE OE ER EE OE RR OE TEN Handover sale to a new owner ts Giatdnie ss EE MM See NS OE EE ER Aen at oe n Frame numb Otic NE EL OON EE en ER ME ER N RE Contact details manufacturer Van Raam BV Aaltenseweg 56 7051 CM Varsseveld Netherlands Tel 31 0 315 257370 E mail info vanraam nl Internet www vanraam nl Conformity Van Raam declares as manufacturer that the Tavara Balance bicycle has been produced in accordance with the 93 42 EEG guidelines User manual Balance 06 13 Introduction This user manual gives important and necessary AN information about the use of your bicycle We ask you to go through the manual thoroughly before using the bicycle g READ THOROUGHLY Delivery bicycle with possible packaging user manuals s possible charger s depending on options
7. lose the clamp the nut should be loosened slightly Do not pull out the saddle pin further than the marking The tube will not go into the shank deep enough and will risk coming off This can lead to serious injuries User manual Balance 06 13 MIN INSERT Handle bar height The height of the handle bars affects the comfort of the ride It determines the pressure lt 2 on the hands and the position of the back Determine your own most comfortable height by using the bike To adjust the handle bars 1 Slightly loosen the screw by using an Allen 1 key 2 Slide the handle bars to the correct height and tighten the screw very firmly again Do not pull out the handle bars further than the mark Otherwise the tube will not be deep enough in HITT the shaft and will risk coming off which can lead to MIN INSERT serious injuries Position handle bars You can tilt the handle bars This influences 2 the distance from the handle bars to the upper body Determine your own most comfortable position by using the bike 3 To tilt the handle bars 1 Slightly loosen the screws A and B with an Allen key 2 Put the handle bars in the desired position and then tighten the screws considerably 3 Slightly loosen screw C with an Allen key put the handle bars in the correct horizontal position and then tighten the screw again gt B User manual Balance 06 13 Accessories Depending on
8. nch contr On of Button Press the on off button to turn on the motor After the system is turned on the electric motor is active in level 1 Level 1 provides light support Level 3 provides optimum support You can change the level while cycling Indication lights battery The engine has launch control This allows the driver to accelerate without pedaling up to a speed of 5 km h To accelerate press the launch button and keep it pressed down The motor is activated after 2 seconds User manual Balance 06 13 With the on off button you can turn off the system When the system is not used it will automatically turn off after a certain time You can see the battery level at the indication lights at the coloured display If only the red light is on the battery is almost empty and needs to be recharged or replaced by a new fully charged battery When the last red light flashes the battery is empty and the engine will not support you any longer while cycling When you push the bicycle turn off the motor When the motor is not used for several days the battery switches into the sleeping mode This to protect the batteries To activate it you must connect the battery to the charger for a few seconds or cycle the bike forwards and push the on off button to activate the system Charging the Battery LQ 4 For the best performance and to prolong the gt life of the battery we recommend that you charge the battery
9. recommended that the bicycle has a yearly inspection carried out by the dealer In the event of technical trouble or faults the bicycle should be taken to the dealer for repairs immediately The replacing of safety related components especially frame brakes illumination handle bars front fork and actuation should be performed by the dealer If you still decide you want to replace components yourself you are responsible for damage or harm due to incorrectly fitted components Only use original spare parts which you can buy at you dealer If requested the dealer will make the necessary information on repair and maintenance available User manual Balance 06 13 If you want to dispose your bicycle contact your dealer You can also contact the local waste disposal company They will dispose the bicycle according to the regulations of your town Handover sale to a new owner When you hand over your bicycle to a new owner it is important that you also hand over all necessary technical documentation so that the new owner can use the bicycle safely Guarantee The guarantee is valid for all faults in the product which are proven to be caused by material or manufacturing error For our bicycles we give a guarantee of 5 years on the frame and the front fork For the paint all accessories and other parts except wear parts we provide a 2 year guarantee as legally regulated Beware The guarantee as well as the product liability
10. the handle bars should always be performed by a dealer If not the guarantee ceases to be valid and you will be personally responsible in the event of possible damage AN Specific safety parts should always be replaced by new parts Delivery inspection Check the delivery immediately after receiving it In the event of damage or incomplete delivery we ask you to contact your dealer immediately Adjustment of the bicycle Before using the bicycle adjust it to the measurements of the cyclist This is of great importance especially the saddle and the handlebars 7 fan optimal adjustment of the bicycle as defined in the instructions is not possible you can contact your dealer for a fitting solution The brakes are correctly adjusted as standard and can only be adjusted by the dealer during periodic maintenance User manual Balance 06 13 5 Saddle height When the cyclist is sitting on the bicycle and can put a foot on the pedal in the lowest position the saddle height is correct Adjust the saddle height in such a way that the leg is stretched but relaxed in that position To adjust the saddle 1 Open the quick clamp A 2 Slide the saddle to the correct height 3 Close the quick clamp 7 Make sure clothing cannot get El caught in the clamp A If the clamp closes too easily the clamping force is too low In this case open the clamp and tighten the nut B a bit more If a lot of force is necessary to c
11. ttery is empty turn on the switch under the luggage carrier in order to activate the battery User manual Balance 06 13 Before the first use Gears Standard the bicycle has 8 gears The gears are used by turning the grip Do not use the pedals when turning the grip Illumination The lights work on batteries Use the buttons to switch the lights on and off The back light has 2 modes steady and flashing To replace the batteries of the headlight turn the screws of the cover loose and remove it You now can change the 3 AA batteries l EJ In case you can not easily reach the screws Slightly loosen screw A and tilt the light a quarter turn so the screws are better accessible A User manual Balance 06 13 Check before every ride the brakes the tyre pressure the illumination that all parts are secure Contact your dealer and do not use your bicycle if you identify any irregularities As with all mechanical parts the bicycle is subject to wear and tear and high loading If a component fails it can lead to very dangerous situations This can lead to damage or injuries to the user of the bicycle Any form of tearing scratching or changing of colour is an indication that the part should be replaced Important safety points for the cyclist Go very carefully during the first ride When riding the bicycle hold both hands firmly on the handle bars and feet on the pedals Test the riding s
12. tyle of the bicycle on rough ground at moderate speed This way the cyclist learns how to react to unexpected movements of the bicycle and the handle bars during use Small obstacles should be cycled over with appropriate speed Obstacles higher than 5 cm should be avoided Technical details Length cm 182 Frame height cm 52 Boarding height cm 23 Front wheel 24 Back wheel 24 Weight kg Ab 19 Max load luggage rack kg 15 Total max load kg 135 Brakes front Cantilever brakes Brakes back Cantilever brakes User manual Balance 06 13 15 Maintenance and adjustments to be done by owner Below you can find the instructions for maintenance and adjustments that you can do yourself on a regular basis which will keep your bicycle in top condition Cleaning The frame of the bicycle can be cleaned with a damp cloth For areas that are dirtier you can use a mild detergent The wheels can be cleaned with a damp brush with plastic hairs not a wire brush The seats and the grips can be cleaned with mild soap and water A Do not use a pressure washer or a steam cleaner Inspection of the bicycle After 200 kilometres or after a period of 2 months the bicycle should be inspected Check the brakes the illumination and the spokes Also check the tyre tread depth This should be at least 1 mm Worn out tyres or possible faulty parts should be replaced User manual Balance 06 1
Download Pdf Manuals
Related Search