BM-157操作说明书(英文) XJ
Contents
1. BM 157 USER MANUAL Ze Soft Antenna Sensitivity Control Power Control CHANNEL Switch Microphone OFF CH1 CH2 Belt Clip Hanging Hook Battery Compartment AC DC Power Supply Socket Receiver Soft Antenna Volume Control Power Control CHANNEL Switch Speaker OFF CH1 CH2 Belt Clip Hanging Hook Battery Compartment AC DC Power Supply Socket 1 Main LCD Screen Out of range alarm icon Channel CH01 CH02 GE Oe Baby calling icon Eee song ican enrgy saving Mode constantly changing display readouts Battery icon am Full battery level ca Low battery level reminds you to change the batteries Empty and flashing batteries change is a must 2 AC Adaptor The AC Adaptors are low voltage power source that allow you to use your household electricity to run the Baby Monitor Connect the AC Adaptors to the AC Adaptor Jack in the Parents and Baby Unit Both plug into any standard volt electrical outlet in your home It is recommended to turn off the units before plug in or unplug the adaptors CAUTION These adaptors were made with a specific design for this product They cannot be used with any other appliance Never use a different type of adaptor with Baby Monitor This product cannot replace responsible adult supervision GE Oe m 7 e This Baby Monitor is intended as an aid Do not use it as a medical monitor or a substitute for responsible and proper adult su2. e Transmitter and Receiver in room where you intend to use it e Set both Transmitter and Receiver to the same channel 01 or 02 by switching the OFF CH1 CH2 channel switch Selected channel will be shown on the top right corner of the LCD screen NOTE It is important that with both units the switch settings are the same because if this is not the case the transmitter and the receiver will not be able to connect to one another 12 Transmitter emission e By using the SENSITIVITY knob you can turn in the sensitivity of the transmitter individually according to your wishes e As soon as the transmitter transmits a signal the Baby calling icon will be flashed on the LCD screen During the entire transmission the LCD backlight is activated e If the transmitter hears hardly any noise it automatically switches to the energy saving mode Baby sleeping icon shown on the LCD screen and the LCD backlight will automatically be turned off 13 Receiver reception e By turning the volume knob from right side the receiver will be turned on After turning it on the LCD display is activated and indicates you that the unit is ready for operation The channel being used will be displayed in the top right of the LCD screen By turning the volume more you can adjust is as you wish e Ifthe unit receives a signal the LCD backlight lights up automatically during the entire transmission and the Baby calling icon flashes e A few seconds after the uni
3. e signaled to you by a flashing visual range alarm icon shown on the receiver In addition the range alarm sound BI BI from Receiver will be heard continuously The out of range alarm will be still heard after the connection with the transmitter is broken Furthermore the visual and audible range alarm of the receiver is set off if e The connection between transmitter and receiver is broken such as the transmitter is turned off e The transmitter is turned into a different channel to that of the receiver e The transmitter or receiver is working with a charger with low batteries 17 Backlight LCD display When Power on Out of range Low battery level Baby calling i e a sound is sent and received the backlight of the transmitter as well as the receiver will automatically turned on Once no more signals are sent and received the backlight is automatically turned off 18 Belt Clip The transmitter and receiver can both be carried around using the belt clip provided on the rear of each unit 19 Trouble Shooting Problems Solutions e Unit is not turned on Push the Unit OFF CH1 CH2 switch to CHI or CH2 position Nowower e Check if the batteries are installed properly Pp 7 e Make sure the adaptor is connected to the Unit properly if using the adaptor instead of batteries e The Unit may be battery low change for new batteries e Sound sensitivity level of Transmitter is too low Turn the Sound Sensitivity l
4. evel proper position Mes tT tted g y proper p sssage NOSTIANSTMEG e Units are out of range or lost connection Move Receiver closer to Transmitter e Ensure both units are in the same channel Transmitter and Receiver e Power is turn off Turn on both Units d t show i e Check if both units are in the same channel Oo not snow image e Reposition or replace batteries x f e The Receiver is too near to the transmitter and its volume is high Increase the distance between the Hearing static or rustle Transmitter and receiver from Receiver ae e Reposition or replace batteries 20 Technical Specifications Power Supply Voltage Transmitter 3 AAA rechargeable batteries alkaline batteries amp adaptor AC 100 240V DC 6V Receiver 3 AAA rechargeable batteries alkaline batteries amp adaptor AC 100 240V DC 6V Channel 2 Channels Operation Frequency Ch1 864 875 MHZ Ch2 864 925 MHZ Operating Range up to 800 metre in ideal conditions Set includes 1 baby unit 1 parent unit 3x AAA rechargeable batteries for mother unit 2 adaptors
