User Manual - DAZA Opticare
Contents
1. is turned on This will prevent falls alarms when the sensor is turned on Switch off 1 Turn the sensor off by setting the switch to position 0 1 is on 2 If applicable set the alarm on the care system telephone nurse call system Between detection of movement and activation of the transmitter there is a delay of 2 seconds This gives you the chance to deactivate the sensor before the transmitter is activated It is possible to extend this delay by an extra 3 or 5 seconds You can do this by moving jumper 2 to position three or five figure 3 Battery replacement D When the yellow LED on the rear illuminates every 2 or 3 seconds the battery must be Never touch the element replaced as soon as possible Only replace it with a 3 6 Volt lithium cell of size 1 2 AA mj E Jumper 2 Correct operation can only be guaranteed when an original battery is used a Tadiran brand type TL2150 20 Jumper 1 Remove the four screws on the rear of the pedestal Replace the battery as shown in the drawing with the positive terminal down After closing the pedestal of the sensor the sensor will require 2 to 5 minutes to calibrate This is indicated by the regular illumination of the red light behind the sensor lens Battery NEVER TOUCH THE ELEMENT IN THE SENSOR Figure 3 Battery placement Daza Opticare BV follows a policy of continuous improvement in the development of its products The technical data can therefore b2. 1009 1109 CE x Wireless Optiscan 2014 04 29 V1 0 User Manual General This wireless Optiscan detects when a person intends to leave the bed It includes a built in transmitter that communicates directly with your carephone or nurse call system This transmitter must be configured to the carehone nurse call system before you can use the sensor By switching the sensor on and off three times briefly in succession you can automatically enable the sensor to send an alarm Because some carephones require a call to be made 2x in succession the transmitter will have to be activated twice Installation and use Place the sensor on the floor facing the bed figure 1 Make sure that the sensor is placed safely where it can cause no harm to the inhabitant for example underneath a chair or table It is highly preferable to place it at a distance of at least 2 meters from the bed The sensor has a 90 degrees field of view over a distance of approximate 7 meter Make sure that no objects are in front of the sensor that can block its view figure 2 Switching on T 1 Switch on the sensor by placing the switch on the back of the sensor to position ok 4 u 0 iS off L 2 Leave the room ie 3 The sensor switches itself on automatically once no movement across the floor o 0 has been detected for 15 seconds Figure 2 Viewing angle sensor Note The sensor will not transmit any alarms in the first 5 seconds after the sensor
3. e changed without notice This product is classified as an electrical and electronic device When you decide to discard this product please ensure that this is done accordance with the European Directive on Waste Electrical and Electronic Equipment WEEE and compliant with local laws relating to this directive Page 1 of 1
Download Pdf Manuals
Related Search