MINNOW BATH SUPPORT
Contents
1. Slightly behind the standard back recline seating Recline Seating Upright Seating M DDEVV Bath Support Cleaning and Care Removable mesh seat pad Machine wash warm and tumble dry Use non chlorine bleach as needed Bleach will yellow the cloth and accelerate deterioration especially if soaked PVC Frame and trunk pad Use a mild detergent Measurements Single Back Dual Back Support Supports Seat width 14 14 Back Support Inside Width 12 12 Back Support Height Range 7 to 10 7 to 13 Frame Width 17 17 Frame Depth 27 27 Product Weight 4 5 lb 5 4 Ib The back support is made of aluminum and can be mildly bent to adjust to different torso widths2. MIAACW Bath Support User s Manual September 2006 By SNUG SEAT INTRODUCTION Thank you for purchasing the Minnow Bath Support from Snug Seat When used properly the Minnow should provide years of convenient bathing assistance It is very important to read all instructions before using this product Keep these instructions for future reference as they contain vital safety and use information A WARNI NGS e To prevent burns set your hot water heater to 120 degrees Fahrenheit or lower Always check the water temperature before placing your child in the tub Swirl the tub water around with your hand to eliminate any hot spots AN THIS PRODUCT IS NOT A SAFETY DEVI CE e Children have DROWNED while using infant bathing devices Since children can drown in as little as 1 inch 2 5 cm of water ALWAYS bathe child using as little water as necessary e ALWAYS keep child within adult s reach e DO NOT allow other children to substitute for an adult e DO NOT carry child in this product e ALWAYS test water temperature before placing child in this product e DO NOT use this product if any parts are missing or broken PARTS INVENTORY N WARNI NG Before each use please inspect this product for damaged hardware loose parts missing pieces or sharp edges Do not use this product if any parts are missing or broken Bath Support Hanger Assembly The Minnow Bath Support comes with a hanger assembly for easy drying of t
3. he unit and convenient storage when not in use Before using the Minnow you must assemble the frame hanger plate 5 to the pre drilled PVC frame 1 using the stainless steel screws 7 This assembly requires the use of a Phillips head screwdriver Use of Hanger The Minnow Bath Support hanger wall plate assembly is provided with two large suction cups that adhere to many bathroom surfaces Hanging the Minnow is a convenient way to speed drying of the unit and to store it when not in use WARNING Pooled water can cause slippery surface conditions and increase the chances of falling in the bathroom Never hang the Minnow in an area where water can accumulate and pool beneath it Back Support Assembly Adjustment The Minnow Back Support assembly can be height adjusted for optimal fit Simply loosen the blue plastic knobs 3 adjust the back support as needed and tighten the blue knobs Safety Trunk Strap The Safety Trunk Strap is provided to secure the user s trunk in the Minnow The Safety Trunk Strap uses a hook and loop fastener for quick and easy closing and a safety buckle for added security N WARNING Always secure the safety buckle Adding An Additional Back Support A second Back Support can be easily added to the Minnow to accommodate taller users Assembly The Back Support is independently height adjustable and can be attached to the Minnow in line with the standard back support upright seating or
Download Pdf Manuals
Related Search