HOT DOG STEAMER - CORNiCO Company, sro
Contents
1. any damage which may have occurred during transit Damage claims should be filed immediately with the transportation company Electrical Requirements The model 8007 and 8012 are designed to operate on 120 Volt 15 Amp single phase outlet Make sure the machine is on a dedicated line and that no other appliances are on the same circuit Note Make sure the hot dog steamer is placed and operated on a flat level surface OPERATING INSTRUCTIONS CONTROLS AND THEIR FUNCTIONS ON OFF SWITCH Turns on the machine by supplying power to the heat element HEAT CONTROL By adjusting the knob up or down the heat control will adjust the temperature of the steamer temperature scale 15 located on the knob to indicate the set point temperature OPERATING PROGEDURE PD Oe NR Remove the two lids from the top of the machine Remove the hot dog basket bun basket partitions steam baffle and juice pan Pour distilled water into the bottom of the heating compartment until the water level is just below the ledge that the steam baffle rests on Do not fill above the ledge as the cabinet will leak and the hot dog buns will be sitting in water Replace the hot dog basket bun basket partitions steam baffle and juice pan Place the hot dogs in the small basket and the buns in the large basket Arrange the hot dogs and buns so that there is free circulation of steam Put the two lids back on the top of the machine Tu2. the proprietary and exclusive property of Gold Medal Products Company and shall not be used copied reproduced reprinted or published in any fashion including website display without its express written consent 6 Model 8007 amp 8012 Hot Dog Steamer Troubleshooting Tips Condensation On The Outside Of The Hot Dog Steamer Cool air striking the warm steamer may cause moisture accumulation Protect the unit against cool drafts of air Casing Of Hot Dogs Burst Too much steam is being generated Move the thermostat control to a lower setting Buns Are Too Soggy Or Too Dry Too much or too little steam will produce these conditions Control the amount of steam by adjusting the temperature control as necessary Some buns are better adapted for steaming than others Experiment with different kinds brands of buns until you find the one best suited for your application 7 Model 8007 amp 8012 Hot Dog Steamer PARTS BREAKDOWN FRONT VIEW E 1 gt A z Hot Dog Steamer PARTS BREAKDOWN INTERIOR COMPONENTS 9 Model 8007 amp 8012 2 Dog Steamer PARTS LIST 9007 9012 6 47201 47201 SwitehOwoff S 8 87960 87960 Thermostat Heat Control 9 87204 87204 Hot Dog Label 87553 16 8700 BunBaske 00000000 17 8701 HotDogBasket 00000000 16847 87234 Bun Hot Dog Basket Model 8012 only __ __ G 11 12 O IES E S 1 Item
3. Part 87202 Revised November 2005 HOT DOG STEAMER Instruction Manual Models 8007 amp 8012 Model 8012 Shown GGOLD MEDAL FUNFOOD EQUIPMENT SUPPLIES Cincinnati OH 45241 4807 USA SAFETY PRECAUTIONS DANGER Machine must be properly grounded to prevent electrical shock to personnel Do NOT immerse the equipment in water Always unplug the equipment before cleaning or servicing ALWAYS wear safety glasses when servicing this equipment Any alterations to this equipment will void the warranty and may cause a dangerous situation NEVER make alterations to the equipment Make sure all machine switches are in the off position before plugging the equipment into the receptacle A CAUTION Do NOT allow direct contact with this equipment and the general public when used in food service locations Only personnel that are trained and familiar with the equipment should operate the equipment Carefully read all installation instructions before operation his machine is NOT to be operated by minors Minors are classified as anyone under the age of 18 NOTE The information specifications and illustrations contained in this manual represent the latest data available at time of publication Right is reserved to make changes as required at the discretion of Gold Medal Products Company without notice Hot Dog Steamer INSTALLATION INSTRUCTIONS Checking Shipment Unpack carton and check thoroughly for
