User Manual www.teka.com
Contents
1. connection if present The cooktops fitted with a tripolar electrical supply cord are designed to be used with alternating current according to the indications on the rating plate located under the cooktop The earthing wire can be identified by its yellow green color In the case of installation over a built in electric oven the electrical connections for the cooktop and oven should be independent not only for safety purposes but also to facilitate removal of one or both in the future The power supply cord must be positioned so that it does not reach a temperature in excess of 50 C above room temperature at any point Before actual connection make sure that The fuse and electrical system is equipped with an efficient earth connection according to the norms and regulations prescribed by law That the electrical supply system is equipped with an efficient earth connection according to the norms and regulations prescribed by laws That the plug or switch are easily accessible Important the wires in the mains lead are coloured in accordance with the following code Green amp Yellow Earth Blue Neutral Brown Live As the colours of the wire in the mains lead may not correspond with the coloured markings identifying the teminals in your plug proceed as follows ER or coloured Green or Yellow Connect the Brown wire to the terminal marked L or coloured Red Connect the Blue wire to the termin2. stable Check to make sure that The bottom of the cookware is perfectly flat The cookware is centered correctly on the burner or the electric hot plate e The support grids have not been inverted 8 customer service In case of malfunction of your appliance you may eliminate the problem by following Ts there a problem If it persists please contact your dealer or nearest authorized service department by telephone or mail indicating the following information 1 Your name telephone number and communication address 2 The model number and serial number of your machine 3 Description of the fault User Manual 5 Practical advice To maintain the EFFICIENCY and SAFETY of this appliance we recommend Call the Service Centers authorized by the manufacturer Always use original Spare Parts This manual is for a class 3 built in cooktop This appliance is designed for non professional use in the home and its features and technical characteristics must not be modified these instructions are only valid for the countries the symbols for which appear on the manual and the serial plate the electrical system of this appliance is safe only when it is operated under current safety standards Prevent children and the disabled from coming into contact or having access to the following as they are possible sources of danger The controls and the appliance in general The packaging p
3. English Version IEKA K CHENTECHNIK Built in Glass Hob User Manual Before operating the appliance please read this manual carefully and keep itin a safe place for future reference IEKA K CHENTECHNIK MODEL www teka com GK LUX 86 3G AIAL2TR GK LUX 78 3G AI AL 2TR GK LUX 73 2G AI AL 2TR GK LUX 30 2G AI AL GK LUX 30 1GAIALTR User Manual Pages Paget User Manual 9 Detail Product Specifications Congratulations on choosing a Teka appliance which you will find dependable and easy to use We recommend that you read this manual for best performance and to extend the life of your appliance Thank you ie GR LUX 86 36 AL AL QTR GK LUA Te UG AT AL QTR Gh LUX 73 2G AL AL QTR 1 Product Overview LPG 28 mBar LPG 28 mBar LPG 28 mBar 1 1 KW 1 1 KW Auto loner Yes ts es WODEL MAME GELUY 3026 AIAL GK LUN SOTO RT ALTR rein T mBar reem 7 mBar Burner Composition 2 KW 5 KW 1 1 KW Auto Ignitor Big Burner Medium Burner Small Burner Control Knobs Top Glass maw gt Some models use 220 Volt AC Grid Burner Lid Burner Spreader Ignitor Plug Thermocouple Gas Nozzle Burner Cup TAT TE QT User Manual 2 Product Specifications Page2 Model Series GK LUX Series Gas Type LPG 28 mBar Electric gnitor Battery 1 5 V DC Safety Device Thermocouple Sensor Top Glass Tem
4. al marked N or coloured Black Paged The placement of the burner A The placement of Triple Ring 1 Place the triple ring burner properly and the spark plug must be aimed at the hole of the burner when install 2 Put burner cap outer and burner cap inter on burner properly B The Placement method of Auxiliary Burner is same as above 4 How to use your appliance The position of the corresponding gas burner or electric hot plate if present is indicated near to each control knob Gas burners The burner differ in size and power Choose the most appropriate one for the diameter of the cookware being used The burner can be regulated with the corresponding control knob by using one of the following settings Off A High Low To light the selected burner first press the corresponding knob down fully turn it anticlockwise to the high flame symbol and keep the knob pressed for approximately 2 3seconds to allow the safely device F to heat up The gas can be delivered when the valve is open To turn off a burner turn the knob clockwise until it stops it should be on the setting Caution if the flame accidently goes out turn off the gas with the control knob and wait at least Iminute before you try to light it again User Manual For best performance follow these general guidelines Use the appropriate cookware for each burner see table in order to prevent the flame from rea
