Laser Source Control Unit
Contents
1. 8 5VDC Pin 9 3 3VDC Do not mount the laser module in a thermal insulating material such as foam plastic For best heat dissipation use a metal mounting fixture The use of a heat sink is recommended A heat sink is always recommended for operating temperatures above 25 C Users should leave a minimum of three inches of space to the rear of the LPMS LIQS to promote adequate ventilation 2 2 Operation The LPMS LIQS is equipped with a key switch located on the front panel Customers use the key to activate and deactivate the laser A 5 second delay will begin after the key switch is turned to the on position The emissions indicator on the front panel will then light up to warn of eminent laser emission The laser system will be off when the key is in the vertical position Caution The LPMS LIQS is a certified laser system only when used with an appropriate laser module that has the appropriate labels Do not operate laser without the LPMS LIQS Use of controls or adjustment or performance of procedures other than those specified herein may impair the protection provided by the equipment and result in hazardous radiation exposure Refer to the enclosed laser module operating instructions for specifics on how to operate the module 2 3 Laser Safety Class 3b and 4 lasers are not intended for use in surveying leveling alignment or medical applications Caution Use of controls or adjustment or performance of procedur2. 1 2001 2 Edition Safety requirements for electrical equipment for measurement control and laboratory use UREA Alain Danielo Dan Dunahay VP and GM of PPT Division Director of Quality Systems Zone Industrielle 1791 Deere Avenue 45340 Beaune la Rolande France Irvine Ca USA Technical Support Contacts North America amp Asia Europe Newport Corporation Service Dept Newport MICRO CONTROLE S A 1791 Deere Ave Irvine CA 92606 Zone Industrielle Telephone 949 253 1694 45340 Beaune la Rolande FRANCE Telephone 800 222 6440 x31694 Telephone 33 02 38 40 51 56 Asia Newport Opto Electronics Technologies 253 Aidu Road Bld 3 Flr 3 Sec C Shanghai 200131 China Telephone 86 21 5046 2300 Fax 86 21 5046 2323 Newport Corporation Calling Procedure Tf there are any defects in material or workmanship or a failure to meet specifications promptly notify Newport s Returns Department by calling 1 800 222 6440 or by visiting our website at www newport com returns within the warranty period to obtain a Return Material Authorization Number RMA Return the product to Newport Corporation freight prepaid clearly marked with the RMAH and we will either repair or replace it at our discretion Newport is not responsible for damage occurring in transit and is not obligated to accept products returned without an RMA E mail rma service Onewport com When calling Newport Corporation please provide the custom
3. Laser Source Control Unit LPMS LIQS Series User s Manual Experience Solutions Warranty Newport Corporation warrants that this product will be free from defects in material and workmanship and will comply with Newport s published specifications at the time of sale for a period of one year from date of shipment If found to be defective during the warranty period the product will either be repaired or replaced at Newport s option To exercise this warranty write or call your local Newport office or representative or contact Newport headquarters in Irvine California You will be given prompt assistance and return instructions Send the product freight prepaid to the indicated service facility Repairs will be made and the instrument returned freight prepaid Repaired products are warranted for the remainder of the original warranty period or 90 days whichever is longer Limitation of Warranty The above warranties do not apply to products which have been repaired or modified without Newport s written approval or products subjected to unusual physical thermal or electrical stress improper installation misuse abuse accident or negligence in use storage transportation or handling This warranty also does not apply to fuses batteries or damage from battery leakage THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTIC
4. ULAR USE NEWPORT CORPORATION SHALL NOT BE LIABLE FOR ANY INDIRECT SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE PURCHASE OR USE OF ITS PRODUCTS First printing 2004 2004 by Newport Corporation Irvine CA All rights reserved No part of this manual may be reproduced or copied without the prior written approval of Newport Corporation This manual has been provided for information only and product specifications are subject to change without notice Any change will be reflected in future printings Newport Corporation 1791 Deere Avenue Irvine CA 92606 USA P N 41759 01 Rev A Declaration of Conformity EU Declaration of Conformity We declare that the accompanying product identified with the ce mark complies with requirements of the Electromagnetic Compatibility Directive 89 336 EEC and the Low Voltage Directive 73 23 EEC Model Number LPMS Laser Power Supply Year C mark affixed 2005 Type of Equipment Electrical equipment for measurement control and laboratory use Standards Applied Compliance was demonstrated to the following standards to the extent applicable BS EN61326 1 1997 A1 A2 A3 Electrical equipment for measurement control and laboratory use EMC requirements This equipment meets the CISPR 11 Class A Group 1 radiated and conducted emission limits BS EN 61000 3 2 2001 Harmonic current emissions Class A BS EN 61000 3 3 2002 Voltage fluctuations and flicker BS EN 61010
