Photocell beam sensor and flash lamp User Manual (PF5103)
Contents
1. Photocell beam sensor and flash lamp User Manual PF5103 I Technical Specification Working voltage 12 24VAC DC Working current 24VDC emitter lt 15mA_ receiver lt 30mA Photocell wavelength 940nm Angle of opposite emission lt 52 Receiver range 212m Working temperature 202 60 C Relay contact loading capacity 1A 30VDC Waterproof grade IP54 Can connect external flash lamp signal 12V 24VAC DC LED can flashing 10 Size 127 50 35mm WO CON DM HB WHN PR ll Safety Instruction 1 For security please read the user manual carefully before initial operation 2 This photocell is without any fuse so Please make sure the power is off before installation 3 Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated 4 Please guarantee the products used in effective working range lll Picture Display Receiver Emitter LIGHT ON PTF5103V4 12 4V COMNO NC FLASH AA VTVV AA AAAA 12V 24VAC DC PHOTO 12V 24VAC DC 12V 24VACIDC 12V 24VAC DC POWER INPUT FLASH INPUT POWER INPUT FLASH INPUT IV Installation instruction 1 The product should be installed more than 20cm upper the ground to avoid reflection and the distance between emitter and receiver shall be more than 0 5 meters if not maybe the photocell will working on or cannot work 2 the end user should installed the photocell on the back of the direct sunshine or ot2. her strong shining 52 to keep the photocell work well steadily 3 Pls try to avoid installing other photocell emitters within effective receive range 4 If install many photo cells on the same line can install receivers on two ends and then emitters in the middle back to back which can effectively avoid the problem as above 5 in order to avoid signal bias of emitters and receivers which will easily cause mis operation pls Installate the photocell firmly 6 Connecting power after checking no error of connecting lines 6 1 Photocell After the emitter and receiver module of photocell input 12V 24VAC DC emitter LED on receiver LED on receiver NO COM on while NC COM off Making the CAP of emitter and receiver align receiver LED off NC COM on while NO COM off If the signal between emitter and receiver is interrupted receiver LED on NC COM off while NO COM on 6 2 Flash lamp IP 6 2 1 When there is signal income from FLASH port 12V 24V AC DC It keeps lighting when JP1 CAP connects the two pins under It blinks when JP1 CAP connects the two pins upper 6 2 2 When there is no signal income from FLASH port 12V 24V AC DC It doesn t work when JP1 CAP connects any two pins Blinks Keeps lighting V Installation Pictures LO k 2 Fix the holder 3 Drill and fix 4 Connect Open package C location map on gt expansion sleeve wires O L jo Fer o i
Download Pdf Manuals
Related Search