5. ching the sides of the pot or pan Always use cookware with a flat bottom and keep the lid on When the contents come to a boil turn the knob to Low Burner Mcookware cm Big burner 26 28 Medium burner 16 18 Small burner 10 14
6. ented Examples of ventilatin holes Enlarging the ventilation slot for comburant air between window and floor Fig A Fig B C Intensive and prolonged use of the appliance may necessitate supplemental ventilation e g opening a window or increasing the power of the air intake system if present Page 6 How to keep your cooktop in shape Before cleaning or performing maintenance on your appliance disconnect it from the electrical power supply To extend the life of the cooktop it is absolutely indispensable for it to be cleaned carefully and thoroughly on a frequent basis keeping in mind the following The enamelled parts must be washed with warm water without using abrasive powders or corrosive substances which could ruin them The removable parts of the burners should be washed frequently with water and soap making sure to remove caked on substances On cooktops with automatic ignition the end of the ignition device must be cleaned carefully and frequently gas holes are not clogged Stainless steel can be stained if it remains in contact with highly calcareous water or aggressive detergents containing phosphorous for an extended period of time Itis recommended that these parts be rinsed thoroughly with water and then dried well it is also a good idea to clean up any spills Clean the cooking surface when itis still warm with a suitable cleaning product Then rub witha damp cloth and dry Aluminum
7. foil plastic items objects made of synthetic material sugar or foods with a high sugar content that have melted onto the surface must be removed immediately with a scraper while the cooking surface is still hot Do not use abrasive sponges or cleaning products under any circumstances Similar this holds true for chemically aggressive cleaners User Manual 7 Is there a problem It may occur that the cooktop does not function or does not function properly Before calling customer service for assistance lets see what can be done First of all check to see that there are no interruptions in the gas and electrical supplies and in particular that the gas valves for the mains are open The burner does not light or the flame is not uniform Check to make sure that The gas holes on the burner are not clogged All of the movable parts that make up the burner are mounted correctly There are no draughts around the cooking surface The flame does not stay lighted on the model with the safety device Check to make sure that You press the knob all the way in All of the movable parts that make up the burner are mounted correctly The gas holes are not clogged in the area corresponding to the safety device The burner does not remain on when set to low Check to make sure that e The gas holes are not clogged There are no draughts near the cooking surface The cookware is not
8. lastic bags polystyrene nail etc The appliance during and immediately after use given the heat generated by its use Surface will remain hot for at least a half hour after being turned off The following should be avoided Improper and or dangerous use Obstructing the ventilation or heat dissipation slots Allowing the power supply cord of small appliances to come into contact with the hot parts of the cooktop Exposure to atmospheric agents rain sun Using flammable liquids nearby Page6 Using unstable or deformed cookware Trying to install or repair the appliance without the assistance of qualified personnel The assistance of qualified personnel must be called upon in the following cases Installation in accordance with the manufacture s instruction When in doubt about the operation of the appliance Replacement of the electrical outlet because it is incompatible with the plug Contact service centers authorized by the manufacturer in the following cases When in doubt about the condition of the appliance after having removed the packing Damage to or replacement of the power supply cord In the case of a breakdown or malfunction ask for original spare parts It is recommended that you follow the guidelines below Only use the appliance to cook food avoiding all other use Check the condition of the appliance after it has been unpacked When not in u
