FlexRhoop™ Assembly, Installation, Care, Maintenance & Use
Contents
1. Take 2 of the plastic clamps and clip them around the 2 mounting rods in the cut out of the enclosure pocket as shown below Step 8 Fastening the short sup port rods Ensure the top of the enclosure rod is fully inserted into the enclosure pocket and then using the nuts bolts and hex key provided insert the end of the short sup port rod and tighten the bolt to tighten the clamp on the enclosure rod Step 9 Fitting the long support rods Please note that the attachment position for the long support rods is slightly different for different models If installing the FlexRhoop on a SF40 R54 SF68 S113 SF72 R79 or SF90 please follow Step 9a If you are installing the FlexRhoop on a SF60 092 or SF80 S155 please follow Step 9b 4 Springfree Trampoline Step 9a Fitting the long support rods on SF60 092 or SF80 S155 Clip the plastic clamps around the enclo sure rods above the enclosure rod joiner Position the clamps so that they sit on the top edge of the enclosure joiner and then using the nuts bolts and hex key provided insert the end of the long support rod and tighten the bolt to tighten the clamp on the enclosure rod see figure in step 8 Before tightening check that the both clamps on each enclosure rod are aligned and facing the same direction Step 9b Fitting the long support rods on SF40 R54 SF68 S113 SF72 R79 or SF90 Clip the plastic clamps around the enclo sure rods above the enclos2. are no overhead power lines or obstructions within 20 ft 7 m radius If using a ladder during assembly use extreme caution Capable adults are recommended for this operation Read and follow all warnings and instructions Trampoline and Safety Enclosure Installation and Placement Instructions 2 Adequate overhead clearance is essential A minimum of 24 ft 7 32 m from ground level is recommended Provide clearance for wires tree limbs and other possible hazards Lateral clearance is essential A minimum of 4 ft 1 22 m clearance around the perimeter of the trampoline must be maintained at all times Place the trampoline enclosure away from walls structures fences and other play areas Maintain a clear space on all sides of the trampoline enclosure Place the trampoline safety enclosure on a level surface before use Springfree Trampoline Use the trampoline safety enclosure in a well lit area Artificial illumination may be required for indoor or shady areas Secure the trampoline safety enclosure against unauthorized and unsupervised use Remove any obstructions from beneath the trampoline safety enclosure Do not attempt to use the trampoline safety enclosure until it is completely assembled The owner and supervisors of the trampoline safety enclosure are responsible for ensuring all users are aware of practices specified in the use instructions The trampoline safety enclosure is only to be used as an enclosure
3. for a trampoline and the trampoline must be of the appropriate size as covered by the specific enclosure Preparation Ensure all components are present Table 1 If you are missing any parts please call your local authorized Springfree Trampoline dealer PARTS LIST Partially Assembled Hoop amp Backboard A A Short Support Rods Long Support Rods Cable Ties Plastic Clamps Bolts amp Nuts Hex Key _ Spares Bag cable ties bolt and nut Basketball _ Pump Short Support Rod Hoop and Backboard Long Support Rod a Ti y Fi a F ee ia URUN Y h a Gr Plastic Clamp EA Bolt amp Nut www springfree com INSTALLING THE FLEXRHOOP Step 1 Preparing the FlexRhoop Locate the partially assembled hoop and backboard On the rim there are two straps with snaps domes at the end Pull the ends of these straps down and under the bottom edge of the backboard and attach to the snaps domes on the back of the backboard This should result in the hoop sitting out at a right angle to the backboard Step 4 Locating the FlexRhoop mounting rods Choose 2 enclosure rods that are inserted into a curved frame section i e any frame section on a round model or a corner frame section on an oval or square model The FlexRhoop will be installed onto these mounting rods WARNING Never attempt to remove an enclosure rod from its pocket or disengage unlock the joiner while the encl
