USER MANUAL GSM-CAN is a vehicle alarm system
Contents
1. enter a code 11 S KYB RAKE SKYBRAKE GSM USER MANUAL 4 BUILT IN GSM COMMUNICATOR 4 1 For communicaton to work it needs a functional SIM card it needs to be prepared for use PIN code for SIM has to be disabled SMS has to be deleted needed services has to be turned on 4 2 With voice commands and SMS commands user can a adjust communicator settings b adjust alarm systems function settings user adjust is not advised c recieve information about system status and vehicles position information control alarm system 4 3 ALARM AND INFORMATION NOTIFICATIONS ON REGISTERED NUMBERS There can be saved up to 5 phone numbers to which depending on settings will be coming calls and or SMS notification To each number are available following settings Obligatory voice notification call in case of alarm If system has been set up in a way that after alarm system would call to more than one number then to the number which has been set as obligatory then system calls to said number even after calling to different number system has recieved acknowledgement of system alarm working If user does not accept the call not picking up the phone or accepts call but is not entering code of acknowledgement 0 or PIN code and system tries to call user up to 3 times Voice notifications call in case of alarm If calling to a different number system recieves code of acknowledgement then system doesn t call this number anymore If2. the system to sound the alarm 1 3 TURNING ALARM ON WITHOUT SENSORS USING INGNITION KEY Turn ignition on and off 3 times Look at the light diode Blinking one time will confirm 3rd time of turning on and off the ignition Exit the vehicle in next 20 seconds close the doors and close central locking using remote control For system arming without sensors system informs with long 0 5 seconds sound signal depends on system settings System is armed but ultrasound sensor and or level impact sensors are disarmed from system Movement in saloon and or cars level changes or impacts won t make the system to sound the alarm eS KYB RAKE SKYBRAKE GSM USER MANUAL 2 SYSTEM DISARMING Press the button on remote control that opens central locking Vehicle signals with direction indicators and for short period 0 1 seconds turns on sound signal depends on central lockings and alarms settings Light diode stops blinking System has been disarmed 3 SERVICE MODE In special cases loss of central locking remote control battery in remote control is empty or malfuctions repair of vehicle Skybrake GSM can enable service mode In this mode system ignores sensors doesn t block engine signalise but systems light diode blinks with short intervals Service mode can be turned on with PIN code in two ways 3 1 TURNING ON SERVICE MODE WITH SECRET BUTTON Most comfortable way to turn on service mode is entering PIN code with secret button If secr
3. user refuses the call doesn t pick up the phone or accepts the call but is not giving code of acknowledgement 0 or PIN code and system tries to call the user 3 times SMS notifications in case of alarm SMS when arming the system SMS when disarming the system SMS about remote engine turning on turning off or turning on off autonomous car heater SMS about defects car battery charge is lower than previously set mark Periodical test SMS SMS about state of the system after previously set time period 1 till 4 days at 12pm Unrecognisable SMS forwarding If this setting is enabled for a number then system will forward all unrecognisable SMS Note If accepting calls and SMS command execution is disabled from unregistered numbers then all SMS from unregistered numbers will be deemed unrecognisable SMS notifications in SmartPhone format This setting can be enabled in case user has a smartphone with Android operating system and application Skybrake In other cases this setting has to be disabled 5 KYB RAKE SKYBRAKE GSM USER MANUAL 4 4 CALLS AND SMS NOTIFICATIONS TO ALARMS SYSTEM NUMBER SMS If accepting calls and SMS commands from numbers other than registered in memory has been disabled Table 2 Command SHO then system rejects call from unregistered numbers but SMS commands from these numbers are ignored deemed unrecognisable This setting does not work SMS notifications and calls are accepted
4. S KYB RAKE SKYBRAKE GSM USER MANUAL SKYBRAKE GSM USER MANUAL GSM CAN is a vehicle alarm system designed for modern cars equipped with central locking able to operate from distance and CAN BUS Skybrake GSM main advantages are reliable engine blocking which protects vehicle against theft additionaly with alarm disabling with changable PIN code built in GSM Communicator and level sensor 1 SYSTEM ARMING 1 1 ARMING Press a button on remote control which closes central locking Vehicle signals with direction indicators and for short period 0 1 seconds turns on cars sound signal depends on central locking and alarms settings central locking closes Systems light diode starts to shine constantly then goes to blinking System is armed If someone opens doors bonnet trunk there is movement in saloon or system identifies level changes or impact it will turn on the alarm 1 2 TURNING ALARM ON WITHOUT SENSORS USING SECRET BUTTON With ignition turned off press secret button Pay attention to light diode Blinking one time confirms the pressing of secret button Exit the vehicle in next 20 seconds close the doors and close the central locking using remote control For system arming without sensors system informes with long 0 5 seconds sound signal depends on system settings System is armed but ultrasound sensor and or level sensor is disabled from system Movement in saloon and or cars level changes or impacts won t make
