USER MANUAL - Crem International
Contents
1. INSTALLATION AND START UP CATER nn Switch Single CATER Recommended install a line circuit breaker and a earth fault breaker to the machine A IMPORTANT Connect the plug to a separate earthed wall socket 220 230V 50 60Hz 10Amp The brewer is not reconnectable and may only be installed to the electric supply network with a voltage that is stated on the brewer and shall be carried out by an authorized electrician Recommended install a line circuit breaker and a earth fault breaker to the machine A CAUTION Connection to a separate 2 phase only Brewer should be connected to 400V with zero and earth Use 10 Amp fuses A IMPORTANT Electrical installations must be done of an certificated electrician 400 2N 4400 W 50 60Hz Turn on the switch located at the rear of the machine the machine will start filling with water While machine is heating up display is blinking Once the water has reached the correct temperature display will stop blinking and show a steady light A Machine is now ready to use OPERATION CATER Brewing with coffee Place a filter in the filter holder lt Always use Coffee Queen s recommended coffee Xs 9 A filter paper Filter type Omm filter paper Part No 110110 Recommended powder amount is 60g L Add coffee restaurant catering2. IEW OF COMPONENTS Water Connection Power Supply Power Switch CATER OVERVIEW OF COMPONENTS CATER Water Connection Power Switch Power Supply CJ BUTTONS AND DISPLAY INFORMATION CATER Pause Stop 1 2 Brewing Half brew 1 251 1 1 Brewing Full brew 2 5L While machine is brewing 4 Full brew Display shows see A While machine is brewing B Half brew y Display shows see B INSTALLATION AND START UP CATER MIN 10cm Place the brewer unit on a flat horizontal surface that will support the weight of the machine Make sure that air is able to circulate behind the machine minimum 1 Connect the supplied water hose to the cold water connection using a gt R connection When pushing the machine into position make sure there is no interference to the hose to ensure proper water flow Water supply to the machine is the customer s responsibility according to instruction and advice from the supplier In areas with high level lime problem a descaling filter should be mounted The new hose set supplied with the appliance shall be used and that old hose sets shall not be reused Connection to a closable valve is recommended Min water pressure 2bar 200kPa Max waterpressure 8bar 800kPa
3. USER MANUAL I UM EN Part No 1764105 01 CONTENT CATER 2 ER 4 Introduction Warnings Precautions intended se 4 Facts amp weight General functional description OVERVIEVY KEE Elei nena 6 Frontview Single CATER E 6 Front view CATER Back view SINGLE CATER A RN 9 BUTTONS AND DISPLAY INFORMATION Button Display indications when brewing INSTALLAMONAND Positioning Water connection Electrical connection and Startup scssiascssscssscessisusssoveccsestsscassesivatsessnsendeiebosssversesscsscosssavedederososnssetbecsibetdbelesstnote 12 OPERATION Brewing with coffee Filter positioning pelo IP E E POP O RRR aa Filter holder and serving station positioning Start brewing Dispensing hot Water seminal it im 14 keep temperature and 22 lt cintia 15 CLEANING AND CARE Daily cleaning Weekly cleaning Exterior cleaning when necessary PROGRAMMING soriana dica 18 Adjusting of Water temperature echte EE 18 CONTENT CATER Adjusting water 18 MESSAGE SIV VIN ON DEP A andate 19 EIERE 19 IE RE 20 SINGLE A 20 GATER nido 21 SEVEN ii 22 Some imp
4. area When needed Clean the spray nozzles hole If necessary loosen spray nozzle and clean de scaling Clean and dry this surfaces nn A CAUTION The machine should not be submerged in water or been washed L S dishwasher CLEANING AND CARE CATER Disassemble the level tube and clean it every week with the enclosed brush Turn off the bigger lid and clean the mixer tube A Cleaning of serving station 2 5L Fill the serving station with hot water Full IMPORTANT brewing without coffee and filter Rinse the serving B Put tablespoon with cleaning powder in the station on the serving station and wait at least 15 minutes inside several times with fresh tap water Tap off 2 3 of the cleaning solution Clean the serving station with the following cleaning brush B Rinse the serving station with fresh tap water sereral times before a new brew OPTIONS 110102 02 Cleaning powder 1104231 Cleaning brush Cleaning brush for level tube 1103360 mixer tube To clean the exterior of the machine use a soft rag with liquid cleaning agent to prevent scratches PROGRAMMING CATER Press buttons a and at the same time for 5 seconds until you hear one beep Display shows the present setting Adjust with the butto