4. n to assume for us any other obligation or liability in connection with the sale of said GOLD MEDAL equipment or any part thereof The term Original Purchaser as used in this warranty shall be deemed to mean that person firm association or corporation who was billed by the GOLD MEDAL PRODUCTS COMPANY or their authorized distributor for the equipment THIS WARRANTY HAS NO EFFECT AND IS VOID UNLESS THE ORIGINAL PURCHASER FIRST CALLS GOLD MEDAL PRODUCTS COMPANY AT 1 800 543 0862 TO DISCUSS WITH OUR SERVICE REPRESENTATIVE THE EQUIPMENT PROBLEM AND IF NECESSARY FOR INSTRUCTIONS CONCERNING THE REPAIR OR REPLACEMENT OF PARTS NOTE This equipment is manufactured and sold for commercial use only GOLD MEDAL PRODUCTS COMPANY 10700 Medallion Drive Ohio 45241 4807 USA www gmpopcorn com Phone 1 800 543 0862 Fax 1 800 542 1496 12 Model 8007 amp 8012
5. rn the On Off switch to the ON position and set the heat control knob to the desired temperature Keep the lids closed when not serving Add more water as necessary to maintain water level 3 Model 8007 amp 8012 Hot Dog Steamer CARE AND CLEANING DANGER Machine must be properly grounded to prevent electrical shock to personnel Do NOT immerse in water Always unplug the equipment before cleaning or servicing Although corrosion resistant stainless steel should be cleaned daily 1 Unplug the unit s power cord from the receptacle 2 Remove any remaining hot dogs and buns 3 Make sure the water in the machine has had time to cool before draining Water may be hot allow to cool to avoid burns Remove the hot dog basket bun basket partitions steam baffle and juice pan Use a mild soap and water to clean these items then set aside and allow to dry Place a container under the drain spout on the right front corner of the machine Unscrew the drain cap and allow the water to drain into the container Wipe the inside of the steamer with a damp cloth and soapy water Rinse and wipe dry For stubborn spots or stains a mild household abrasive cleaner may be used When using this type of cleaner always remember to rub in the direction of the grain to preserve the metal finish 9 When the unit has been thoroughly cleaned rinsed and dried re install the hot dog basket bun basket partitions s
6. s Not Shown 10 Model 8007 amp 8012 Hot Dog Steamer Electrical Schematic Models 8007 amp 8012 A NI 14311313 NG 2 JUHM INV I ALAM O MOV 18 ATTE 10227 N d 0 0419 09628 HILIMS 349 92022 N d 1 15004381 1 9 0309 NI 0731 NIVN 5 ON EN Model 8007 amp 8012 11 Hot Dog Steamer WARRANTY WE WARRANT to the original purchaser the Gold Medal equipment sold by us to be free from defects in material or workmanship under normal use and service Our obligation under this warranty shall be limited to the repair or replacement of any defective part for a period of six 6 months from the date of sale to the Original Purchaser with regard to labor and two 2 years with regard to parts and does not cover damage to the equipment caused by accident alteration improper use voltage abuse or failure to follow instructions THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED AND OF ALL OTHER OBLIGATIONS OR LIABILITIES ON OUR PART INCLUDING THE IMPLIED WARRANTY OF MERCHANTIBILITY THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF We neither assume nor authorize any other perso
7. team baffle and juice pan 10 Your steamer should now be ready for another day of operation 4 Model 8007 amp 8012 Hot Dog Steamer MAINTENANCE INSTRUCTIONS DANGER Machine must be properly grounded to prevent electrical shock to personnel Do NOT immerse in water Always unplug the equipment before cleaning or servicing Adequate eye protection must be used when servicing this equipment to prevent the possibility of injury THE FOLLOWING SECTIONS OF THIS MANUAL ARE IN TENDED ONLY FOR QUALIFIED SERVICE PERSONNEL WHO ARE FAMILIAR WITH ELECTRICAL EQUIPMENT THESE ARE NOT INTENDED FOR THE OPERATOR Attention Only certified service personnel should perform all service and maintenance 5 Model 8007 amp 8012 Hot Dog Steamer ORDERING SPARE PARTS Identify the needed part by checking it against the photos illustrations and or the parts list 2 When ordering please include part number part name and quantity needed 3 Please include your model name serial number and date of manufacture located on the machine nameplate with your order 4 Address all parts orders to Parts Department Gold Medal Products Co 10700 Medallion Drive Cincinnati Ohio 45241 4807 or place orders at 800 543 0862 513 769 7676 Fax 513 769 8500 E mail info gmpopcorn com Web Page www gmpopcorn com The text descriptions graphics and other material in this publication are
Download Pdf Manuals
Related Search