User Manual
Contents
1. Lens Setup Instructions Anamorphic Lens Setting up the system STEP 4 Make sure the projector is turned on Itis helpful to have a picture that fills the entire panel of 16 9 projector With a 2 40 1 source material the vertical expand is good to be performed to the picture at this step Fig 4 Now carefully adjust the focus of projector Also make sure the image is symmetrically in the center of the 2 40 1 screen STEP 5 First move the prisms to the pass mode using the control knobs until the prisms stop Carefully position the lens with a stand in front of the projector with the small opening closest to the projector lens and the large opening pointing towards the screen Now manually adjust the lens in a stand Make sure the entire beam fits centered within the two lenses Lower raise and tilt the lens until the desired height and angle is reached Fig 5 Make sure the image is now rectangular and still symmetrically in the center of the screen NOTE The optimum symmetry for the projected picture can only be found by tilting the lens to the direction of the beam front view rear view Fig 6 Fig 5 STEP 6 Turn the control knobs to the wide position until the prisms stop again The tuning of picture width can be accomplished manually by adjusting the cap screws inside the lens to match your screen perfectly on both sides NOTE Tuning is done with the cap screws to where t2. Anamorphic Lens Anamorphic Lens Setup Instructions Bringing the lens into the use STEP 1 Lift the lens up and flip it upside down in a stand By using the L wrench 3 mm carefully remove the front element by releasing the four cap screws Fig 1 a Put the front element in a safe place waiting for the further use After this remove the bottom plate of housing by releasing the four screws on the bottom plate Fig 1 b STEP 2 Fig 2 Now carefully take off the plastic cover sheets from both sides of both lenses Fig 2 INSTALLATION INSTRUCTIONS Parts list a Carefully remove and unwrap all the E Lens Unit Insert the E back to n E oad contents of box Referring to the parts E Table Stand prepare to affix the four screws Fig 3 with L list make sure you have everything wrench 3mm Tighten the screws securely E L Wrench 3 mm needed to proceed with the installation of the lens If any parts are missing m L Wrench 4mm contact Prismasonic immediately E Instruction Manual At this point do not yet insert the front element back to its place since it has to be unassembled while setting up the system Inspect the lens to make sure there are no shipping defects If you notice a problem with the lens itself or the lens mechanical system contact Prismasonic immediately Flip the lens back upright in a stand Your lens is now ready for the setting up Fig 3 T Setup Instructions Anamorphic
3. he prisms stop after turning the knobs to the wide position Fig 6 STEP 7 Take the front element remove the cover sheets and secure it to the lens body using the four screws Fig 7 You slightly have to zoom in the picture after front element installation Also now adjust the focus and picture in a wide mode to achieve the optimum settings and note these settings as for future reference Fig 7 STEP 8 In case the friction based lens height Fig 8 a or the tilt Fig 8 b adjusting mechanism become too loose it is possible to get them tightened with the set screws of stand drums on both sides of lens Use the L wrench 4 mm for tightening the Screws You re done Enjoy your new 2 40 1 picture Maintenance Your Cinomorph lens was designed to require very minimal cleaning It is best to only wipe the lens housing with a clean damp soft cloth when needed Cleaning the optics Only use optically safe lens cleaning solutions and a clean lint free cloth certified for cleaning of lens materials In order to clean the optics from both sides the bottom plate can be temporarily removed
Download Pdf Manuals
Related Search