Instruction Manual - Forestry Suppliers, Inc.
Contents
1. FIG 2 em in Switch Array 1 Each switch has a recording number to the left of it that corresponds with the bird descriptions listed on the foil label inside the cover on the front the unit they are as follows 1 Pigeon 5 Gull 2 Pigeon Il Bird Predator 6 Gull Il 3 Starling Pigeon Ill 7 Bird Predator Il 4 Sparrow 8 Bird Predator Ill For best results choose a combination of both predator calls AND bird distress recordings to create the most natural scenario The Mode Setting Switches are the last five switches FIG 3 in Switch Array 2 These set the various modes of operation such as the amount of time between playing bird distress calls when the unit will scone EE operate day only night m only or 24 hours and whether the unit will ie operate in the random M tty mode or normal mode Switch Mode or Function Sets the Time Off Period Sets the Time Off Period Sets the Time the unit plays Sets the Time the unit plays Turns Random Mode On or Off DELAY SWITCHES The two Delay or Time ee nti Off Switches are located ed just below the Recording acer Switches 1 8 in the switch array FIG 4 The unit will delay a number of seconds or minutes between recorded sounds when the unit is set to one of the various Time Off Modes The TEST setting is appropriate for testing but is NOT recommended for long term success Please note that the unit will play all of th2. 0 North Elizabeth Street e Chicago IL 60607 ph 312 226 2473 fax 312 226 2480 Toll Free US amp Canada 800 662 5021 www bird x com sales bird x com EPA Est No 075130 OR 001 C BirdXPeller Pro 1 Instructions P N 655 0049 00 BXP 1 rev H Digital Bird Repeller BirdXPeller O Important safety related information a Do not install the device during rain or snow conditions b Installation shall be made in such a way that a power supply and the internal part of the control unit never be subjected to water or snow c Note that the power supply is intended for dry location use only 1 Point the unit toward the bird infestation Expect a maximum coverage area of approximately 1 acre ina long dispersion pattern Set the unit on a flat surface or mount it to a wooden post using the mounting bracket and screws included 2 Plug one end of the AC adapter into the POWER jack located on the back of the unit Plug the adapter into any standard electrical outlet An optional battery cable may be used to connect the control unit to a 12 volt battery If this is done first connect the black battery clip to the negative terminal on the battery and then connect the red battery clip to the positive terminal Both the connection to the electrical outlet or battery and the connection of the power cable inside the control unit must be protected from dripping or splashing water Do not s
3. HIGH will increase sound output CAUTION Take care when turning the dial since the unit may be in an inactive state when the dial is rotated It could then reactivate at a very high level of sound which could be painful to your ears POWER SWITCH INT EXT SPKR The power switch enables the unit to operate Slide the switch to the INT EXT SPKR ON position to start the unit This will operate the unit and generate sound out of the unit AND out of an optional extension speaker at the same time If you wish to operate ONLY a remote extension speaker optional then move the switch to the EXT SPKR ONLY position If you turn the unit OFF be sure to leave it off for about 30 seconds before turning it back on to allow the electronics to properly reset To fully disconnect the unit unplug the power adapter from the electrical outlet or disconnect the battery cable from the 12 volt battery TROUBLESHOOTING ad 1 O Ee ee 1 OO OO e Check volume settings Unit is on e Check time of operation settings but no sound is heard e Check that at least one bird is selected to play Unit is oN but plays the e Reset the unit by turning it off for same bird over and over 30 seconds and then back on regardless of settings e Double check Mode switch settings Unit is not operating e Make sure photocell is not properly in the obstructed DAY or NIGHT mode e Make sure the photocell is not affected by bright lights in either the fr
4. e selected recordings either sequentially or non sequentially depending on the Random Mode then it will go into a delay The time the unit stays off depends on the Time Off and the Random Mode Settings If the unit is operating in Random Mode the unit will delay anywhere from the minimum value to the maximum value for that Time Off setting If the unit is not in Random Mode it will delay only the minimum value akWND To set the Time Off period or delay interval use the following settings on switches 1 and 2 in the Mode Function Settings Switch 1 Switch 2 Time Off Period ON OFF Test 17 50 sec OFF ON Medium 1 4 min ON ON Long 5 10 min OFF OFF X Long 10 30 min The two Time of Operation switches are located just under the Time Off tcc Switches in the switch array FIG 5 The unit E a will operate day only night only or continuously 24 hours However the photocell that senses the sunlight is susceptible to bright lights Take care not to have bright lights shining toward the front of the unit since this can prevent the unit from operating properly To set the time period for the unit to operate set switches 3 and 4 in the Mode Function settings to the following Switch 3 Switch 4 Mode ON OFF Day Only OFF ON 24 Hour ON ON Night Only OFF OFF Night Only RANDOM QPERATION SWITCH The Random Operation Switch is the bottom switch in the switch array FIG a ee unit will randomly p
