Home

PDF Manual

image

Contents

1. 3 The rocker switch at the bottom is for Zooming Since it is a variable rocker the farther you press it right the faster it will zoom in telephoto and the farther you press it left the faster it will Zoom out wide You should practice a bit before shooting so that you acquire a good sense of the rocker s characteristics 4 The small button marked with a red R is the record start stop button 5 Finally the LED indicator light will turn red or blink to indicate a variety of camcorder functions such as record tape end low battery etc the pattern will vary slightly between different camcorders but will remain consistent when used with the same camcorder You are ready to begin using the VZ RL100 When not in use disconnect the RL100 Troubleshooting 1 Zoom Creeping unwanted zooming Recalibrating the zoom center is easy With the controller connected to your camera loosen the brass set screw on the underside of the rocker with a 5 64 hex key alan wrench holding the rocker firmly in place On the backside of the rocker is a hole with a slotted shaft and this is where you adjust the zoom center with a flat screwdriver Turn it slightly left and right and you ll see the camera zoom in and out find the centermost point between the zoom in out start positions then tighten the brass set screw don t overcrank it 2 Controller not responding Unplug the unit and plug it back in after a few seconds 512 219 7722 w
2. VariZoom VZ RL100 OPERATING INSTRUCTIONS PLEASE READ BEFORE USING Thanks for purchasing our new deluxe variable rocker LANC control the VZ RL100 Before you begin using your controller here are a few important guidelines to follow DO NOT PLUG THE UNIT INTO ANY PANASONIC CAMERA OR DAMAGE MAY RESULT NEVER EXPOSE THE UNIT TO WATER OR LIQUIDS AND NEVER EXPOSE IT TO EXCESSIVE HEAT PRESSURE OR SHOCK DOING SO MAY RESULT IN DAMAGE NOT COVERED BY THE FACTORY WARRANTY 2 YEARS DO NOT ATTEMPT TO OPEN THE UNIT DOING SO MAY VOID YOUR FACTORY WARRANTY DO NOT SUBJECT THE VARIABLE ZOOM ROCKER OR THE LANC CABLE TO UNNECESSARY STRESS ABUSE OF THE ZOOM ROCKER OR LANC CABLE MAY RESULT IN DAMAGE NOT COVERED BY YOUR WARRANTY Your VZ RL100 controller is equipped with the following features pressure sensitive variable speed zoom control record start stop LED indicator HOW TO USE THE VZ RL100 1 Plug the controller into the LANC jack Control L on your camcorder DO NOT PLUG THE CONTROLLER INTO ANY OTHER JACK OR DAMAGE MAY RESULT DO NOT PLUG IT INTO ANY PANASONIC CAMERA If you are not sure about the location of the LANC jack consult the camcorder owner s manual 2 You can attach the controller to your tripod handle monopod shoulder support or stabilizer with the adjustable clamp do not overtighten The controller doesn t require any external power or setup Once connected the VZ RL100 is ready to perform
3. ww varizoom com

Download Pdf Manuals

image

Related Search

Related Contents

第6号 - 丹波市  

Copyright © All rights reserved.
Failed to retrieve file