Home
MODEL: AstroStart RSS-5224
Contents
1. DISPUTE INVOLVING DIRECTED ORITS SUBSIDIARY THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER S PURCHASE PRICE OF THE PART DIRECTED SHALL NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEVER INCLUDING BUT NOT LIMITED TO ANY CONSEQUENTIAL DAMAGES INCIDENTAL DAMAGES DAMAGES FOR THE LOSS OF TIME LOSS OF EARNINGS COMMERCIAL LOSS LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE NOTWITHSTANDING THE ABOVE THE MANUFACTURER DOES OFFERALIMITED WARRANTY TO REPLACE OR REPAIRAT DIRECTED S OPTION THE PART AS DESCRIBEDABOVE Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation of incidental or consequential damages This warranty gives you specific legal rights and you may also have other rights that vary from State to State DIRECTED does not and has not authorized any person or entity to create for it any other obligation promise duty or obligation in connection with this Part 920 0007 07 06 This Interface kit Data Bus Interface part has been tested on the listed vehicles Other vehicles will be added to the select vehicle list upon completion of compatibility testing Visit website for latest vehicle application guide DISCLAIMER Under no circumstances shall the manufacturer or the distrib
2. Status confirmations tee G 7 Auxiliairy sensor icon Sy nea A Refer to the vehicle user manual for more cf DISPLAY LIGHTS UP l l Back light o pnan ona E nmana information on confirmations emitted by o Never moeosursor LIGHT SHUTS OFF your vehicle i e the horn parking lights and siren These confirmations are LEGEND DISPLAYED ICON BLACK DEFAULT morem different for each vehicle depending on These settings are not available with the XL202 module which module firmware is used Using your Remote Control CONFIRMATIONS COMMANDS BUTTON ao a 7 soes Om k l ogm A A en PANIC BUTTON HELD FOR gt 4 SEC A or A o a a rw TRUNK BUTTON HELD FOR gt 4 SEC ee s ACTIVATE CANCEL AUX 1 Senet aa tee A Refer to the vehicle user manual for more information on ACTIVATE CANCEL AUX 2 ie te confirmations emitted by your vehicle i e the horn parking VEHICLE SELECTION HIS BUTTON IS LOCATED lights and siren These confirmations are different for each BUTTON HELD 1 5 SEC ON THE BACK OF THE REMOTE vehicle depending which Bypass is used LEGEND DISPLAYED ICONS BLACK COMMANDS FOLLOWED BY AN ASTERISK APPLY ONLY TO COMMAND UNITS EQUIPPED WITH A SECURITY SYSTEM THIS COMMAND TERMINATES THE RUNTIME PANIC MODE AND ALARM STATUS ONLY IF THE FACTORY ALARM TRIGGER MONITORING FEATURE IS SUPPORTED BY THE FIRMWARE TEMPORARY VALET MODE IF ACTIVATED A SECOND TIME DURING REARMING DE
3. purchaser to repair or replace with a comparable reconditioned piece the security or remote start accessory piece hereinafter the Part which proves to be defective in workmanship or material under normal use provided the following conditions are met the Part was purchased from an authorized DIRECTED dealer and the Part is returned to DIRECTED postage prepaid along with a clear legible copy of the receipt or bill of sale bearing the following information consumer s name address telephone number the authorized licensed dealer s name and complete product and Part description This warranty is nontransferable and is automatically void if the Part has been modified or used in a manner contrary to its intended purpose or the Part has been damaged by accident unreasonable use neglect improper service installation or other causes not arising out of defect in materials or construction TO THE MAXIMUM EXTENT ALLOWED BY LAW ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY IMPLIED WARRANTY WARRANTY OF MERCHANTABILITY FITNESS FOR PARTICULAR PURPOSE AND WARRANTY OF NON INFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON OR ENTITY TO ASSUME FOR IT ANY DUTY OBLIGATION OR LIABILITY INCONNECTION WITH ITS PRODUCTS DIRECTED HEREBY DISCLAIMS AND HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING DEALERS OR INSTALLERS IN THE EVENT OF ACLAIM ORA
