User Manual User Manual
Contents
1. Temperature limiter www AvantcoEquipment com EQUIPMENT User Manual VANTCO Exploded Parts Diagram HDS100 amp HDS200 24 Rear board 25 Steam plate 10 Thermostat knob 11 Thermostat 12 Pipe plug 26 Steam plate handle 13 Pipe supporting plate 27 Cabinet 14 Switch off thermostat NO PART NAME QTY NO PART NAME QTY 1 Handle 2 15 Terminal block 1 2 Top cover 2 16 Rear bar 1 3 Top cover holder 1 17 Wire buckle 1 4 Glass 2 18 Power cord 1 5 Separation plate 1 19 Foot 4 6 Hot dog supporting plate 1 20 Lower bracket 2 7 Bun supporting plate 1 21 Heating element 1 8 Front panel 1 22 Bun rack 1 9 Power switch 1 23 Hot dog rack 1 1 1 1 1 1 1 1 1 6 www AvantcoEquipment com EQUIPMENT VANTCO User Manual Limited Warranty All equipment which is sold under Avantco trademark and used for commercial purpose is warranted against defects in materials and workmanship The warranty runs for six months from the date of original installation and is for the benefit of the original purchaser only All other Warranties Expressed or Implied Statutory or Otherwise including Without Limitation any implied Warranty of Merchantability or Fitness for Purposes are excluded The Seller shall in no event be liable for direct indirect or consequential damages in connection with Avantco commercial products This warranty is not effective if damage occurs because of accident carelessness improper installation lack of p2. AVANTCO User Manual Hot Dog Steamer CE Model FH 01 FH 02 Models HDS100 HDS200 Please read and keep these instructions Indoor use only www AvantcoEquipment com 1 EQUIPMENT User Manual VANTCO BEFORE USE PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Specifications Capacity Wattage Weight Dimensions HDS100 100 hot dogs 48 buns 120V 1300W NEMA 5 15P 27 Ibs 18 5 W x 14 D x 16 H HDS200 200 hot dogs 48 buns 120V 1300W NEMA 5 15P 35 Ibs 18 5 W x 14 D x 20 H Explanation of Graphical Symbols AN RISK OF FIRE OR ELECTRIC SHOCK DO NOT OPEN WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user It provides a warning for the presence of uninsulated dangerous voltage within the product s enclosure This voltage may be of sufficient magnitude to constitute a risk of fire or electric shock to persons Important Safeguards When using electrical appliances the following safety precautions should be followed The exclamation point within an equilateral triangle is intended to alert the user of important operating and maintenance instructions accompanying the appliance 1 Read all instructions 2 Do not touch hot surfaces The surfac
3. es are liable to become hot during use 3 To protect against electrical shock do not immerse cord plugs or the base in water or other liquid 4 Close supervision is necessary when any appliance is used by or near children 2 www AvantcoEquipment com 10 11 12 13 14 EQUIPMENT VANTCO User Manual Unplug from outlet when not in use and before cleaning Allow to cool before putting on or taking off parts Do not operate any appliance with a damaged cord or plug after the appliance malfunctions or after any additional damage Return appliance to the nearest authorized service facility for examination repair or adjustment The use of accessories not recommended by the appliance manufacturer might cause injuries Do not use outdoors This appliance is for commercial use Do not let cord hang over edge of table or counter or touch hot surfaces Do not place on or near a hot gas or electric burner or in a heated oven Extreme caution must be used when moving an appliance containing hot oil or other hot liquids Only use this appliance for its intended use Avoid scratching the glass door or nicking edges Upon delivery if your door has a scratch or nick contact customer service before using the streamer The tempered safety glass door is more resistant to breakage than traditional glass The appliance is off when power switch control is in the off position Before Using Your Hot Dog Steamer Prior to you
4. n on the streamer and set the thermostat control to the highest setting until steam is generated 16 After stream is produced turn back the thermostat control to 130 F 17 Position hot dogs on the smaller left compartment and buns on the wire rack in the right compartment Allow adequate room around the hot dogs and buns to enable stream circulation 18 Control the bun compartment s steam by adjusting the humidity control lever located in the bun compartment under the wire rack 19 Keep the lids closed when not serving 20 Add hot water as needed to maintain the water level Do not let the unit burn dry If burned dry turn off the unit and allow it to cool completely Adding water to a dry hot unit could cause damage to the parts Cleaning and Maintenance To maintain proper sanitation this hot dog steamer must be cleaned daily Stainless steel is corrosion resistant but to elongate your product s life and service quality it should be cleaned after each use 1 Unplug the power cord from the electrical outlet Allow the unit to cool completely 2 3 Remove remaining hot dogs and buns 4 Drain water via the drain pipe accessible on the operator s side 5 Detach all removable parts bun rack perforated trays steam control lever partition and glass panels Thoroughly clean the unit and parts Do not immerse the unit in water or other liquids Liquids could enter the electrical compartment and cause a short circuit
5. or electrical shock 6 Do not store unit with water in the reservoir ye im Attack tough grease oil and carbon with this ready to use decarbonizer 4 N OBLE FORMULA D and degreaser Its unique formula is designed to clean ovens grills LEAL hoods and a wide variety of other surfaces Using Your Steamer To start your streamer push the power switch Allow 15 45 minutes to preheat the streamer depending on the water volume and temperature For quick steam turn the thermostat to max and use hot water To receive the best results do not load the maximum capacity of hot dogs and buns at once Instead allow steam to circulate the food 4 www AvantcoEquipment com EQUIPMENT VANTCO User Manual Temperature Control Knob This thermostatic switch controls the temperature inside the steamer from 95 175 F Turn the thermostat knob to adjust for your desired temperature Troubleshooting Guide PROBLEM POSSIBLE CAUSE SOLUTION Condensation on glass Cool air coming in contact with the Do not place the unit near cool air warm steamer vents Burnt hot dog casing Generating too much steam Turn the thermostat down to a lower setting Soggy buns Generating too much steam Adjust the steam control level Dry buns Not generating enough steam Adjust the steam control level and check the water level Hot Dog Steamer Circuit Diagram HDS100 amp HDS200 Switch Thermostat Resistance Heater Power light
6. r first use follow these instructions l Zi U SF et eS SS l1 12 13 14 Remove the steamer and all parts from the box Place the unit on a flat sturdy surface facing forward with the dial on the left hand side Open the two top flaps and remove all parts and packing foam Set the parts aside Before the first time use all parts should be properly washed and sanitized Slide in the back and front panel of window glass Ensure the valve drain cap is tightly screwed close Pour 6 qt of hot water into the unit s base This should cover the heating elements DO NOT OVERFILL After inserting the water place the perforated rectangular base on the left side of the unit On the right side of the unit place the square base plate with the control lever Separate the two sections by sliding the partition piece into the left slots Place the hot dog rack in the left compartment Ensure the rack is elevated by its feet for proper circulation of steam Place the bun rack in the right compartment Place the lid beam in the middle of the unit s open top Place the two lids on the unit s edges and beam Adjust the beam as needed Plug the unit into a grounded and properly sized electrical outlet to minimize shock and fire hazards For further specifications refer to the electrical requirements outlined on the serial tag on the operator s side of the unit www AvantcoEquipment com 3 EQUIPMENT User Manual VANTCO 15 Tur
7. roper set up Supervision when required or if the equipment is installed or operated in any manner contrary to the installation and operating instructions Work performed by unauthorized personnel or unauthorized service agencies voids this Warranty This warranty does not apply to and Avanico is not responsible for any warranty claims made on products sold or used outside of the United States www AvantcoEquipment com 7
Download Pdf Manuals
Related Search