5. pervision e Make sure the Receiver and adaptor cable are always out of child s reach Do not place the Receiver inside the baby s crib or playpen e The antenna on the Units are fixed do not try to extend them Never attempt to modify the product e Avoid using the product near water and expose to rain or moisture 3 Receiver amp Transmitter Battery Installation H e Locate the battery compartment door on the back of the Units soe te Open the battery compartment door a e Insert 3 AAA batteries into the Receiver and the Transmitter according to the signs shown in the battery compartment respectively e Replace battery compartment doors Battery Tips eon If the product is not in use for a long time disconnect both units from the household electrical outlet And remove the batteries or the exhausted batteries from the units otherwise battery leakage and corrosion can damage them Dispose the batteries safely Non rechargeable battery is not to be recharged Rechargeable batteries are only to be charged under adult supervision CAUTION Danger of explosion if battery is incorrectly replaced Replace only with the batteries of the same and equivalent type 5 Transmitter amp Receiver Battery Charging If the battery level becomes low in both LCD displays the empty battery icon the battery icon and the out of range alarm icon flash in order to warn you about The low battery level The receiver also emits a warning
6. t receives no more signals the receiver is automatically switched to energy saving mode The Baby sleeping icon will be shown and the LCD backlight will automatically turned off 14 Set Up amp Use IMPORTANT Test sound reception before use and whenever location of transmitter is changed Refer to Testing Before First Time Usage e Transmitter detects sound levels within a range of 1 to 2 meters 3 to 6 5 feet for NORM setting Place transmitter in the same room with child Point microphone directly toward child location such as crib or playing area Set both Receiver and Transmitter to the same channel 01 or 02 Push transmitter SENSITIVITY switch to a desired position Adjust different detecting sound level sensitivity by switching the SENSITIVITY switch The receiver will go to energy saving mode and Baby sleeping icon shown when it doesn t detect sound from the surrounding area Place receiver where you stay and hear it Set the receiver to the same channel Rotate VOLUME knob to adjust volume Turning off by slide the OFF CH1 CH2 switch to OFF position 15 Note e Position the Transmitter at least 1 meter away from the baby for optimum sound transmission Unwrap and fully extend power cord for best transmission if adaptor is used e Plug the adaptor into the nearest standard household electrical outlet 16 Out of Range alarm and Range controls If the receiver is out of the range of the transmitter it will b
7. tone BI BI continually 6 Charging the batteries Please charge the rechargeable batteries first time usage The rechargeable batteries to the transmitter and receiver must not be taken out of the units for charging The battery icon loops and flashes while charging It stops flashing when the batteries are fully charged 7 Charging the transmitter and receiver e Connect the power supply unit to the thin plug on the 6V socket of the unit Once the power supply unit is connected to the unit charging automatically begins e The charging time for completely charging empty battery takes 9 hours when the unit is turned off Remarks Use only the DC adaptors which are included in the package Plug into any nearby standard household electrical outlet And connect them with the units Supply Power DC 6V eeo 9 Note e User can also install 3 alkaline AAA batteries instead of the supplied rechargeable batteries e Or directly operated by the supplied adaptors 10 Help protect the environment Batteries bearing one of the symbols shown opposite must not be disposed of in normal domestic waste Instead take them to a collecting point for old batteries or special waste products as your local authority for details or return them to the dealer you bought them from He will ensure they are disposed of safely Ret w 11 Testing Before First Time Usage eS X Pb Cd Hg Test the Transmitter emission and the Receiver reception e Plac
Download Pdf Manuals
Related Search