4. 2KPRESSKIT MODEL AstroStart RSS 5224 Sees 2 Way LCD XRT Remote Start and Security System with One Mile of Range Rev 20091103 Page 1 The RSS 5224 is the ultimate 2 way communication with graphics and audio tones on a 4 button transmitter Multi channel and vehicle remote control capability and vehicle status indicator via remote A maximum of four remote controls can be assigned to your vehicle See your dealer for additional remote controls The range of your remote control can be affected by a weak battery interference from nearby metal structures hydro poles or crowded parking lots If the vehicle is out of range the transmitter will emit a soft chirp after 3 seconds to indicate that the command has not been received by neither the module nor the transmitter HOW TO USE THE REMOTE To send a command press the corresponding button for two seconds The command may not be sent if the button is not pressed long enough The remote control beeps when a button is pressed then emits eight short beeps during the transmission i e about one second after the button was pressed Your remote control can transmit on four different channels allowing control of four separate vehicles Only the Panic command is transmitted on both channels simultaneously To select a different channel press the P button located on the back and hold it for 2 secondes when the button is released the transmitter passes to the next
5. LAY START CONFIRMATION CAN TAKE FEW SECONDS EXCEPT IF THE ENGINE IS ALREADY RUNNING F SPRESSKM Du ELECTRONICS INC VIPER CLIFFORD PYTHON pnn ITAL 2009 Directed Electronics All rights reserved 2KPRESSKIT MODEL AstroStart RSS 5224 SSIES 2 Way LCD XRT Remote Start and Security System with One Mile of Range Rev 20091103 Page 3 Understanding the Confirmations Emitted by the Remote The LCD displays the vehicle status at all time the display is refreshed on every transmission or when the status of the vehicle changes pertaining that the Status confirmation function is enabled The display shows the last confirmation received The following diagram shows the usefulness of each icon of the display Descriptions in CAPITAL letters show confirmations pertaining to the security system s functions AODO aAOD O 1 Transmission 14 Battery charge indicator 2 Vehicle out of range 15 Auxiliairy outputs status Ki oa a d 3 Reception 16 Sentinel mode status TX In See alien 4 Unlocking 17 SECURITY SYSTEM STATUS 4 5 Locking 18 ULTRASONIC SENSOR 3 A 6 PRE ALERT 19 IGNITION STATUS SENSOR 7 Panic PRE ALERT ALARM 20 TILT SENSOR 9 8 ALARM 21 Remote starter status D 9 SHOCK SENSOR 22 HOOD STATUS re e eg 10 FIELD DISTURBANCE SENSOR 23 TRIGGERED ZONES 11 TRUNK LID STATUS 24 Valet mode status O saul Oy 12 GLASS BREAKAGE SENSOR 25 Vehicle identification 13 DOORS S
6. TATUS These features are not available with the XL202 module Only if the Factory Alarm Trigger Monitoring feature is supported by the firmware Two types of confirmations are displayed on the remote Command confirmation These confirmations are command acknoledgement the icon corresponding to the command is displayed to confirm reception of the command Status confirmations These confirmations are displayed when the status of a zone monitored by the system changes i e door openning security system alarm state only if the Factory Alarm Trigger Monitoring feature is supported by the firmware etc it depends on which firmware you are using Command confirmations are returned immediatly following a command transmission whereas the status confirmations may be returned up to 12 seconds after the event appened depending on the communication protocol between the hand held unit and the vehicle Remarks When the remote receives a confirmation that is intended to a vehicle other that the one actually selected most audible confirmations are made more descret vehicle icon flashes 1 4 to warn you that the display reflect the status of that specific vehicle This is only applicable if the Factory Alarm Trigger Monitoring feature is supported by the firmware When a command is transmitted the vehicle selection gets back to the previously selected unless the confirmation was related to an alarm condition In that case the selected ve
7. channel A The remote control shown may differ from that included in the kits Your system may be programmed in such a way that it can distinguish between two groups of remote controls maximum two remotes per group These groups let you activate predefined settings seat mirror and other when unlocking certain vehicles additional optional equipment required This feature is available with certain firware only As soon as a command is sent the remote switches over to standby mode in order to receive and display confirmations sent by the command module installed in the vehicle These confirmations are sent to all the programmed remote These signals are transmitted only once and could be neutralized by radio or electromagnetic interferences generated by electronic devices in the vicinity If no confirmation is received in a given location move away from electronic devices and activate the Status command s The start module will inform you of the status of door locks alarm only if the Factory Alarm Trigger Monitoring feature is supported by the firmware and running of the engine Note that the communication between the vehicle and the transmitter operates in only one direction at a time This is why it is recommended to wait for the confirmation before sending another command Otherwise the vehicle and the transmitter could transmit at the same time wich would block the command as well as the returned confirmation Out of rang