5. ble this setting and turn off Service Mode Changing system status with Short Call If system recieves call from a given number it doesn t answer right away waits approximately 5 seconds and if call is ended before system accepts the call alarm changes its status Arms the alarm if its disarmed and other way around S KYB RAKE SKYBRAKE GSM USER MANUAL SN NNNN Add new phone number in position in the number list position number 1 to 5 SNO NNNN Add new phone number NNNN in first free position in number list SR Delete number from position in number list position number 1 to 5 SI Recieve SMS with all saved phone numbers SH1 Allow accepting calls and SMS notification from unregistered numbers SHO Forbid system from recieving calls and executing SMS commands from unregistered numbers Calls from unregistered numbers will be ignored SMS commands will be deemed unrecognisable Voice Canal Commands 1 Arming the system O Disarming the system OO Clean alarm memory O9 System status Alt Vehicle positioning by GPS 42 Vehicle positioning by GSM 5 Get information about SIM cards balance 611 Start engine 610 Stop engine 621 Start autonomous car heater 620 Stop autonomous car heater 661 Engine blocking 660 Unblock engine 7 Personal setings menu x 1 enabled x 0 disabl
6. ed Ox Recieve SMS about disabling alarm Ix Recieve SMS about enabling alarm 2x Recieve SMS in case of alarm going off 3x Recieve SMS about enabling alarm disabling alarm SMS in case of alarm going off SMS about technical fault periodicall test SMS voice notification call in case of alarm going off Ax Recieve a voice notification in case of alarm going off 5x Recieve SMS about technical fault bx Recieve periodical test SMS Tx Recieve obligatory voice notification call in case alarm goes off i Return to main menu 8 Alarm system function menu Note available only to user calling from number in first position in number list 9 Phone number menu OO Delete all phone numbers from list OAH Denied recieving calls and executing SMS commands from unregistered numbers S KYB RAKE SKYBRAKE GSM USER MANUAL O5 Allow recieving calls and executing SMS commands from unregistered numbers O9 List of registered numbers 20 Delete number from position in numbers list position number 1 to 5 1 Add new number in position in numbers list position number 1 to 5 22 Add your number in position in numbers list position number 1 to 5 Return to main menu End call
7. et button is installed in car check the PIN code you had chosen Enter PIN code by pressing the secret button number of pressees should match the first number of your PIN code gap between preses can not exceed 1 second wait for 1 second long blink on light diode which confirms entering of first number Following the same way enter second third and fourth numbers of PIN code fanti hijack or immobiliser functions are enabled then on first press of the secret button system reacts as to anti hijack or immobiliser function control On following preses of secret button system reacts as of entering a PIN code 3 2 TURNING ON SERVICE MODE WITH IGNITION If car isn t equipped with secret button open drivers door and turn on ignition After brief pause systems light diode will start to blink with double blinks Count blinks until number One double blink 1 which corresponds to your first PIN code number then turn off and turn on again ignition Now count double blinks until number which corresponds to second number of PIN code and again turn off and turn on ignition Following same pattern enter third and fourth PIN code numbers If correct PIN code has been entered light diode blinks with often blinks If wrong PIN code has been entered turn off ignition close drivers side door and start everything from point 4 2 again 3 3 TURNING SERVICE MODE OFF Enter your PIN code and in next 8 minutes following same pattern as in points 4 1 and 4 2
8. from all numbers if system is in Service Mode Transmitting commands through voice canal regardless if call is made from registered or unregistered number its necessary to Call to alarms system number With help of phones keyboard enter correct PIN code and press Enter a command See Voice command tabele and press To cancel an incorrect command instead of press after that enter a correct command and press To transmit a command in SMS format it s necessary to In the beginning enter a correct system PIN code if command is sent from an unregistered phone You can skip the step of entering a PIN code if command is sent from a registered number and request for PIN code is disabled for said number Command starts with symbol and ends with symbols While in session DTMF code after pressing a keyboard button is sentat once therefore correcting an incorrectly entered symbol is useless For each of registered phone numbers are available following settings PIN code request in SMS command If this setting is enabled and at the beginning of SMS command there isn t a correct PIN code system deems SMS unrecognisable Denied system control System considers SMS notifications to be unrecognisable and drops calls This setting is intended for reserve number of security service If control denial setting is enabled by mistake with help of secret button or ignition enter a PIN code and with SMS commant disa
Download Pdf Manuals
Related Search