5. ding five seconds 6 Beam blocker Located on the laser module this cap prevents unwanted radiation emissions REMOTE INTERLOCK CONNECTOR INTERLOCK KEY L SWITCH Laser Diode Control Unit o Jo NY m I Y Newport MANUAL RESET PO BUTTON CONNECTOR 2 System Operation 2 1 Installation Plug the LPMS LIQS into a grounded outlet Ensure that the interlock on the back panel is intact and installed The unit will not operate without the interlock installed Before users can operate the unit they must connect the laser module to the LPMS LIQS power supply Any extension to the laser module cable must be less than two meters in overall length to maintain CDRH IEC laser certification A DB 9 9 pin connector is located on the rear panel of the LPMS LIQS A bare wire adapter is included with the LPMS LIQS should the laser module not have a DB 9 connector installed In this case attach the module s black wire to the properly marked location ground on the bare wire adapter Then attach the red wire to the proper location on the bare wire adapter All LQ series lasers attach to the 12V position on the bare wire adapter All LPM modules attach to the 5V position Users should position the equipment so that it is not difficult to disconnect the interlock Pin 1 ground Pin 2 ground 6 7 8 9 Pin 3 12VDC Pin 4 5VDC Ss ae we a Pin 5 3 3VDC Pin 6 ground 2 4 bs s Pin 7 12VDC Pin
6. er care representative with the following information e Your Contact Information e Serial number or original order number e Description of problem i e hardware or software To help our Technical Support Representatives diagnose your problem please note the following conditions Is the system used for manufacturing or research and development What was the state of the system right before the problem Have you seen this problem before If so how often Can the system continue to operate with this problem Or is the system non operational e Can you identify anything that was different before this problem occurred Table of Contents Warranty i Technical Support Contacts iii 1 General Information 1 1 1 A A A 1 TZ A EE 1 1 3 Safety Features said 2 2 System Operation 3 2 1 st 222 rar A ee 3 2 2 YOperallon an reellen tb A E a antes 3 2 3 Hasen Salety os rss Binnen 4 24s Specitications ed 4 3 Free Service Information 5 3 1 Service PO ansehen 6 1 General Information 1 1 Introduction The LPMS LIQS is a turnkey power supply for lasers The LPMS LIQS incorporates all safety features required by U S federal regulations End users those not directly integrating a laser into another product must purchase an LPMS LIQS to meet U S government requirements for laser systems Original equipment manufacturers are not required to purchase an LPMS LIQS and are therefore responsible for integrating the
7. es other than those specified herein may result in hazardous radiation exposure Caution The use of optical instruments with this product will increase eye hazard Modifications that affect any aspect of the product s performance or intended functions will require re certification and re identification of the product in accordance with the provisions of 21 CFR 1010 2 and 1010 3 2 4 Specifications Specification LPMS 5 110 LPMS 5 220 LIQS 12 110 LIQS 12 220 Input Voltage 110 VAC 100 240 VAC 110 VAC 100 240 VAC Input Frequency 60 Hz 47 63 Hz 60 Hz 47 63 Hz Output Voltage 5 VDC 5 VDC 12 VDC 12 VDC Operating Temperature 5 40C 5 40C 5 40C 5 40C Compatible Laser Series LPM LPM LQA LQC LQD LQA LQC LQD 3 Free Service Information The Model LPMS LIQS contains no user serviceable parts To obtain information regarding factory service contact Newport Corporation or your Newport representative Please have the following information available 1 Instrument model number 2 Description of the problem If the instrument is to be returned to Newport Corporation you will be given a Return Number which you should reference in your shipping documents Please fill out a copy of the service form located on the following page and have the information ready when contacting Newport Corporation Return the completed service form with the instrument To obtain warranty service contact your neare
8. ir own safety features to meet government standards 1 2 Unpacking Each Newport LPMS LIQS is thoroughly tested prior to shipment Visually inspect your unit after removing it from the shipping container If you see any damage retain all packaging materials and shipping receipts Any damage claim should be made promptly to the transportation company Notify the nearest Newport representative concerning the claim so that any repair or replacement can be arranged as soon as possible 1 3 Safety Features The LPMS LIQS incorporates the following safety features to comply with government regulations 1 Power on off key switch Located on the front panel of the LPMS LIQS this switch enables users to power the unit on with the turn of a key The LPMS LIQS 1s inoperable when key is removed 2 Emission indicator This green LED located to the upper right on the LPMS LIQS front panel lights up when the unit is on to warn of eminent laser emission 3 5 second activation delay The LPMS LIQS does not power on until five seconds after a user has turned the key switch to the on position 4 Remote interlock amp connector This feature is located on the rear panel of the LPMS LIQS The unit will not operate without the interlock intact 5 Manual reset button Located on the front panel this button requires that the user push it to begin lasing any time a remote interlock is used or there has been an interruption in power excee
9. st Newport agent or send the product with a description of the problem transportation and insurance prepaid to the nearest Newport agent Newport Corporation assumes no risk for the damage in transit Newport Corporation will at its option repair or replace the defective product free of charge However if Newport Corporation determines that the failure is caused by misuse alterations accident or abnormal condition of operation or handling you will be billed for the repair and the repaired product will be returned to you transportation prepaid Formatted Bullets and Numbering 6 3 1 Service Form GLO Newport Corporation U S A Office 800 222 6440 FAX 949 253 1479 Newport Name Return Authorization Please obtain RA prior to return of item Company Address Date Country Phone Number P O Number FAX Number Item s Being Returned Model Serial Description Reason for return of goods please list any specific problems Notes Newport Corporation Worldwide Headquarters 1791 Deere Avenue Irvine CA 92606 In U S 800 222 6440 Tel 949 863 3144 Fax 949 253 1680 Internet sales newport com Visit Newport Online at www newport com
Download Pdf Manuals
Related Search