Home

HPA IN EAR

image

Contents

1. between channels L and R Then both channels L and R mutually output to both headphones In middle position both channel levels are equal at left stop only channel L at right stop only channel R transmits signals 5 Mode Switch Stereo Mode The device outputs the signal fed into the left input to the left headphone and the right signal to the right headphone Mono Mix Mode Channel L and channel R are mixed and output to both headphones By means of the balance controller the ratio between both channels can be adjusted REAR PANEL Operating elements at the rear panel 1 Power switch Activation of the voltage supply of the device This switch is installed slightly flushly so that it is protected against switching off by mistake 2 XLR inputs L and R Connection of the input signals coming from a mixing console or the lilke Assignment of the double purpose jack 1 ground S ground 2 signal T signal 3 signal R signal With asymmetric wiring PIN 3 should be assigned to ground bridge in the connecting plug Maximum input level 5dbm 3 DC In socket lockable Connection of a AC DC power adaptor with 9V DC output 230V mains input minimum output current 100mAH When a battery or rechargeable battery is inserted in the body pack it is switched off when plugging in the adaptor As soon as the plug is withdrawn the unit works on battery voltage supply again Poles are PIN RING MONO operation of the
2. HPA IN EAR With mono monitor mixing the signal is connected to one of the two input channels the MODE switch is adjusted to mono mix mode pressed and the BALANCE controller is in the middle position Thus the mono signal is output to both headphones Mono mix operation This operation mode is the easiest way to create a user specific monitor mix an overall mono mix of the band for example is supplied to channel L the signal of the particular musician to channel R Thus that musician can individually adjust his optimum listening signal by means of the balance controller Adjustment of the output level at the source of the signal i e a mixing console Adjust the output level at the source of the signal mixing console at approx OdB to 3dB at the signal peaks This provides the in ear device with an adequate input level so that there is sufficient power at the headphones output In addition this prevents that high increase of the level such as feedback escalate the headphones level The input level limits the signal at approx 5dBm Features Two direct symmetric XLR inputs Much better sound than wireless in ear system Switch over for stereo to mono mix mode 2 x 50mW Controls for volume and mix Sturdy aluminum case with 3 8 internal threads at the bottom Suitable for mounting on super stands Mains connector lockable for plugging in an external DC mains adaptor optional extra Power supply with 9V block batt
3. USER GUIDE HPA IN EAR Headphone Monitor AMP Thanks for choosing the Millenium HPA IN EAR Monitor amplifier Please read this manual carefully to get the most out of your unit Caution Do not use this item at too high sound levels otherwise it may cause permanent hearing defects Adjust the volume so that you can hear sufficiently Ringing in the 4 ears can indicate that the adjusted hearing level is too high Using headphone systems with good fitting which suppress the ambient noise well FRONT PANEL eattcheck Millenium Ooo Headphone MonitorAMP HPAIN EAR Description of the operating elements on the front panel 1 3 5mm stereo jack Connection for the headphones minimum impedance 16 ohm per channel Maximum output power 50mW per channel tip left signal ring right signal sleeve ground 2 Battery indicator LEDs There are two LEDs for controlling the inserted battery or rechargeable battery After switching on with a newly inserted fresh battery the green LED lights With increasing operating time and decreasing battery power i e Voltage gt 7 3V both LEDs green and red light up When only the red LED battery voltage 6 5V lights the battery should be replaced 3 Volume control Adjustment of the volume for both output channels 4 Balance control In Stereo Mode Adjustment of the volume balance for the left and right output channels In Mono Mix Mode Adjustment of the volume level ratio
4. ery NO AUN Technical Data Dimensions 170x93x47mm Net weight 0 4kg Input jacks 2 x combos Output jack 3 5mm jack stereo Frequency response 30Hz 20kKHz 2dB Min impedance of the headphones 16ohms per side Input Impedence 15 kohm Nom input level symmetric OdBV Max input level symmetric 4dBV Limit input level symmetric 5dB Max output power into 200hms 50mW per channel Max operating current 40 mA Power supply 9V battery DC input socket ext input power DC 9V PIN RING Disposal Do not dispose of the device at the end of his operating life in your normal domestic waste This device is subject to the European Guidelines 2002 96 EC Have the product disposed of by a professional disposal company of by your communal disposal facility Observe the currently applicable regulations In case of doubt contact your disposal facility Dispose of packaging materials in an environmentally responsible manner EA Musikhaus Thomann ta Teppendorf 30 KX 96138 Burgebrach i GERMANY C www thomann de

Download Pdf Manuals

image

Related Search

Related Contents

ISTRUZIONI D`USO UNITÀ CONDENSATRICI  Owner`s Handbook - Williams Performance Tenders  取扱説明書 - M  AB 325 - Service.braun.com  

Copyright © All rights reserved.
Failed to retrieve file