Home
60 watt solar 12 volt power generator kit
Contents
1. O m 60 WATT SOLAR 12 VOLT POWER GENERATOR KIT User s Manual Congratulations on your Sunforce Products solar product purchase This product is designed to the highest technical specifications and standards It will supply years of maintenance free use Please read these instructions thoroughly prior to installation then store in a safe place for future reference If at any time you are unclear about this product or require further assistance please do not hesitate to contact our trained professionals operating the customer support line 1 888 478 6435 or email to info sunforceproducts com Specifications Power Rating Up to 60 Watts Maximum rating Under optimum conditions Current 4 Amps 15Volts PARTS INCLUDED 1 Three x 20 Watt Amorphous Solar Panels 2 Amp Solar Charge Controller 3 Quick connect extension cable 4 12 Volt plug 5 Female 12 Volt connector 6 12 Volt inverter plug 7 3 1 cable connector 8 Stripped wire charge controller connector 9 200 watt power Inverter 10 Support frame i g 2 3 4 Constructing your frame The construction of your Sunforce 60 watt solar power generator kit frame can be achieved in four easy steps no additional tools required 1 Stand the two side triangle supports up on there longest edge 2 Slide the base support bar into the side triangles The base support bar has no visible studs x al 4
2. Place the panels onto the frame panels have mounting holes in the frame that correspond to studs on the triangle supports and top support bar Your 60 watt solar power generator kit is now mounted For AC devices or appliances use the 200 Watt inverter included in the kit Connect to the battery making sure the positive is attached to the positive battery terminal and the negative is attached to the negative battery terminal Note some inverters may have similar color coded alligator clamps Next plug the AC device into the inverter Remember that the start up surge power of the device which is approximately double the continuous power must be under the wattage value of the inverter Please refer to the inverter manual for operating instructions It is strongly recommended to turn off the inverter when not in use GENERAL TESTING PROTOCOL Always test outdoors under optimal sunlight Test Solar Panels for Voltage If a Voltage read out is desired connect a voltmeter not included and test each panel individually and observe the open voltage The open Voltage can range from 16 Volts to 24 Volts Test Connection to Charge Controller for Voltage Reconnect solar panels and connect to charge controller as per instructions Measure the Open Circuit Voltage at the battery side of the charge controller Open circuit voltage should read 5 10 lower than without the charge controller Open circuit measurement will read between 15 a
3. the battery voltage reaches 14 2 Volts and the SCC will prevent the solar panels from overcharging the battery It is normal for the SCC LED to light on and off as the battery voltage cuts in and out WARRANTY The solar panel is covered by a five year limited warranty of 80 of power output and must be tested under optimal conditions This product is warranted from defects in materials and workmanship for a period of five years from date of purchase This warranty does not apply in the event of misuse or abuse and or repairs and alterations For more information or technical support 1 888 478 6435 www sunforceproducts com info sunforceproducts com MADE IN CHINA 60Kit3x20111210
4. nd 23 5 Volts DC Connect Charge Controller to Battery First disconnect solar panels and connect the charge controller to the battery Always connect the charge controller to the battery first and remove last Observe polarity positive to positive and negative to negative Reconnect Solar Panels to Charge Controller If battery voltage is 14 2 Volts or higher the GREEN LED on the charge controller should be on If battery voltage is between 13 and 14 2 Volts the YELLOW LED should be on If battery voltage is 13 Volts or lower the RED LED should be on If all testing results are within the above indicated ranges the solar array is functioning If Voltage readings indicate lower ranges repeat above connections and retest FAQ Can use these solar panels outdoors Yes these solar panels are weatherproof The weatherproofing includes UV protection and protects from weather effects of 35 F 175 F 37 C 79 Can overcharge my battery as long as Sunforce 7 Amp Solar Charge Controller is used it will protect the battery from overcharging How many panels connect to my 7 Amp Solar Charge Controller You can connect up to 105 Watts of Solar Power to the 7 Amp Solar Charge Controller Panels should be connected in parallel positive to positive negative to negative When will the Charged Indication light green on the charge controller light up The charged indication green light will light up when
Download Pdf Manuals
Related Search
Related Contents
clavier de système avec joystick et jog shuttle art. 40705 P15M2 - Cia Ovens Dell Inspiron 3500 Installation Manual Vantec NST-386S3-SV storage enclosure Please Click here to the Instructions PDF File Copyright © All rights reserved.
Failed to retrieve file