4. CTS NORTH AMERICA Springfree Trampoline Inc 151 Whitehall Drive Unit 2 Markham Ontario L3R 9T1 Canada Toll free 1877 JUMP SAFE Fax 1 905 948 0016 Email customerservice springfree com Web www springfree com AUSTRALIA Springfree Trampoline Aust Pty Ltd Unit 1 60 Hoopers Road Kunda Park Queensland 4556 Australia Free 1800 JUMP SAFE 1800 123 204 Fax 61 7 5453 9444 Email fun springfree com au Web www springfree com au NEW ZEALAND Springfree New Zealand Ltd 125 Blenheim Road P O Box 80117 Riccarton 8440 Christchurch New Zealand Free 0800 JUMPSAFE 0800 586 772 Ph 64 3 961 0529 Fax 64 3 963 6999 Email info springfree co nz Web www springfree co nz If you require service on a Springfree Trampoline product and your territory is not included in this list then contact us via one of our registered e mail addresses above 6 Springfree Trampoline www springfree com
5. is or death even when landing in the middle of the bed DO NOT allow more than one person on the trampoline inside the enclosure Multiple jumpers increase the chances of loss of control and this can result in broken head neck back or leg or other serious injury Do not use the trampoline when wet Do not exceed the weight limit recommended by the manufac turer Do not jump from other objects buildings or surfaces onto the trampoline or into or over the trampoline enclosure Do not use the trampoline enclosure system while under the influence of alcohol or drugs Trampolines over 20 in 51 cm tall are not recommended for children under six years of age DO NOT intentionally rebound off the enclosure or intentionally jump into the enclosure DO NOT hang kick cut or climb on the enclosure basketball system Do not hang from the rim During play especially when per forming dunk type activities keep players face away from the backboard rim and net During play do not wear jewellery rings watches necklaces etc Objects may entangle in net Wear clothing free of drawstrings hooks loops or anything that could get caught while using the trampoline enclosure and result in entanglement and or strangulation During play especially when performing dunk type activities keep players face away from the backboard rim and net Seri ous injury can occur if teeth face come in contact with back board rim or net Ensure that there
6. osure rod is under tension Springfree Trampoline Step 2 Inserting the support rods There are 4 sleeves sewn onto the back side of the backboard Locate the 2 short support rods and slide them into the short sleeves close to the bottom edge of the backboard Repeat this process with the 2 long support rods and the long sleeves attached near the top of the backboard Step 3 Attaching the cable ties Once the rod is in place take a cable tie and thread it through the eyelet at the end of the sleeve then through the hole in the plastic fitting on the end of the support rod Thread the cable tie back through itself as shown and pull the free end to tighten The FlexRhoop is now ready to mount onto the FlexiNet enclosure Step 5 Taking down the FlexiNet enclosure Remove the C clips at the bottom of these enclosure rods and a further 2 enclosure rods to the left and the right Then lift the bottom of the 6 enclosure rods out of their sockets in the frame With the enclosure rods still at tached to the pockets around the top edge of the FlexiNet enclosure lay the 6 rods down flat on the mat of the trampoline Step 6 Preparing the FlexiNet enclosure Focusing on the 2 mounting rods onto which the FlexRhoop will be installed ensure that the outer plastic sleeve of the rod is intact and does not have any cracks or damage www springfree com 3 Step 7 Fitting the short support rods
7. re with or cause the jumper to fall awkwardly Do not attempt to jump on the ball as this may cause serious injury Do not attempt to disassemble trampoline enclosure support rods from the rod joiner mechanism while the rods are installed in the trampoline and under tension WARNING To ensure safety DO NOT attempt to assemble this system without following the instruction carefully Check the entire box and inside all packing material for parts and or additional instructions material Before beginning assembly read the instruction and identify parts using the hardware identifier and parts list in this document Proper and complete assembly use and supervision are essential for proper operation and to reduce the risk of accident or injury A high probability of serious injury exists if this system is not installed maintained and operated properly Springfree Trampoline www springfree com 1 Read these materials prior to assembling and using this basketball system 10 11 12 13 14 15 16 17 The FlexRhoop is only for use on Springfree Trampolines Use trampoline enclosure basketball system only with mature knowledgeable supervision Enforce all safety rules and be familiar with the information in the User s Manual to assist in fol lowing trampoline enclosure instructions and trampoline safety DO NOT attempt or allow somersaults Landing on the head or neck can cause serious injury paralys