9. next to the cook top at a height of at least 420mm Fig C mm ee Se ee ee ee Fig C d Should the hob be installed directly under a cupboard with at least 700mm from the cook top as shown in Fig C User Manual e The dimensions of the opening for the furniture must be those indicated in the table below see Fig D ee 55mm 4 i P a Figure D MODEL A mm B mm GK LUX 86 740 430 GK LUX 78 740 430 GK LUX 73 660 430 GK LUX 30 260 490 The hob can only be installed above a built in oven provided with cooling ventilation f In the event the cooktop is not installed above built in oven a wood panel must be inserted as insulation g This panel must be placed at least 20mm from the bottom of cooktop itself Important When installing the hob above a built in oven the oven should be placed on two wooded strips in the case of a joining cabinet surface remember to leave a space of at least 45 560mm at the back User Manual Gas connection for cooktop The cooker should be connected to the gas supply by a qualified installer During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing Connection of the appliance to the gas mains or liquid gas must be carried out acco
10. pered 8 mm thickness Burner Type Diameter nett Heating Power Big Burner 130mm 5 KW Medium Burner 95 mm 2KW Small Burner 56mm 1 1 KW Some Models use 220 Volt AC 3 Installation Instructions for Built in The following instructions are directed at the qualified installer so that the installation and maintenance procedures may be followed in the most professional and expert manner possible Positioning for gas hob Important this unit may be installed and used only in permanently ventilated rooms The following requirements must be observed A the room must be fitted with a ventilation system which vents smoke and gases from combustion to the outside a AAA In achimney stack or branched flue Exclusively for cooking appliances Directly to the outside B The room must also allow for the influx of the air needed for proper combustion The flow of air for combustion purpose must not be less than 2m h per kw of installed capacity The supply of said air can be effected by means of direct influx from the outside through a duct with a inner cross section of at least 100cm which must not be able to accidentally blocked otherwise the room can be vented indirectly through adjacent rooms fitted with ventilation ducts to the outside as described above as long as the adjacent rooms are not shared areas bed rooms or present the risk of fire Fig B Adjacent Room to be Room V
11. rding to the prescribed regulation in force and only after itis ascertained that it is adaptable to the type of gas to be used If connect to liquid gas use pressure regulators that conform to the regulation in force Important for safety for the correct regulation of gas use and long life of the appliance ensure that the gas pressure conforms to the indications given in table product specifications Connection to non flexible tube Copper or steel Connection to the gas source must be done in such a way as to not create any stress points at part of the appliance The appliance is fitted with an adjustable L shaped connector and a gasket for the attachment to the gas supply Should this connector have to be turned the gasket must be replaced supplied with the appliance The feeding connector of the gas to the appliance is threaded G2 gas male cylinder Connection to flexible steel tube The gas feed connector to the appliance is a threaded male G4 connector for round gas pipe and sealing gaskets that conform to the standards currently in force The maximum length of the flexible pipes must not exceed 2000mm Once the connection has been made ensure that the flexible metal tube does not touch any moving parts and is not crushed Page4 Check the seal Once the appliance has been installed make sure all the connections are properly sealed using a soapy water solution Never use a flame Electrical
12. se disconnect the appliance from the power supply if present and turn off the gas valve Always check to make sure that the control knobs are on the setting when the appliance not in use The manufacturer will not be held liable for any improper incorrect or unreasonable use Pages D Liquid Petroleum Gases LPG are heavier than air and as aresult settle downwards LPG tanks whether empty or partially full must not be installed or stored in rooms or spaces below ground level cellars etc Itis also a good idea to keep only the tank currently being used in the room making sure that itis not near sources of heat ovens fireplace stove etc that could raise the internal temperature of the tank above 50 C Installation of built in cook tops The appliance can be installed next to furniture units which are no taller than the top of the cooker hob The wall in direct contact with the back panel of the cooker must be made of non flammable material During operation the back panel of the cooker could reach a temperature of 50 C above room temperature For proper installation of the cooker the following precautions must be taken a The hob may be located in a kitchen a diner or living room but not in a bathroom or shower room b The furniture standing next to the unit that is higher than the working boards must be placed at least 600mm from the edge of the board c The cabinets should be positioned
Download Pdf Manuals
Related Search