Water Logger Housing Manual (Part # HOUSING-U2x)
Contents
1. Water Logger Housing Manual Part HOUSING U2x Inside this package The water logger housing is designed for Specifications e Water ues HOBO U20 water level loggers and HOBO gt ater logger housing U24 conductivity loggers to provide added e 6 Cable ties protection from debris while allowing water Dimensions 5 1 cm 2 0 in maximum diameter 23 5 cm 9 25 in length to move freely in and out Recommended Installation Method Step 1 Step 2 Unscrew cap from housing Install one of the supplied cable ties through the hole in the lanyard end of the U20 or the sensor end of the U24 Create a loop large enough to hook your finger through the loop only acts as a handle when removing logger from housing Trim excess Step 3 Feed one of the supplied cable ties through opposite holes at the middle of housing and then loosely loop as shown Note The cable tie will be tightened in step 5 to help prevent the logger from moving around in the housing Securing the logger in the housing is strongly recommended for the U20 to help ensure accurate water level measurements Use is optional for the U24 Step 4 Press down on cable tie so that it curves along inside bottom of housing before inserting logger With housing on a flat surface and while U24 a pressing down on cable tie so that it curves _ a along inside bottom of housing insert logger 5 with its cable tie handle closest to open end Logger shou2. ld rest on top of curved cable tie and its handle should be fully inside housing view into housing Step 5 Step 6 Tighten cable tie to secure logger in Reinstall cap Hand tighten z securely housing Trim excess 2010 Onset Computer Corporation All rights reserved Onset and HOBO are registered trademarks of Onset Computer Corporation Manual Part No MAN HOUSING U2X Doc No 14313 B U24 Water Logger Housing Manual Deployment Considerations e Using the supplied cable ties the housing can be secured to a post or other suitable structure A tethered mounting arrangement can also be used HASAN COLETTE UATARA CHET Post Mount Tether Mount e Refer to the logger user manual for additional deployment information Removing Logger from Housing e f necessary use an adjustable wrench to remove the cap e Use cutters to snip the cable tie securing logger if one is present e Remove the logger to perform readout and any required maintenance Refer to the logger and software user manuals as needed
Download Pdf Manuals
Related Search