PC5580 X-10 Manual Control
Contents
1. Power 832 Application Notes X 10 Automation Manual Control Application The ESCORT can be used to control up to 32 X 10 automation devices This Application Note will cover the basic programming required for manual operation Additional Application Notes are available for scheduling and output control Equipment Power 832 control panel ESCORT 5580 module X 10 controller PL 513 or PSC 04 X 10 lamp module Special Notes Program Sections ESCORT Section 002 First System Options ESCORT Section 007 Number of Automation Transmissions ESCORT Section 130 Item 01 House Code amp Unit Number ESCORT Section 131 Item 01 Miscellaneous Options ESCORT Section 134 Item 01 Schedule Output Condition Procedure To enter ESCORT programming perform the following on any local touch tone phone Enter on any local touch tone phone to turn the ESCORT on Enter 8 ESCORT Service Code default is 5580 For information regarding how the ESCORT is programmed please refer to the ESCORT 5580 Installation Manual Step 1 First System Options ESCORT Section 002 e Tur Option 03 ON to enable Home Automation e An access can be required to enter the 5 Automation for additional security If Option 04 is ON an access code is required If Option 04 is OFF an access code is not required Step 2 Number of Automation Transmissions ESCORT Section 007 The number of Auto2. mation transmissions can be changed to increase reliability Since the Automation transmissions are non confirmed and occur over the existing AC wiring of the premises having the ESCORT transmit multiple On Off commands can increase reliability e Program the number of on off transmissions to be sent for each command e Note each transmission takes approximately one second The larger the number the slower the Automation system will appear to operate Step 3 Item 01 House Code amp Unit Number ESCORT Section 130 Each light module has dials for selecting a unique address for each A unique address is required for each light module so that the user can control them individually One dial is used to select from letter A to P the other dial is used to select a number from 1 to 16 e Referring to Appendix B program the three digit code equivalent to the letter and number corresponding to the letter and number selected for the first X 10 light module i e A1 000 Step 4 Item 01 Miscellaneous Options ESCORT Section 131 e Turn Option 01 ON to enable the X 10 module e Turn Option 02 ON to enable end user manual control Option 03 allows you to select if the X 10 module will be included in global commands For example several light modules may present to control downstairs lighting At bedtime rather than having to turn off each light module individually the user could initiate a global off comma
3. nd All the light modules included in the global command option would be turned off e Turn Option 03 ON to include the X 10 module in the global command group Turn Option 03 OFF to exclude the X 10 module from the global command group e Turn Option 04 ON to enable dimming e Option 05 is not used for manual control It only applies of the X 10 module is being used in conjunction with schedules or outputs e Turn Option 06 ON so that the light will remain on until told to turn off The Escort can be programmed to announce different words when an X 10 module is activated deactivated Depending on the application turn Option 07 08 or 09 ON Only turn ON one of these options In the case of lighting it is logical for the Escort to announce on and off e Turn Option 07 ON so that the ESCORT will announce the light is on and off when activated e Turn Option 08 OFF e Turn Option 09 OFF Step 5 Item 01 Schedule Output Condition ESCORT Section 134 e Enter data 00 to disable schedule output control Step 6 Program Additional X 10 Modules Repeat steps 3 through 5 for each X 10 module on the system The programming is identical however the Section numbers are different for each Summary The user will be able to turn on or off individual lights on the system using the 5 command
Download Pdf Manuals
Related Search