Wind `N Go® UltraLight Weather Alert Radio #7301
Contents
1. Use the lt lt gt gt buttons to set the time in minutes NOTE If the battery drains the clock will not function CELL PHONE CHARGING using a USB compatible cell phone charger not included 1 Press the CELL button until the USB symbol is shown in the LCD display 2 Plug the CELL PHONE ADAPTER CORD into the CELL PHONE OUTPUT identified by the cell phone icon on the protective rubber input cover 3 Plug the other end into your cell phone s USB compatible charger Charging will begin immediately if the units battery is charged or when winding the dynamo hand crank TROUBLESHOOTING In the event the LCD DISPLAY becomes faint or inoperable the unit may need to be reset To do so press the reset button with a small pointed object Power off the unit and restart For all other questions or replacement batteries consult the manufacturer TECHNICAL INFORMATION SPECIFICATIONS INTERNAL RECHARGEABLE BATTERY Lithium ion 3 7V 800mAh 500 1000 cycles FLASHLIGHT 1 2 Watt LED 10 000 hours 20 lumens 120V AC or 12V DC CHARGER not included 5V 1A Available at electronics stores DC INPUT 5V DC 300mA 3 5 Lx 2 38 W x 6 94 H 175 x 63 5 x 62 5mm After winding for 20 30 minutes 30 45 minutes 3 5 minutes 30 45 minutes 2 3 minutes talk time When fully 5 6 hours 6 8 hours 45 60 minutes 3 4 hours charged using talk time USB 120V or 12V depending on cell charger phone model RADIO BANDS AM 525 1710 Khz FM2. 87 5 108 Mhz NOAA Weather Band Stations Log onto www nws noaa gov for the frequency transmitted in your area 162 40 Mhz 162 42 Mhz 162 45 Mhz 162 47 Mhz 162 50 Mhz 162 52 Mhz 162 55 Mhz C FE AERVOE INDUSTRIES INC Gardnerville NV 89410 1 800 227 0196 www aervoe com mailbox aervoe com Wind N Go is a registered trademark of Aervoe Industries Inc 7301inst cs11 12 UltraLight Weather Alert Radio OPERATING INSTRUCTIONS FLASHLIGHT PLUS AM BAND FM BAND 7 WEATHER BAND STATIONS NOAA WEATHER ALERT
3. Wind N Go UltraLight Weather Alert Radio 7301 IMPORTANT SAFEGUARDS Read all instructions before operating Do not look directly at the light may cause injury Do not use in flammable or explosive environments Do not operate at temperatures above 120 F Avoid placing siren near the ears when using the siren To reduce the risk of electric shock do not submerge the unit or its accessories in any liquid Unit is water resistant but not waterproof Turn off all lights and radio features before charging For maximum battery efficiency never completely deplete stored power Store in a clean dry place when not in use Administer close supervision when using around children e o o o o o e o o o Note This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one of mo
4. es will yield a longer power duration Close the HAND CRANK when done USB 120V AC or 12V DC Charging 120V amp 12V adapters not included The USB adapter may be used to charge the unit directly from any USB power source An optional method requires a USB compatible 120V AC or 12V DC adapter available from your local electronics store 1 Plug the male pin tip on the USB CHARGE CABLE into the DC INPUT port of the unit and then plug the adapter into a USB port 2 If using the optional 120V or 12V adapters connect either one to the USB end of the USB CHARGE CABLE and into any electrical outlet or vehicle power receptacle 3 Charging will begin when connected The CHARGING INDICATOR above the Dynamo Handle will illuminate To avoid damage to the battery and circuit disconnect the adapter after charging OPERATION the battery meter should have at least 1 bar Flashlight Press the FLASHLIGHT ON OFF button to turn the flashlight on and off AM FM NOAA Weather Band Radio 1 Extend the ANTENNA to obtain the best reception 2 Press the POWER button on the front to turn on and off 3 Select either the AM FM or Weather band pressing the BAND button The radio station and radio band will appear on the backlit LCD SCREEN When choosing the Weatherband mode you will need to identify which frequency receives your local weather report 4 Adjust the volume by pressing the VOL VOL buttons 5 Tune to the desired station using the lt lt g
5. re of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation PARTS IDENTIFICATION Antenna Flashlight ON BACK Charging Indicator Light A Red Flashing LED Glow Ring Reset Button Flashlight ON OFF Frequency __ Selector Tuning Volume _ _ Radio ON OFF Backlit LCD Siren Hand Crank DC Input amp Cell Phone Charging Out Port Wrist Strap Speaker CHARGING THE BATTERY Before first use open the battery compartment cover and attach the battery with the provided connector Seat into the battery compartment and replace the cover Before charging turn off all light and radio features The BATTERY METER in the LCD display will appear during charging or when using the flashlight or radio Dynamo Charging Open the HAND CRANK and rotate clockwise at approximately 120 cycles minute for a minimum of one minute A CHARGING INDICATOR LIGHT will illuminate above the hand crank Longer wind up tim
6. t gt tuning buttons Cycle through the frequencies by pressing repeatedly Or scan the frequency for the next audible station by pressing and holding the up or down button for a few seconds then releasing Repeat to hear the next audible station NOAA weatherband information is listed on the back page Weather Alert Mode The Weatherband Alert mode when set will automatically turn on the radio when any emergency alert from NOAA is activated in your area In this mode it is recommended that you use a continuous source of power such as an accessory 120V AC charger to ensure the unit is always charged 1 Turn the radio on and press the ALERT button The ALERT symbol will flash in the LCD Display The radio is now on Stand By and will turn on and tune in to the weather band station currently broadcasting an emergency NOAA alert including an Amber Alert 2 To deactivate press the BAND button again to return to normal radio listening 3 To learn more about the NOAA and emergency alerts visit www nws noaa gov nwr Siren and Flashing Red Light Press the SIREN button on the front The high volume emergency siren will sound and the red LED on the back will blink Clock To set the clock turn off all other functions first Press and hold the BAND button until the Hours are blinking in the display Use the lt lt gt gt buttons to set the time in hours Press and hold the BAND button again until the Minutes are blinking in the display
Download Pdf Manuals
Related Search