Manual (english)
Contents
1. User s manual Par 56 short with LED RGB VARYTEC Table of content E Dalely INSIUCHONS sais tacos ae ond a a a et A ace ane ee aa eae ee 2 1 Sand alone incida 2a DMA MOG meme eee tee ON As Technical Dala dos alcala ctrl ainia Did 2 9 VARYTEC 1 Safety instructions FOR SAFE AND EFFICIENT OPERATION Be careful with heat and extreme temperatureAvoid exposing it to direct rays of the sun or near a heating appliance Not put it in a temperature bellow 41 F 5 C or exceeding 95 F 35 C Keep away from humidity water and dust Do not place the set in a location with high humidity or lots of dust Containers with water should not be placed on the set Keep away from sources of hum and noise Such as transformer motor tuner TV set and amplifier To avoid placing on un stable location Select a level and stable location to avoid vibration Do not use chemicals or volatile liquids for cleaning Use a clean dry cloth to wipe off the dust or a wet soft cloth for stubborn dirt If out of work contact sales agency immediately Any troubles arose remove the power plug soon and contact with an engineer for repairing do not open the cabinet by yourself it might result a danger of electric shock Take care with the power cable Never pull the power cable to remove the plug from the receptacle be sure to hold the plug When not using the player for an extended period of time be sure to disconnect t2. ety relating and machine technical installations are inspected by a skilled person once a year 1 Make sure before installing that all screws are tightly connected and not corroded 2 There must be no deformations on the housings fixations and installations spots 3 No damages must be showed on the power supply cables material fatigue and sediments If the device is going to be cleaned please use moist lint free cloths Never use alcohol or solvents The cooling fan must be cleaned monthly To clean the interior of the device please use a vacuum cleaner or an air jet We recommend cleaning the lenses weekly to keep the light output as long as possible 2 Operations 2 1 Stand alone function The stand alone function is automatic activated when the dipswitch 10 is in the ON position and every other dipswitch is in the OFF position In this mode you can run this fixture without any external controller a Music control If the dipswitch 10 is in the ON position and every other dipswitch is OFF the fixture reacts to music impulse The sensitivity can be adjusted with the sensitivity knob on the back O 5 9 VARYTEC b Automatic colourchange If the dipswitches 9 and 10 are ON the fixture is in the automatic colour change mode The speed of the colour change kann be adjusted with the dipswitches 1 to 7 O gt Slow SPEED Fast Pils c Manual mode If the dipswitches 8 9 and 10 are ON the
3. fixture is in the manual mode Dipswitch 1 and 2 adjust the Intensity of red Dipswitch 3 and 4 adjust the Intensity of green Dipswitch 5 and 6 adjust the Intensity of blue ee O R FIG 3 3 DMX Mode Connect the signal out of you controller with the XLR in plug on the fixture On the XLR out you can connect other DMX controllable fixtures DMX OUT DMX IN With the dipswitches 1 to 9 you can adjust the dmx address by using the binary system O DMX Address 6 9 VARYTEC The item works with 6 dmx channels CH 6 IR G B MACRO Specaistrobe MODE 17255 Dimmer 1 255 Dimmer 1 255 Dimmer EE Lighteness decreasing 32 63 16 255 ON 16 255 ON 16 255 ON FADE OUT 0 15 OFF 0 15 OFF 0 15 OFF Lighteness increasing 64 95 16 255 ON 16 255 ON 16 255 ON a FADE IN 0 15 0FF 779 0 255 FADE OUT 16 255 ON 16 255 ON 16 255 ON SPEED amp INmode 96 127 E Es 0 255 0 255 0 255 NA NA NA 0 255_NA 4 Technical Data Power supply max 230 240V AC 50Hz Max consumption max 20W 7 9 VARYTEC VARYTEC Importeur B amp K Braun GmbH Industriestra e 1 D 76307 Karlsbad www bkbraun com info bkbraun com
4. he plug from the receptacle 3 9 1 1 Overhead Rigging This ltem must be built in a way that it can hold 10 times more of its weight for 1 hour without causing any damages The installation must be secured with a secondary safety attachment The safety attachment has to be constructed in a way that no part of the installation can fall down When rigging de rigging or servicing the fixture staying in the area below the installation place on bridges under high working places and other endangered areas is forbidden Before taking the device in operation the installation must be approved by an expert The operator has to make sure that safety relating and machine technical installations are approved by a skilled person once a year Procedure The Device must be installed outside areas where persons may walk by or be seated IMPORTANT OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE including but not limited to calculating working load limits installation material being used and periodic safety inspection of all installation material and the projector If you lack these qualifications do not attempt the installation yourself but instead use a professional structural rigger Improper installation can result in bodily injury and or damage to property Use only professional trussing systems if the ltem shall be lowered from the ceiling or high joists Never let the Device swing freely in a room Caution Overhead Items may cause seriou
5. s injuries when crashing down If there is concern about the safety then DO NOT INSTALL the Device DANGER OF FIRE When installing the device make sure there is no highly inflammable Material decoration articles etc within a distance of min 0 5 m Mount the projector with the mounting bracket to your trussing system using an appropriate clamp For overhead use always install a safety rope that can hold at least 12 times the weight of the fixture You must only use safety ropes with quick links with screw cap Pull the safety rope through the hole in the mounting bracket and over the trussing system or a safe fixation spot Insert the end in the quick link and tighten the safety screw The maximum drop distance must never exceed 20 cm A safety rope which already held the strain of a crash or which is defective must not be used again Adjust the desired inclination angle via the mounting bracket and tighten the fixation screws DANGER TO LIFE Before taking into operation for the first time the installation has to be approved by an expert 4 9 VARYTEC 1 2 Power Connection II CAUTION Never leave this device running unattended Every person that is involved with this Item has to be qualified Connect item with the main plug The voltage and frequency must exactly be the same as stated on the device The power plug must always be inserted without force 1 3 Cleaning and Maintenance Please make sure that saf
Download Pdf Manuals
Related Search