User Manual for Battery Pack for VFI RM
Contents
1. O PowerWalker User Manual for Battery Pack for VFI RM 1 Important Safety Warnings Please comply with all warnings and operating instructions in this manual strictly Save this manual properly and read carefully the following instructions before installing the unit Do not operate this unit before reading through all Safety information and operating instructions carefully e Do not try to repair the unit yourself contact your local supplier or your warranty will be void e To eliminate any overheating of the battery box keep all ventilation openings free from obstruction and do not place any foreign objects on top of the battery bank Keep the battery box 20 cm away from the wall e Make sure the battery box is installed within the proper environment as specified 0 40 C and 30 90 non condensing humidity e Do not install the battery box under direct sunlight Your warranty will be void if the batteries fail due to overheating e This battery box is not designed for use in dusty corrosive and salty environment e The warranty for this battery bank will be void if water or other liquid is spilt or poured directly onto the battery box Similarly we do not warrant any damage to the battery box if foreign objects are deliberately or accidentally inserted into the battery box enclosure The battery will discharge naturally if the system is unused for a period of time It should be recharged every 2 3 months if unused I2. mounted or placed vertically on the desk Rack Installation Connecting with UPS and Other Battery Box Follow below installation chart to connect with UPS and other battery box with included cable 2 battery b 3 Storage amp Maintenance attery DOX The unit contains no user serviceable parts If the battery service life 3 5 years at 25 C ambient temperature has been exceeded the batteries must be replaced In this case please contact your dealer Be sure to deliver the spent battery to a recycling facility or ship it to your dealer in the replacement battery packing material Storage Before storing charge the unit 4 hours Store the unit covered and upright in a cool dry location During storage recharge the battery in accordance with the following table Storage Temperature Recharge Frequency Charging Duration 25 C 40 C Every 3 months 40 C 45 C Every 2 months
3. f this is not done then the warranty will be null and void During normal operation the batteries will be automatically remained in charged condition Servicing of batteries should be performed or supervised by trained personnel with knowledge of batteries and the required precautions When replacing batteries it is necessary to replace ALL batteries with the same quantity type amp capacity CAUTION Do not dispose of battery or batteries in a fire The battery may explode CAUTION Do not open or mutilate the batteries The electrolyte from the batteries is toxic and harmful to the skin and eyes CAUTION Risk of Electric Shock Hazardous voltage may exist between battery terminals and ground Test before touching with bare hands CAUTION A battery can present a risk of electrical shock and high short circuit current The following precaution should be observed when working on batteries Remove watches rings or other metal objects Use tools with insulated handles Wear rubber gloves and boots Do not lay tools or metal parts on top of batteries Disconnect charging source prior to connecting or disconnecting battery terminals Do not plug or unplug the battery connector if UPS works in DC discharging mode U BKB GW N e 2 Installation and Setup NOTE Before installation please inspect the unit Be sure that nothing inside the package is damaged Please keep the original package in a sa
4. fe place for future use 2 1 Rear Panel View DC connector connects to either UPS or 2 battery box DC breaker Battery over current protection breaker External battery numbers detection port detects the numbers of connected batteries 2 2 Installation and Setup with UPS Unpacking amp Inspection 1 Remove the battery box from the packing Note The battery box is very heavy be cautious when unpacking and lifting the unit to avoid injury 2 Check the inside package H maar es anig Battery connection cable Battery connection cable x 1 Detection cable x 1 Detection cable Earx2 amp screwx8 T Extended stand Ears oe PP 3 Extended stand Selecting Installation Position It is necessary to select a proper environment to install the unit in order to minimize the possibility of damage to the battery box and extend the life of the batteries Please follow the instructions below 1 Keep at least 20cm 8 inches clearance from the rear panel of the unit from the wall or other obstructions 2 Do not block the air flow to the ventilation openings of the unit 3 Please ensure the installation site environmental conditions are in accordance with the unit s working specifications to avoid overheat and excessive moisture 4 Do not place the unit in a dusty or corrosive environment or near any flammable objects 5 This unit is not designed for outdoor use This unit can either be
Download Pdf Manuals
Related Search