User manual - Russell Hobbs
Contents
1. Russell WX Hobbs INSTRUC HONS amp WARRANTY RHMP01 MULTI PURPOSE FAN INTRODUCTION Congratulations on purchasing a Russell Hobbs Multi Purpose Fan Each unit is manufactured to ensure safety and reliability Before using this appliance please read the instruction manual carefully and keep it for future reference IMPORTANT SAFEGUARDS When using any electrical appliance basic safety precautions should always be followed including the following Aen a 12 13 Do not allow the cord to touch hot surfaces and do not place on or near a hot gas or electric burner or in a heated 15 16 17 18 19 20 21 22 23 Please read the instructions carefully before using any appliance Always ensure that the voltage on the rating label corresponds to the main voltage in your home Incorrect operation and improper use can damage the fan and cause injury to the user The fan is intended for household use only Commercial use invalids the warranty and the supplier cannot be held responsible for injury or damage caused when using the appliance for any other purpose than that intended This fan is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Check the power cord and plug regularly for any damage2. TEL NO 011 490 9000 CAPE TOWN TEL NO 021 552 5161 DURBAN TEL NO 031 792 6000 www homeoflivingbrands co za www russellhobbs co za
3. hands 2 Do not put any unnecessary items into the fan guard 3 Please unplug the fan from the electrical outlet before cleaning Changing the Plug Should the need arise to change the fitted plug follow the instructions below This unit is designed to operate on the stated current only Connecting to other power sources may damage the appliance Connect a three pin plug as follows The wires in this mains lead are coloured in accordance with the following code Green Yellow Earth WARNING THIS APPLIANCE MUST BE EARTHED Blue Brown Neutral Always ensure the three pin plug is connected as follows Live E Green and Yellow E N Blue Earth L Brown PLEASE AFFIX YOUR PROOF OF PURCHASE RECEIPT HERE IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE PRODUCED WARRANTY 1 Home of Living Brands Pty Limited warrants to the original purchaser of this product the customer that this product will be free of defects in quality and workmanship which under normal personal family or household use and purpose may manifest within a period of 1 one year from the date of purchase warranty period Where the customer has purchased a product and it breaks is defective or does not work properly for the intended purpose the customer must notify the supplier from whom the customer bought the product the supplier thereof within the warranty period Any claim in terms of th
4. 9 M4 10 screw 10 Tube 11 Set button 12 Transparent window 13 Button 14 Mosquito box assembly 15 Base 16 Base nut How to operate Assembling the fan according the chart above 1 Ensure that you have all the parts for the fan from 1 16 as shown above 2 a Install fan body on the base and fasten the base nut b Install the tube and the part of motor c Fasten the tube with the triangle screw 3 According to picture 1 insert the rear guard into the motor parts and fasten the rear guard by part 6 4 According to picture 2 insert the blade to the shaft and ensure the pin enters the blade slot and tighten the blade using the blade cap turning anticlockwise 5 Fix the front guard in the upright position on the rear guard and clip it properly Make sure that they are connected from the upper side 6 Angle adjustment Push the fan guard slightly as shown on the picture Using the remote The remote control must be directed at the infrared port as shown in the picture If the remote control does not operate well please check the inside battery first and insert new batteries if needed 1 Press ON SPEED button to choose the wind speed Low Medium or High 2 Press SWING button to change the wind direction Whilst the corresponding light switches on press this button again to stop oscillation 3 Press TIMER button to set the time using the timer function To set a time of 2 hours you need to press th
5. If the cord or the plug is damaged the manufacturer or a qualified person must replace it in order to avoid an electrical hazard Do not use the fan if it has been dropped or damaged in any way In case of damage take the unit in for examination and or repair by an authorised service agent To reduce the risk of electric shock do not immerse or expose assembly plug or the power cord to water or any other liquid Never immerse the unit in water or any other liquid for cleaning purposes Remove the plug from the socket by gripping the plug Do not pull on the cord to disconnect the fan from the mains Always unplug the unit when not in use before cleaning or when adding or removing parts The use of accessory attachments that are not recommended or supplied by the manufacturer may result in injuries fire or electric shock Ashort cord is provided to reduce the hazards resulting from becoming entangled in or tripping over a longer cord Ensure that the cord is not in a position where it can be pulled on inadvertently oven Use of an extension cord with the fan is not recommended This fan is not suitable for outdoor use Do not use this appliance for anything other than its intended use DO NOT carry the appliance by the power cord DO NOT COVER the fan under any circumstances Do not leave the appliance unattended during use Always unplug the unit when not in use or before cleaning Always operate the appliance on a smooth even