8. e If the vehicle is out of range the transmitter will emit a soft chirp after 3 seconds to indicate that the command has not been received by neither the module nor the transmitter TECHNICAL SUPPORT INFORMATION 2 lt PRESSKIT web resources be N www xpresskit com N www xpressvip com www directechs com BOR oI OT D ELECTRONICS INC VIPER CLIFFORD PYTHON pn ITAL 2009 Directed Electronics All rights reserved 2KPRESSKIT MODEL AstroStart RSS 5224 SEIS 2 Way LCD XRT Remote Start and Security System with One Mile of Range Rev 20091103 Page 2 Replacing the Battery The LCD of the 4 button remote has a battery icon telling you when to replace the battery A We strongly recommend keeping a replacement battery in your glove compartment The remote controls require one AAA battery See your dealer for spare batteries To replace the battery slide the latch sideways and remove the battery cover on the back of the remote control case remove old battery and replace it with a new one Make sure the battery is placed the right way See pictogram inside the cover Programming the Features of the Remote Control To access the remote control programming mode press the P button located on the back of the remote and hold it for 5 seconds The remote beeps once to indicate entering programming mode pbk pe Keyboard Un Lock E 1 BEEP Asees o Disabled 0 4 BEEP Mute n q 2s O 23s
9. hicle is temporarely changed to allow stopping the alarm condition without having to change the vehicle selection then gets back to previously selected when the alarm condition is stopped Out of range In the event that the environement prevents the confirmation from being received by the remote control all icons are cleared out In this case resend the command or send the status command to refresh the display Upon Entering your Vehicle A DO NOT TURN IGNITION KEY TO START POSITION Automatic transmission vehicles Manual transmission vehicles To avoid turning the engine off when taking place behind the To avoid turning the engine off when taking place behind the steering wheel do not apply the brakes until you have placed steering wheel do not apply the brakes and do not remove the the key in the ignition and turned it to the RUN position parking brake until you have placed the key in the ignition and turned it to the RUN position Drive as usual Drive as usual BOR OS OT D ELECTRONICS INC VIPER CLIFFORD PYTHON pn ITAL 2009 Directed Electronics All rights reserved 2KPRESSKIT MODEL AstroStart RSS 5224 SSIES 2 Way LCD XRT Remote Start and Security System with One Mile of Range Rev 20091103 Page 4 Limited One year Consumer Warranty For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product Directed Electronics DIRECTED promises to the original
10. utors of the bypass kit data bus interface part s be held liable for any consequential damages sustained in connection with the part s installation The manufacturer and it s distributors will not nor will they authorize any representative or any other individual to assume obligation or liability in relation to the interface kit data bus interface part s other than its replacement N B Under no circumstances shall the manufacturer and distributors of this product be liable for consequential damages sustained in connection with this product and neither assumes nor authorizes any representative or other person to assume for it any obligation or liability other than the replacement of this product only PROTECTED BY U S PATENTS 5 719 551 6 011 460 B1 6 243 004 B1 6 249 216 B1 6 275 147 B1 6 297 731 B1 6 346 876 B1 6 392 534 B1 6 529 124 B2 6 696 927 B2 6 756 885 B1 6 756 886 B2 6 771 167 B1 6 812 829 B1 6 924 750 B1 7 010 402 B1 7 015 830 B1 7 031 826 B1 7 046 126 B1 7 061 137 B1 7 068 153 B1 7 205 679 B1 CDN PATENT 2 320 248 2 414 991 2 415 011 2 415 023 2 415 027 2 415 038 2 415 041 2 420 947 2 426 670 2 454 089 EUROPEAN PATENT 1 053 128 PAT PENDING 2 291 306 MADE IN CANADA BOR ECCUT Dz mie bs CL Full 2 Way D2D Compatible VIPER CLIFFORD PYTHON sires i ae 2009 Directed Electronics All rights ener
Download Pdf Manuals
Related Search
Related Contents
KOHLER K-4761-BN-DAW Use and Care Manual Descargar - Nilfisk PARTS Taski Pro Strip TEFAL AH950027 Instruction Manual ATTREZZI DI SOCCORSO IDRAULICI Martha Stewart Living 1606400310 Instructions / Assembly Copyright © All rights reserved.
Failed to retrieve file