5. et an object filled with liquids on the control unit 3 Set the DIP switches located on the front metal faceplate of the unit see Switch Array 1 and Switch Array 2 to the desired settings See the section Programming your BirdXPeller PRO for specific programming information 4 Turn the volume switch to LOW Minimum 5 Turn the power switch located in the upper right hand corner of the faceplate to INT EXT SPKR ON position NOTE The unit may take a couple of seconds before starting 6 Adjust the volume to the desired level 7 After turning the unit OFF be certain to wait AT LEAST 60 SECONDS before turning it back on 8 Close the cover and latch shut Ensure that the cover is properly latched closed and do not open the cover during rain or other conditions that would expose the inside of the control unit to water PROGRAMMING YOUR BIRDXPELLER RECORDING To program your Switches 1 8 BirdXPeller PRO unit you will need a small screw driver toothpick or other pointed rigid object to Pa move the switches in the i 4 switch array see FIG 1 The switch arrays are the switch banks located in the bottom right hand corner on the faceplate inside the clear front cover A switch is ON if the switch is moved to the right hand side The switch is OFF if the switch is moved to the left hand side BIRD RECORDIN ETTING SWITCHE The Bird Recording EES Switches are the first nee eight switches
6. ings can carry many diseases use extreme caution when removing them Do not breathe or come into direct contact with them If you have questions about how to do this safely consult an expert Adult birds are likely to return to their young in order to protect them or to assist them in leaving the area Remove food spillage garbage nesting material and other appealing items Survey the birds to determine flight and time patterns entries and exits and nesting feeding and roosting habits This will suggest the unit placement speaker direction and time of operation you should choose Make educated guesses as to where the birds will go when they are repelled from their current infestation and consider additional units to cover these alternative areas Maintain a clean and changing environment Periodically clean the area of nests and droppings relocate or reposition the unit vary the output or turn off the unit for a short time Install early before bird season begins as it is easier to keep the birds away than to rout them out once they have established a living pattern Use products synergistically Two or more different kinds of devices this repeller plus a visual scare product and or a roost inhibiting device will produce a synergistic effect i e in combination the products will yield much greater effectiveness than the one alone Contact us for information on companion products Uw BIRD XDJ 30
7. lay the selected recordings in non sequential 2 order when operating in RANDOM Random Mode When the unit is not operating in the Random Mode the unit will play the selected recordings in a sequential order The Random Mode is recommended to keep birds from adapting to a preset pattern of sounds To operate the unit in Random Mode set switch 5 as follows Switch 5 Mode ON Random mode ON OFF Random mode OFF PROGRAMMING EXAMPLE Bird Recording Switches Results 1 3 5 and 6 to ON position Plays Birds 1 3 5 amp 6 Mode Switches 1 OFF position 2 ON position Medium every 1 to 4 minutes 3 ON position 4 OFF position Operates during daylight hours only 5 ON position In random non sequential order VOLUME CONTROL The unit has a volume control dial on the front panel of the unit Turning the dial toward LOW will reduce sound output and rotating the dial toward
8. ont or the back of the unit e Check battery condition Unit does not function a e Turn power switch on the unit to properly when connected the OFF position Reconnect the battery wait 30 seconds then to a 12 volt battery switch the unit back on Limited Warranty This BirdXpeller Pro unit is warranted against defects in material and workmanship for six months from date of purchase extended warranty available Bird X will replace or repair provided defect occurs under normal use Returns accepted only with authorization from our Chicago office Successful Long Term Behavior Modification Product success takes time to build Bird and pest habits may take several days or weeks to break Follow all suggestions for maximum efficacy Instant tests do not replicate natural conditions and give no indication of the unit s success with the infestation Prepare for Successful Bird Control Bird X Inc has been recognized worldwide as the bird control x perts for 40 years We have become experts through extensive experience and research As a result we are happy to analyze problems and make reommendations based on each customers specific situation and needs In addition we provide the following recommendations for greatest success even before activating the repeller Remove inducements Clean the area of all evidence of birds nests fledglings droppings dead birds and the residential scent Because birds and their dropp
Download Pdf Manuals
Related Search