6. ake sure the plug works and check your fuses b Change the same type of PCB c Ensure power switch is on at a the wall a Install the rear guard tightly b Tighten the blade cap c replace the fan blade d Turn the fan blade to 180 and reinstall a Check whether or not the mosquito eradication light is on and or replace it b Check whether the Mosquito eradication fan works or replace it c Install the Mosquito eradication box properly 4 Why is there After a period of running the You may clean it yourself dirt around the vent unit there will be some dirt of the negative ion around the orifice of the generator negative ion generator It s the effect of negative ion which is normal 5 Other unusual a Motor gave out smoke or Stop using immedeiately and send your appliance to problems odour technical service for maintenance b Metal parts exposed with electric or the fan insulation is damaged c The rear cover of motor is damaged Cleaning and Maintanence 1 Please disconnect the power cord plug from the electrical outlet and make sure that your fan is not operating before cleaning it 2 Please add a few drops of lubricant to the motor shaft after cleaning to extend motor life every year 3 Pack the unit properly and store it in a cool dry place if you are not using it for a period of time Safety and Precaution 1 Do not pull out the power cord plug from the electrical outlet with wet
7. e button once To set 6 hours of running time you need to press three times and the number of hours will be changed every time 4 Press ION button to purify the air When the corresponding light is on the negative ion generator releases the negative ions that purify the air 5 Press MOSQUITO KILLER button to begin the mosquito eradication process By pressing the button once more the eradication process will stop 6 Press OFF button to switch off the fan By doing this all fan functions return to initial condition Notes When changing batteries use the same type otherwise your remote control may not operate properly Keeping the batteries inside the remote control when not in use for long periods of time may damage your remote control ON SPEED MOSQUITO KILLER Frequently Asked Questions OFF TIMER 10N MOSQUITO KILLER SWING ON SPEED Solution 1 Why is the fan not operating 2 Why is the fan vibrating 3 Why is Mosquito the eradication function not working a No power to the unit b There is no electricity c The fuse may have blown d PCB is damaged a The rear guard is not installed tightly b The blade cap is loose c The blade is damaged d The blade is imbalanced a The light is not on b The mosquito eradication fan is not working c The mosquito eradication installed in its proper place or not installed box is not a M
8. is warranty must be supported by a proof of purchase If proof of purchase is not available then repair and or service charges may be payable by the customer to the supplier The faulty product must be taken to the supplier s service centre to exercise the warranty The supplier will refund repair or exchange the product in terms of this warranty subject to legislative requirements This warranty shall be valid only where the customer has not broken the product himself or used the product for something that it is not supposed to be used for The warranty does not include and will not be construed to cover products damaged as a result of disaster misuse tamper abuse or any unauthorised modification or repair of the product This warranty will extend only to the product provided at the date of the purchase and not to any expendables attached or installed by the customer If the customer requests that the supplier repairs the product and the product breaks or fails to work properly within 3 three months of the repair and not as a result of misuse tampering or modification by or on behalf of the customer then the supplier may replace the product or pay a refund to the customer The customer may be responsible for certain costs where products returned are not in the original packaging or if the packaging is damaged This will be deducted from any refund paid to the customer HOME OF LIVING BRANDS PTY LTD JOHANNESBURG JOHANNESBURG
9. stable surface Do not place the unit on a hot surface Ensure that the switch is in the Off position after each use The manufacturer does not accept responsibility for any damage or injury caused by improper or incorrect use or for repairs carried out by unauthorised personnel In case of technical problems switch off the unit and do not attempt to repair it yourself Return the appliance to an authorised service facility for examination adjustment or repair Always insist on the use of original spare parts Failure to comply with the above mentioned pre cautions and instructions could affect the safe operation of this machine Introduction The Russell Hobbs multi purpose fan with its modern design and multi purpose features is the latest offering from the Russell Hobbs family It consists of a mosquito eradication function that may be used with the fan or separately It offers a hassle free way to protect your family from mosquitos whilst enjoying cool clean and fresh air Operating Functions Negative lon Function The Negative lon Function purifies the air through its negative ion generator that uses a pulse and oscillating circuit Mosquito Eradication Function The Mosquito Eradication Function is a noise radiation and odour free function that aids in reducing mosquitos Technical Specifications _ i 1 Front Guard 2 Guard hoop 3 Screw 4 Blade Cap 5 Blade 6 Guard Mounting Nut 7 Rear guard 8 Motor
Download Pdf Manuals
Related Search