Alarm Features/Troubleshooting Guide
Contents
1. LCD screen an upright position with respect to the upright posi e Yellow LED flashing tion for more than 10 seconds every 2 seconds E04 Low Less than 25 power remaining 3 beeps every Battery alarm symbol Pump remains in Plug in extriCARE system Battery indicating that extriCARE System 20 seconds and E04 flashing on function until the and make sure the on Error will power off soon LCD screen battery depletes off switch is in the ON e Yellow LED flashing position Note the pump every 2 seconds can provide therapy while charging The extriCARE System being nan E05 used with an adapter that is not 3 beeps every Alarm symbol and E05 System is shut off Unplug the adapter and recommended There is a risk 20 seconds flashing on LCD screen use the recommended of voltage incompatibility if the e Yellow LED flashing ev adapter input voltage is greater than 6V ery 2 seconds always on E06 Canister The canister is not detected or is 3 beeps every Alarm symbol and E06 Pump will not run Properly install the Installation installed incorrectly 20 seconds flashing on LCD screen canister in place Take off Error e Yellow LED flashing canister and inspect white every 2 seconds square sticker If white sticker is missing or black replace canister E07 Blockage Tubing or dressing clog or 1 beep every e Alarm symbol and E07 Pump remains on Replace the dressing and blockage 20 seconds flashi2. Medical Products 1100 First Avenue Suite 202 King of Prussia PA 19406 866 446 0092 info devonmedicalproducts com
3. ng on LCD screen tubing set with a new set e Yellow LED always on Air Leakage Error There are many potential sources of leaks incomplete seal between extriCARE dressing and skin improper connection between tubing canister leakage etc The alarms have been divided into two categories E02 a Major Pump unable to reach 50 of the 3 beeps every Alarm symbol and E02 System will shut Inspect for possible air Leak Error preset pressure after 1 minute of 20 seconds flashing on LCD screen down after 5 minutes leaks between pumping effort e Yellow LED flashing e the wound and every 2 seconds extriCARE dressing e the extriCARE dressing E08 b Minor Pump unable to reach 80 1 beep every Alarm symbol and E08 System will shut and canister Leak Error of the preset pressure after 1 20 seconds flashing on LCD screen down after 20 e the canister and pump minute of pumping effort yellow LED remains minutes e if necessary power off illuminated and back on to restart the system after adjustment Apply pressure around outside of dressings with one hand in a clockwise rotation while watching pressure indicator number When the number increases you have identified location of the leak Then pick up dressings and apply Gel strip onto the skin Replace dressing down to the skin OR Identify location of the leak and then apply Gel strip under edge of dressing where leak is located B30 0024 Rev A 20150401 2015 Devon
4. z B z VON innovation in Medical i devonmedicalproducts com MEDICAL PRopUcTS oducts Engineering extriCARE Negative Pressure Wound Therapy NPWT System Cx l Alarm a e a a extriCARE In order to assure proper patient compliance the extriCARE 2400 system is equipped with both audio and visual alarms for all the errors listed in the chart below To disengage the alarms 1 Audio alarms can be muted by pressing any button on the device front plate 2 Visual alarms which include the LED and screen symbols need to be disengaged by pressing the PUMP button If the screen is locked it needs to be unlocked first before the visual alarm can be disengaged For instructions on how to unlock the screen please refer to section 10 2 5 on the User Manual Error Error pane Audio Alarm Visual Alarm System Status Suggested Code Type Features Features Mitigation E01 Canister The canister is equipped with full 3 beeps every Alarm symbol and E01 Pump will shut off Install a new canister Full Error sensors that will be triggered ei 20 seconds flashing on LCD screen immediately ther when a canister is full of ex e Yellow LED flashing udates or a false fullness caused every 2 seconds by incorrect use of the system E03 Tilt Error The extriCARE System is tilted at 3 beeps every Alarm symbol and E03 Pump remains on Place the device back to an angle greater than 95 degrees 20 seconds flashing on
Download Pdf Manuals
Related Search