8. springtree TRAMPOLINE FlexRhoop Assembly Installation Care Maintenance amp Use Instructions VERSION 1 1 The Springfree FlexRhoop is built using the same innovative materials and design concepts as the Springfree Trampoline The FlexRhoop is springfree great for kids who want to practice their shooting or dunking and adds a ie whole new element of fun for trampoline users Responsive backboard with no hard surfaces Flexible rods and rim that flexes safely when in use Easy to install on all Springfree Trampoline models Weather and UV resistant materials Please note that when choosing a basketball the maximum circumference cannot exceed 27 6 in 700 mm WARNING Read these materials prior to assembling and using this basketball system trampoline and enclosure Failure to follow these warnings may result in serious injury and or property damage Owner must ensure that all players know and follow these rules for safe operation of the system DO NOT attempt or allow somer saults Landing on the head or neck can cause serious injury paralysis or death even when landing on the middle of the bed DO NOT allow more than one person at the same time on the trampoline or enclosure Use by more than one person can result in serious injury Trampolines and basketballs were intended for separate purposes Take extra precautions while jumping on the trampoline with a basketball as the ball may interfe
9. the back board using the adjustment strap Locate the 2 straps attached to the long support rods on the back side of the back board Pass the webbing strap through the plastic buckle and tighten to tilt the top of the backboard back until it sits at the desired angle To tilt the top of the back board forward loosen the strap and loosen the long support rod clamps Then slide the clamps up the enclosure rods until the desired backboard angle is achieved Congratulations You have successfully completed the assembly of your Spring free FlexRhoop Be sure to review all warnings and precautions with your fam ily before using The Springfree Trampoline and FlexiNet safety enclosure design is protected by a number of international patents granted and pending and regis tered designs At the time of printing of this manual these include US patent 6319174 New Zealand patent 513331 China Patent ZL02825390 6 European registered design 000126602 0001 Australian registered design 311568 75 other international patents pending Please check http www uspto gov for latest updates Springfree Trampoline is a registered trademark of Board amp Batten International Inc FlexiNet is a registered trademark of Board amp Batten International Inc COPYRIGHT SPRINGFREE TRAMPOLINE 2005 2010 ALL RIGHTS RESERVED Springfree Trampoline www springfree com 5 SPRINGFREE TRAMPOLINE WORLDWIDE AUTHORIZED SERVICE CONTA
10. ure rod joiner Position the clamps above the top edge of the enclosure joiner and then using the nuts bolts and hex key provided insert the end of the long support rod and tighten the bolt to tighten the clamp on the enclosure rod see figure in step 8 Before tighten ing check that the both clamps on each enclosure rod are aligned and facing the same direction 3 in 80 mm www springfree com Step 10 Putting up the FlexiNet enclosure with FlexRhoop attached Ensuring that the bottom edge of the backboard is on the inside of the enclosure top band hoist up the net Bend the 2 rods attached to the FlexRhoop and insert the bottom end into the socket on the frame Ensure that the rod is pushed firmly into the socket and secured in place by the C clip Before installing the remaining enclosure rods be sure that the clamps are facing outward away from the centre of the tram poline mat NOTE Do not be alarmed if the support rods bend during or after the FlexRhoop is installed The support rods are designed to accommodate this bend Step 11 Completing the enclo sure Insert the next enclosure rod on the OP POSITE side of the trampoline by the same process Again ensure that the metal joiner lock remains engaged and that the rod is pushed right down into its socket and secured in place by the C clip Continue in stalling the remaining enclosure rods using the same technique Step 12 Adjusting
Download Pdf Manuals
Related Search