5. eople cannot cause material damage to the machine trip over it Keep it away from sharp edges and Do not try to open the machine or repair it in heat sources any way To avoid danger only have the machine The new hose sets supplied with this appliance repaired in a technical workshop Service are to be used old hose sets must not be re Centre or by a qualified person used Remove the mains cable from the socket when This appliance is not suitable for installation in the machine is not in use for longer periods To an area where a water jet could be used do this pull the plug not the cable This appliance must not be cleaned by a water This appliance must be placed a horizontal jet position which is resistant to any water that may leak a This appliance is intended to be used in For the optimal performance of the machine household and similar applications such as these parameters shall not be exceeded Staff kitchen areas in shops Maximum permissible inlet water pressure Offices and other commercial working 800KPa 8Bar environments Minimum permissible inlet water pressure On agricultural estates 200KPa 2Bar By clients in hotels motels and other Maximum working temperature 40 C residential type environments Minimum working temperature 10 C Bed and breakfast type environments GENERAL Facts amp weight CATER Hot water tap Yes Yes Brew options Heig
6. ground coffee Make sure that the coffee is evenly spread Slide the filter holder into position A Loosen upper lid B on the serving station and then place B the serving station C Make sure that the serving station is centered with the rotation plate OPERATION Brewing with coffee CATER 1 1 Brewing 1 2 Brewing mu Pause Stop A CAUTION Do not remove serving station before display is lit with a steady light and the ready beep has been heard it can cause serious spill and burns CAUTION Do not dispense hot water while machine is brewing Push button for 2 5L push button for 1 25L A 4 E 1 1 Full brew display is blinking between all 3 lines _ When brewing starts the brewing lamp will be lit up with red light STOP PAUSE button Press the button once for pause To continue the brewing if it is in pause mode press Press the button twice to stop brewing 1 2 Half brew display is blinking between lower 2 lines When brewing is completed a 3 second beep will be heard from the machine brewing lamp will be turned off It is now safe to remove the serving station Hold a glass or jug under the water tap Lift the red handle to start dispensing hot water OPERATION Brewing with coffee Tips for keeping coffee hot Pre heat the serving stat
7. hange heating element DIMENSION SKETCH CATER SINGLE CATER 690mm 205mm 450mm 105mm 436mm 20 DIMENSION SKETCH CATER CATER 690mm 4l0Omm 450mm 105mm 436mm DIMENSION SKETCH CATER Serving Station 205 mm 273 mm 436 mm 400 mm 105 mm gt For the warranty to be valid the conditions for maintenance must have been followed according to our instructions proper precaution has been made and warranty claim been issued without delay The affected equipment may not be used during awaiting service if there is any risk that the damage or defect would worsen The warranty will not cover consumption supplies such as glassware normal maintenance such as cleaning of filters contaminations in water lime incorrect voltages pressure or adjustment of water amounts The warranty will not cover damages of defects caused by incorrect handling and operation of
8. ht Width Depth 2 690 205 450mm 690 410 450mm Tank volume Power supply 2 5L 220 230 2200 W 50 60Hz 2x 2 5L 400V 2N 4400 W 50 60Hz Capacity Cold water connection Y External thread 17 cups 6 minutes Hot water 20 L hour Y External thread 34 cups 6 minutes Hot water 20 L hour Serving station 1x2 5L 2x2 5L SINGLE CATER 15 kg CATER 24 kg Coffee brewer with automatic water supply Equipped with a separate tap for hot water Brewing in a removable serving station Brewing in paper filters Brew time is about 5 6 min OVERVIEW OF COMPONENTS CATER Function Buttons Hot Water Tap Filiter Holder Serving Station Lid Carry Handle 8 Serving Station R Level Tube le Tap for Coffee Drip Tray Insert Drip Tray QUEEN OVERVIEW OF COMPONENTS CATER Function Buttons Hot Water Tap Filiter Holder Serving Station Lid Carry Handle Display Serving Station lavan Level Tube Tap for Coffee Drip Tray Insert Drip Tray OVERV
9. ion start a brewing with only water into the serving station When brewing is complete let it stand for about hour Pour out the water Then start a brew with coffee CATER To keep temperature and aroma put the lid A back on the serving station immediately after the brewing A IMPORTANT The temperature in the serving station will decrease with 1 5 C h There is 30ml of coffee standing the tubes from the inner container to the coffee faucet This part is not insulated and will drop in temperature much faster If the serving station haven t been used in Ih the first cup can be lower temperature Cups after the first will not be affected of this Do not change the recommended portion of coffee Do not mix freshly brewed coffee with old coffee Always rinse the serving station before next brew Empty the filter holder from filter and coffee grounds directly after a brew Dispense 50ml of coffee every hour to always have fresh and hot coffee to the faucet CLEANING AND CARE CATER Before each brewing Rinse the serving station with fresh tap Rinse serving station and filtre holder water with hot water Outside cleaning use soft rag with liquid cleaning agent to prevent scratches Clean the bottom plate A Clean the spray nozzle B and the surrounding
10. ns a increase water temp and O decrease water temp Confirm the new settings by pressing the button 70 C min temperature 96 C max temperature Press buttons a and at the same Off 6 25 5 time for 5 seconds until you hear 3 beeps 20 4 The display shows the current setting 15 3 Adjust with the buttons WS 2 increase 5 and 0 0 5 1 decrease 10 2 15 3 Confirm the new settings by pressing the 20 4 button 25 5 CATER MESSAGE SHOWN ON DISPLAY A IMPORTANT LEVEL CONTROL Error message Display shows El E2 E4 All maintenance and installations must be done of an authorized technician shown on the display The water high level sensor is triggerd before the low level sensor Clean the level sensor Change the level sensor Cables connected is incorrectly shown on the display Filling time too long Poor water pressure Water tap is not open Restart machine TEMPERATURE CO TROL shown on the display Temperature sensor out of range Temperature sensor is broken Cable loose 5 C 105 C Replace shown on the display Heating time is too long Solid state broken Element broken High limit control defect Restart the machine Change solid state C
11. ortant information may appear in textboxes seen below A CAUTION More INFO INFO INFO INFO 31 GENERAL CATER Thank you for choosing a CATER coffee brewer We hope you enjoy it Read the user guide before using the machine Always keep this guide close at hand for future This guide contains important instructions for reference proper and safe use of the vending machine a Never immerse the machine plug or mains Do not use the machine if the mains cable plug cable in water because there is a danger of is damaged or the machine has fallen down electric shock If the mains cable is damaged it must be The appliance is not intended for use by replaced by the manufacturer service agent or persons including children with reduced similarly qualified persons in order to avoid a physical sensory or mental capabilities or hazard lack of experience and knowledge unless they Only plug the machine into a properly installed have been given supervision or instruction earthed safety socket whose line voltage concerning the use of the appliance by a person matches the technical data for the machine responsible for their safety Children should be supervised to ensure they do not play with the appliance Do not use the machine outdoors so it can be Place the machine out of the reach of children exposed to weather rain snow frost It will Position the mains cable so that p
12. the appliance FOR SERVICE Please contact your dealer Your Dealer INTERNATIONAL www creminternational com
Download Pdf Manuals
Related Search